Separation of screw-sensed particles in a homogeneous shear field

The Stokes motions of three-dimensional screw-sensed slender particles in a homogeneous shear field are investigated, including the effects of buoyancy. Conclusions are drawn about the possibility of achieving a separation of mixtures of right- and left-handed particles. The linearity of the Stokes equations allows complex flows to be solved by adding the effects of the several terms which describe the flow in which the particle is immersed. The homogeneous shear flow considered here consists of three such terms; solutions for a series of 12 unit motions are sufficient to determine the hydrodynamic resistance tensors. The forces and torques experienced by screw-sensed particles are calculated from these 51 resistance tensors, using slender-filament theory. The results allow an estimate of the range of buoyancy parameters for which gravitational sedimentation can be neglected. The fundamental component of the particle motion is a rotation, at approximately the same angular velocity as that of the fluid. Superimposed on this are variations, of large period, in the particle orientation. A phase plane analysis is used to find the terminal orientations. Very long calculation times are required for the phase portrait. An approximate method based on azimuthally-averaged equations is developed to avoid the requirements for long time integration.     

The inclusion of electrostatic and dispersion interactions into potentials of mean torque for solutes dissolved in uniaxial liquid crystal solvents

A potential of mean torque is derived for a solute at infinite dilution in a uniaxial liquid crystal solvent, which contains terms originating from the dispersion interaction, and the electrostatic interaction between quadrupole moments on both molecules. It is shown that the electrostatic term is non-zero only if the solute-solvent vectors are distributed with lower than spherical symmetry. If this distribution has cylindrical symmetry then both the electrostatic and dispersion terms in the potential of mean torque are shown to depend on order parameters for the orientational distribution of the solute-solvent vectors, as well as on the order parameters of the solvent molecules.     

Mössbauer gamma echo

By applying stepwise phase modulation of recoilless gamma radiation in a coincidence experiment, constructive interference is produced in transmission geometry between the source and the absorber fields. The resulting regenerated decay signal is called a gamma echo. Here it is demonstrated that during the decay of the 14.4 keV state of⁵⁷Fe multiple echo signals can be generated.     

Single-molecule single crystals

Various approaches to the preparation and verification of single-molecule single crystals are discussed for polyethylene and poly (oxyethylene). Analytic tools are electron microscopy, electron diffraction, and differential scanning calorimetry. The main difficulty in producing a single-molecule single crystal is to keep crystals from joining during growth.     

Spontaneous photorefractive effect in Sr1−x CaxTiO3 (x=0.014)

The temperature dependence of the principal values of the refractive index in Sr_1−x Ca_xTiO₃ (x=0.014) has been measured in the 17–275 K range under various conditions of sample illumination with 1.96 eV photons. The spontaneous photorefractive contribution δn ^ph to the temperature-induced variation of the refractive index of Sr_1−x Ca_xTiO₃, which appears after illumination of the sample in the ferrophase (transition temperature T _c=32 K) and persists in the paraphase under heating up to 150 K, has been separated. The photoinduced polarization has been estimated. Fiz. Tverd. Tela (St. Petersburg) 39, 711–713 (April 1997)     

Interface analysis of the system Si/YBa2Cu3O7?x

Summary The influence of different preparation conditions and substrate surface orientations on the superconducting properties of thin YBa₂Cu₃O_7–x (YBCO) films on silicon was studied. Comparative electrical and surface spectroscopic measurements were performed. SAM and SIMS depth profile analysis show an enrichment of barium at the interface between the superconductor and silicon for samples with T_c<76 K. Comparison with XPS data obtained for thin silicon films on YBCO indicates the formation of barium and yttrium silicates at the interface under these conditions.     

III-V compound semiconductor (001) surfaces

There has been renewed interest in the structure of III-V compound semiconductor (001) surfaces caused by recent experimental and theoretical findings, which indicate that geometries different from the seemingly well-established dimer models describe the surface ground state for specific preparation conditions. I review briefly the structure information available on the (001) surfaces of GaP, InP, GaAs and InAs. These data are complemented with first-principles total-energy calculations. The calculated surface phase diagrams are used to explain the experimental data and reveal that the stability of specific surface structures depends largely on the relative size of the surface constituents. Several structural models for the Ga-rich GaAs (001)(4×6) surface are discussed, but dismissed on energetic grounds. I discuss in some detail the electronic properties of the recently proposed cation-rich GaAs (001)ζ(4×2) geometry. Received: 18 May 2001 / Revised version: 23 July 2001 / Published online: 3 April 2002     

Differentiation of species of the Baccharis genus by HPLC and chemometric methods.

Phytochemical investigation of the aerial parts of three Baccharis species (Asteraceae family) was performed using HPLC and chemometric methods, with the objective of distinguishing between three morphologically very similar species: Baccharis genistelloides Persoon var. trimera (Less.) DC, B. milleflora (Less.) DC and B. articulata (Lam.) Persoon. With the help of Principal Component Analysis (PCA) and variance weights, it was possible to characterize the chromatographic profiles of the alcoholic extracts of the three species. Application of Soft Independent Modeling of Class Analogy (SIMCA) and K-Nearest Neighbor (KNN) methods on a training set of 74 extracts resulted in models that correctly classified all eight samples in an independent test set.     

Diffuse x-ray scattering study of the formation of microdefects in heat-treated dislocation-free large-diameter silicon wafers

Diffuse x-ray scattering (DXS) is used to study the formation of microdefects (MDs) in heat-treated dislocation-free large-diameter silicon wafers with vacancies. The DXS method is shown to be efficient for investigating MDs in silicon single crystals. Specific defects, such as impurity clouds, are found to form in the silicon wafers during low-temperature annealing at 450°C. These defects are oxygen-rich regions in the solid solution with diffuse coherent interfaces. In the following stages of decomposition of the supersaturated solid solution, oxide precipitates form inside these regions and the impurity clouds disappear. As a result of the decomposition of the supersaturated solid solution of oxygen, interstitial MDs form in the silicon wafers during multistep heat treatment. These MDs lie in the {110} planes and have nonspherical displacement fields. The volume density and size of MDs forming in the silicon wafers at various stages of the decomposition are determined.