New ceramic microfiltration membranes from mineral coal fly ash

This work aims to develop a new mineral porous tubular membrane based on mineral coal fly ash. Finely ground mineral coal powder was calcinated at 700 °C for about 3 h. The elaboration of the mesoporous layer was performed by the slip casting method using a suspension made of the mixture of fly ash powder, water and PVA. The obtained membrane was submitted to a thermal treatment which consists in drying at room temperature for 24 h then a sintering at 800 °C. SEM photographs indicated that the membrane surface was homogeneous and did not present any macro defects (cracks, etc.). The average pore diameter of the active layer was 0.25 μm and the thickness was around 20 μm. The membrane permeability was 475 l/h m² bar.This membrane was applied to the treatment of the dying effluents generated by the washing baths in the textile industry. The performances in term of permeate flux and efficiency were determined and compared to those obtained using a commercial alumina microfiltration membrane. Almost the same stabilised permeate flux was obtained (about 100 l/h m²). The quality of permeate was almost the same with the two membranes: the COD and color removal was 75% and 90%, respectively.     

Deterministic solution of the kinetic theory model of colloidal suspensions of structureless particles

A direct modeling of colloidal suspensions consists of calculating trajectories of all suspended objects. Due to the large time computing and the large cost involved in such calculations, we consider in this paper another route. Colloidal suspensions are described on a mesoscopic level by a distribution function whose time evolution is governed by a Fokker–Planck-like equation. The difficulty encountered on this route is the high dimensionality of the space in which the distribution function is defined. A novel strategy is used to solve numerically the Fokker–Planck equation circumventing the curse of dimensionality issue. Rheological and morphological predictions of the model that includes both direct and hydrodynamic interactions are presented in different flows.     

Theoretical diagnostic and prediction of physical properties of quaternary InGaAsP compound using artificial neural networks optimized by the Levenberg Maquardt algorithm

The quaternaries \(In_{1 - x} Ga_{x} As_{y} P_{1 - y}\) are the main promising elements for the fabrication of optoelectronic devices. The adjustment of their physical parameters is assumed by the change of the molar fraction \(x\) and \(y\). These parameters can be affected by the variation of temperature and pressure. To make the theoretical diagnosis of these materials, it is fundamental to know the energy gap ‘\(\varvec{E}_{\varvec{g}}\)’ and the lattice parameter ‘\(a\)’, over a wide range of chemical compositions \(0 \le x \le 0.47\) and \(0 \le y \le 1\), at different temperatures and pressures. We show that by using the Artificial Neural Network method optimized by the Levenberg Maquardt algorithm ANN-LM, it is possible to obtain results very close to the experiment. The scatter plot and error calculation show that the ANN-LM model provides more accurate values of the lattice parameter than those calculated by Vegard’s law. On the other hand, the energy gap values \(Eg (x, y, T)\) estimated, using the ANN-LM model, proved to be close to the experimental values that those calculated by the empirical equations. In addition, the ANN-LM method allowed us to estimate with great accuracy the values of the energy gap at different temperatures and pressures \(Eg (P, T)\). Our work provides crucial information on the physical properties of the quaternary without the use of approximations, and without taking into account the hypothesis of a perfect agreement between \(InGaAsP\) and \(InP\) substrate.     

Strong perturbation effects in heavy ion induced electronic sputtering of lithium fluoride

Electronic sputtering of lithium fluoride by swift heavy ions was studied as a function of electronic energy loss (dE/dx) _e . The single crystal targets were irradiated with swift heavy ion beams (166Z _P 692; 46E _P /M _P (MeV/u) 611). This allowed varying the deposited energy by a factor of 20 (1.86dE/dx (keV/nm) 632). The sputtered secondary ions were measured from well controlled LiF targets without surface contaminations, by means of the time-of-flight technique (TOF-SIMS). The mass spectrum reveals an important contribution of clusters (over single ions), which increases with (dE/dx) _e . Another observation for the strongest perturbation at high dE/dx (>8 keV/nm) is that the secondary ion yields saturate: Y(dE/dx) = constant. In contrast, at lower dE/dx (<8 keV/nm) for weaker perturbation, the yield Y scales with (dE/dx)². This quadratic increase would rather point towards a thermal evaporation-like mechanism leading to electronic sputtering, however, the origin of the yield saturation remains an open finding.     

Voltammetric Sensing of Amino Acids in the Presence of Cu(II) in Acidic and Alkaline Solutions

A number of amino acids have been determined at carbon film electrodes in the presence of copper. Strongly acidic, 0.1 M HCl, in the presence of 0.1 mM Cu(II), as well as alkaline, 0.1 M NaOH, solution permit successful measurement of individual amino acids, clearer separation between oxidation of Cu and Cu‐complexes occurring in alkaline solution. Electrochemical impedance showed that Cu(II) facilitates charge transfer, particularly in alkaline medium. Square wave voltammetry with preconcentration increased the response compared to linear sweep voltammetry. Protein hydrolysis rates were monitored through determination of amino acids produced by decomposition, injecting samples into alkaline electrolyte solution.     

Synergistic Effect of Bioactive Monoterpenes against the Mosquito,Culex pipiens (Diptera: Culicidae)

Mosquitoes represent one of the most important vectors and are responsible for the transmission of many arboviruses that affect human and animal health. The chemical method using synthetic insecticides disturbs the environmental system and promotes the appearance of resistant insect species. Therefore, this study investigated the insecticidal effect of some binary monoterpene combinations (1,8 cineole + α-pinene and carvone + R (+)-pulegone) using a mixture design approach. The fumigant toxicity was evaluated against Culex pipiens female adults using glass jars. The results show that the toxicity varies according to the proportions of each compound. Indeed, Mixture 1 (1,8-cineole + α-pinene) displayed a strong toxic effect (51.00 ± 0.86% after 24 h and 100.00 ± 0.70% after 48 h) when the pure compounds were tested at 0.25/0.75 proportions of 1,8-cineole and α-pinene, respectively. Nevertheless, the equal proportion (0.5/0.5) of carvone and R (+)-pulegone in Mixture 2 exhibited a toxic effect of 54.35 ± 0.75% after 24 h and 89.96 ± 0.14% after 48 h, respectively. For Mixture 1, the maximum area of mortality that the proposed model indicated was obtained between 0/1 and 0.25/0.75, while the maximum area of mortality in the case of Mixture 2 was obtained between 0.25/0.75 and 0.75/0.25. Moreover, the maximum possible values of mortality that could be achieved by the validated model were found to be 51.44% (after 24 h) and 100.24% (after 48 h) for Mixture 1 and 54.67% (after 24 h) and 89.99% (after 48 h) for Mixture 2. It can be said that all purev molecules tested through the binary mixtures acted together, which enhanced the insecticide’s effectiveness. These findings are very promising, as the chemical insecticide (deltamethrin) killed only 19.29 ± 0.01% and 34.05 ± 1.01% of the female adults after 24 h and 48 h, respectively. Thus, the findings of our research could help with the development of botanical insecticides that might contribute to management programs for controlling vectors of important diseases.     

Impedimetric genosensor for miRNA-34a detection in cell lysates using polypyrrole

Journal of Solid State Electrochemistry - This work reports the development of simple, practical, cost effective and label free genosensor prepared by electropolymerization of polypyrrole on pencil...