Developing an on-line derivatization of FAs by microwave irradiation coupled to HPLC separation with UV detection

The development of analytical methods for routine simultaneous identification and quantification of carboxylic fatty acids (CFAs) are required in different fields, such as, pharmaceutical cosmetics, food products and formulations of water–microemulsion–oil systems. Determination of CFAs has been developed mainly by gas chromatography (GC). As an alternative to GC, liquid chromatography (LC) has better sensitivity and selectivity. However, most CFAs show no useful absorption in ultraviolet–violet (UV–Vis) region, one of the more used detection technique in high-performance liquid chromatography (HPLC). In order to allow the use of UV–Vis detection, the use of pre-column derivatization has been reported to increase sensitivity and selectivity. Therefore, establishment of a simpler and faster on-line method with complete separation is needed for the screening of large numbers of samples. 2,4-Dinitrophenylhydrazine (2,4-DNPH.), benzoil chloride (BC), and phenylhydrazine (PH) were used for derivatization of different FAs by microwaves radiation (MW). After the on-line derivatization, products were separated and quantified by HPLC. Reactor coil was placed inside of microwaves oven at 450 W. Parameters as flow, amount of reagents, irradiation time, and chromatographic conditions were optimized. The continuous analysis using the MW–HPLC–UV system provided high sensitivity and reduced both the amount of reagent used and the analysis times. This proposed method can be used for the routine analysis of FAs contained in water–microemulsion–oil systems, to quantify the total acid fraction in each phase.     

Complex emulsion inversion pattern associated with the partitioning of nonionic surfactant mixtures in the presence of alcohol cosurfactant

Commercial ethoxylated nonionic surfactant mixtures containing alcohol cosurfactant exhibit a three-phase behavior whose formulation strongly varies with the water/oil ratio. As a consequence, a change in water/oil ratio can result in a sequence of up to three different emulsion inversion processes, through a combination of formulation and composition effects.     

Reactions of pyrrolidine enamines of cyclic and acyclic 3,4-dioxobutanoic acid Derivatives with dimethyl acetylenedicarboxylate. A new case of atropoisomerism.

Reaction conditions and structure of the starting enamines (cyclic or open-chain) determine greatly the final products of the title reactions. Whereas in benzene and acetonitrile, DMAD and 1 give a mixture of the diastereoisomeric dienamines 5, in methanol they afford pirrolizine 3. Enaminofuranones 2 and 10 furnish the corresponding “Michael adducts” 7a,b,c and 11a,b,c but fail to yield pirrolizines. It has been demonstrated that above b and c adducts differ exclusively on the arrangement of groups around a chiral axis.     

Synthesis of new 3-(phenoxyphenyl)sydnones marija Šindler-kulyk

The title compounds were prepared by dehydrocyclization of corresponding substituted N-nitrosoglycines obtained from isomeric o-, m- and p-aminodiphenyl ether with ethyl bromoacetate and subsequent nitrosation of the intermediate N-arylsubstituted glycines.     

DABCO-directed self-assembly of bisporphyrins (DABCO=1,4-diazabicyclo[2.2.2]octane)

Three isomeric zinc bisporphyrins have been prepared by covalently linking together two aminoporphyrins with an isophthalic acid derivative. The porphyrins differ in the substitution pattern on the meso phenyl groups, that is, ortho, meta, or para. Titrations carried out by UV-visible and 1H NMR spectroscopy have been used to map out the stabilities and the stoichiometries of the complexes formed with 1,4-diazabicyclo[2.2.2]octane (DABCO) in chloroform. The ortho- and meta-substituted bisporphyrins form 1:1 intramolecular sandwich complexes. The para-substituted bisporphyrin cannot adopt the cofacial conformation required for this type of complex and forms a higher order 2:2 intermolecular assembly, which is stable over a wide range of DABCO concentrations.     

Theoretical study of p‐methacryloyl‐aminophenylarsonic acid

Conformations of p‐methacryloylaminophenylarsonic acid (p‐MAPHA) are determined through molecular mechanics and DFT/B3LYP calculations. Solvation effects are studied within the self‐consistent isodensity continuum model (SCI‐PCM). The stationary points were found to correspond to minima as verified by the analysis of vibrational frequencies in the molecule. The molecular optical absorption was obtained by using different solvent environments. The present results are in good agreement with the available experimental data. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem, 2002     

Conformational dynamics of a bispyridinium cyclophane

A complete study of the conformational behavior of 4,8-diaza-3(1,4),9(4,1)-dipyridina-1,6(1,4)-dibenzenacyclodecaphan-3(1),9(1)-bis(ilium) bishexafluorophosphate is described. This study allows us to conclude that the process observed by which the different chemical shifts of the pyridinium protons show coalescence at a high-temperature 1H NMR is the rotation around the C-N bond, whereas the conformational equilibrium between the four conformers is produced at low temperature.     

Evaluating the significance threshold in robustness testing. A critical discussion on the influence of time in molecular fluorescence spectrometry

Robustness experiments are performed in analytical chemistry to assess the behaviour of an analytical procedure under conditions slightly different from those of the experimental optimum. This work presents a study of robustness applied to a previously proposed fluorescent methodology using two replicated 2(7-4) saturated fractional factorial designs. A comparison is established between three different ways to test the significance of the effects of the variables involved on the response signal. Critical discussions about the most appropriate threshold to be introduced when testing for significance of the factors and the influence of the time necessary to carry out the experiments are included.     

On the computation of molecular electronic affinities

Using a multireferent MBPT method (CIPSI) the electronic affinity (EA) of F, CN and HCC is computed. Results show how UMP2 gives unbalanced truncation of the MP series, while ROMP2 has the correct (balanced) behaviour. The good agreement with the experimental EA found for some compounds is accidental and associated to an error compensation. The good agreement with the experimental data found for the ROMP2 and CIPSI EAs is analysed.This paper was presented at the International Conference on The Impact of Supercomputers on Chemistry, held at the University of London, London, UK, 13–16 April 1987     

Determination of copper in medicinal plants used as dietary supplements by atomic absorption spectrometry with direct flame solid analysis

An alternative device for the direct solid analysis (DSA) for copper determination by flame atomic absorption spectrometry (FAAS) is proposed. Copper was directly determined in commercial medicinal plants used as dietary supplements. The determination of copper in solid samples by DSA–FAAS was made by using a conventional air–acetylene flame. Between 0.05 and 1.5 mg of each test, sample was weighed directly into a small polyethylene vial connected to the device used for solid introduction into the flame. Test samples were introduced into the flame as a dry aerosol using a T-quartz cell set between the burner and the optical path. The T-quartz cell has a slit in the superior part by which the solid aerosol passes to the flame. A transient signal, evaluated as integrated absorbance, is produced and it is totally integrated in 2 s. Background signals always presented absorbance values less than 0.1. It was found a characteristic mass of 0.8 ng Cu and absolute limit of detection of 1.2 ng (3 s), or 1.2 μg g⁻¹ if a sample mass of 1 mg was used. Optimized conditions for air flow rate, flame stoichiometry, and so on were established as well. No excessive grinding of the samples was needed and samples with particle of size less than 80 μm were used throughout. No statistical difference between the results from the proposed system and those obtained by sample digestion and determination by conventional FAAS was observed. With the proposed procedure, more than 50 test samples can be analyzed in 1 h and it can be easily adapted to conventional spectrometers for FAAS.