Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Improved selectivity and detection limit of the carbonate-selective electrode

The properties of the carbonate neutral carrier 4-( n-hexadecyl)-3-nitro-1-trifluoroacetylbenzene were compared with those of a similar carrier, without a nitro group, studied previously. In spite of differences in the Hammett constant of the carbonyl group responsible for interaction with the analyte, the analytical characteristics of both carriers, measured under the same conditions, were comparable. Special care was taken to avoid the presence of an excessive carbon dioxide level in the diffusion layer at the membrane-solution interface. The internal reference solution was prepared without carbonate components; the external solution was protected from contact with atmospheric carbon dioxide. Under such conditions the detection limit of both electrodes was extended to 10(-11 )mol L(-1), and the selectivity towards salicylate, chloride, and acetate was significantly improved.     

Use of carbon suboxide to obtain block and graft copolymers. I. Grafting of carbon suboxide on polyamide 6

Polyamide 6 in the form of film was grafted by gaseous carbon suboxide in the form of toluene solutions. The influence of temperature on the extent of grafting was studied. It was concluded that in a sufficiently high temperature a copolymer of high structure appears. The influence of substances that initiate homopolymerization of suboxide upon the course of grafting reaction was studied. It was found that the substances do not increase the effectiveness of grafting. However a significant increase of effectiveness of grafting is produced by introducing into the reaction environment some small quantities of methanol. By the addition of methanol a graft copolymer of a maximum effectiveness of 43.1% was obtained. The copolymer was subjected to further tests and appeared to be c.l. poly(amide-6–g-carbon suboxide). Additional tests indicated that the polyamide film graft with carbon suboxide shows some interesting properties.     

Potentiometrische Bestimmung von Seltenen Erden (z. B. Erbium)

Zusammenfassung Eine schnelle und zuverlässige, potentiometrische Titrationsmethode zur Bestimmung von Erbium mit Ammoniumoxalatlösung in wäßrig-acetonischem Medium im Verhältnis 11 wurde ausgearbeitet. Man titriert in dem System Pt | ErCl₃ | Hg₂Cl₂ + KCl | Hg. Der Potentialsprung im Äquivalenzsättigungspunkt ist bereits auf Zugabe eines Tropfens Reagenslösung sehr deutlich. Der Meßfehler überschreitet nicht die Grenzen ±0,5%.Die Methode ist bei Metallionen, die mit Ammoniumoxalat schwerlösliche Niederschläge bilden, nicht anwendbar.

---

Summary A rapid and accurate method for the potentiometric titration of erbium by means of ammonium oxalate solution in a water-acetone medium (11) has been worked out. The system Pt | ErCl₃ | Hg₂Cl₂ + KCl | Hg was used. The potential jump at the neutral point is distinct, even if only one drop of the reagent is added. The error of the measurement is not greater than ±0,5%- Metal ions forming insoluble precipitates with ammonium oxalate interfere with this method.

     

An efficient reagent for the phosphorylation of deoxyribonucleosides, DNA oligonucleotides, and their thermolytic analogues

[reaction: see text] The phosphoramidite 11 was prepared in three steps from methyl 2-mercaptoacetate and demonstrated efficiency in the synthesis of conventional 5'-/3'-phosphate/thiophosphate monoester derivatives of 2'-deoxyribonucleosides and DNA oligonucleotides. Moreover, the use of 11 has enabled the preparation of the dinucleoside phosphorothioate analogue 26 in high yields (>95%) with minimal cleavage (<2%) of the thermolytic thiophosphate protecting group.     

An investigation of the reliability of the Galerkin-Petrov method

It is shown that the Galerkin-Petrov method if applied in a controlled way yields reliable results for excited states of the same symmetry classifications as the ground state. Computations are performed for the 2¹ S and 3¹ S states of He. The problem of optimizing nonlinear parameters of the basis functions by means of the GP method is discussed. A special optimization scheme is suggested and numerically illustrated for someS states of He.     

High-pressure structure of Li2CO3

The high-pressure behavior of Li₂CO₃ is studied up to 25 GPa with synchrotron angle-dispersive powder X-ray diffraction in diamond anvil cells and synthesis using a multi-anvil apparatus. A new non-quenchable hexagonal polymorph (P6₃/mcm, Z=2) occurs above 10 GPa with carbonate groups in a staggered configuration along the c-axis—a=4.4568(2) Å and c=5.1254(6) Å at 10 GPa. Two columns of face-shared distorted octahedra around the Li atoms are linked through octahedral edges. The oxygen atoms are coordinated to one carbon atom and four lithium atoms to form a distorted square pyramid. Splittings of X-ray reflections for the new polymorph observed above about 22 GPa under non-hydrostatic conditions arise from orthorhombic or monoclinic distortions of the hexagonal lattice. The results of this study are discussed in relation to the structural features found in other Me₂CO₃ carbonates (Me: Na, K, Rb, Cs) at atmospheric conditions.     

Side effects in measurements of selectivity coefficients of solid state ion selective electrodes

The influence of various factors such as solubility, the oxidation of the membrane, and the contamination of the solution, on the experimental values of the selectivity coefficients of solid state sulphide ion selective electrodes is discussed. A new method for the evaluation of very small selectivity coefficients, based on the addition of reagents forming complexes or insoluble salts with the main ion, is proposed. By means of this method, selectivity coefficients for silver, copper, cadmium and lead ion selective electrodes have been determined, which are in far better agreement with thermodynamic values than those described in the literature.     

Studies of organotin(IV)-orthoquinone systems

The primary process in the reaction of hexaphenylditin with various substituted orthoquinones (Q) is shown to involve attack by the quinone at a phenyl ligand. The intermediate thus formed decomposes to yield Ph₃Sn(SQ^·), where S(Q^·−) is the corresponding semiquinonate. Rearrangement of these species in solution gives rise to biradicals, while intramolecular electron transfer may lead to the formation and precipitation of Ph₂Sn(CAT), where CAT²⁻ is the corresponding substituted catecholate. The identification of these processes depends in part on electron paramagnetic resonance spectroscopy. The reaction of Ph₃SnCl or Ph₂SnCl₂ with Na(TBSQ^·) (TBSQ^·−=3,5-di-tert-butyl-orthobenzosemiquinonate) results in the formation of Ph₂Sn(TBSQ^·), which can undergo redistribution and intramolecular electron transfer, so that the solution chemistry of these latter systems is similar to that of the products of the Sn₂Ph₆+Q reaction.     

Changes in surface composition of Fe-Si-Cr-K oxide alkylation catalyst: the marked role of potassium ferrites

The influence of gas-phase methylation of phenol on the state of the Fe-Si-Cr-K oxide catalyst surface was investigated by thermodesorption of K atoms and ions. Changes in potassium desorption energies, as determined from Arrhenius-like plots, varied from 3.07 eV to 1.21 eV for the atoms and from 2.59 eV to 2.89 eV for ion desorption from the active and deactivated samples, respectively. The results were discussed in terms of transformation of the catalyst surface and formation of β-ferrite.