Chemical modification of silica gel with synthesized Schiff base hydrazone derivative and application for preconcentration and separation of U(VI) ions from aqueous solutions

Schiff base hydrazone derivative (HL) sorbent was synthesized according to the literature to be used in the adsorption and preconcentration of U(VI) ions from aqueous solution and it was exposed to immobilization, and new solid support material was obtained. For this purpose, Schiff base hydrazone derivative (HL) was chemically bonded to silica gel surface immobilized 3-aminopropyl trimethoxysilane, then analyzed by Fourier transform infrared, Brunauer–Emmett–Teller, scanning electron microscopy and elemental analysis. The influence of the solution pH, amount of sorbent, contact time, temperature, foreign ion effect and initial U(VI) concentration was investigated. The maximum U(VI) uptake capacity was found to be 8.46 mg/g.     

Simultaneous determination of seven phthalic acid esters in beverages using ultrasound and vortex‐assisted dispersive liquid–liquid microextraction followed by high‐performance liquid chromatography

A sensitive, rapid, and simple high‐performance liquid chromatography with UV detection method was developed for the simultaneous determination of seven phthalic acid esters (dimethyl phthalate, dipropyl phthalate, di‐n‐butyl phthalate, benzyl butyl phthalate, dicyclohexyl phthalate, di‐(2‐ethylhexyl) phthalate, and di‐n‐octyl phthalate) in several kinds of beverage samples. Ultrasound and vortex‐assisted dispersive liquid–liquid microextraction method was used. The separation was performed using an Intersil ODS‐3 column (C₁₈, 250 × 4.6 mm, 5.0 μm) and a gradient elution with a mobile phase consisting of MeOH/ACN (50:50) and 0.2 M KH₂PO₄ buffer. Analytes were detected by a UV detector at 230 nm. The developed method was validated in terms of linearity, limit of detection, limit of quantification, repeatability, accuracy, and recovery. Calibration equations and correlation coefficients (> 0.99) were calculated by least squares method with weighting factor. The limit of detection and quantification were in the range of 0.019–0.208 and 0.072–0.483 μg/L. The repeatability and intermediate precision were determined in terms of relative standard deviation to be within 0.03–3.93 and 0.02–4.74%, respectively. The accuracy was found to be in the range of –14.55 to 15.57% in terms of relative error. Seventeen different beverage samples in plastic bottles were successfully analyzed, and ten of them were found to be contaminated by different phthalic acid esters.     

Finite element method for the vibration of cracked beams with varying cross section

Vibration analysis of cracked beams having linearly varying cross-sections both in thickness and width was investigated. A computer program using the finite element method has been written to find the dynamical characteristics (natural frequencies and mode shapes) of the cracked beam. The cracked section in the beam has been modeled by a massless spring whose flexibility depens on the local flexibility induced by the crack. The stiffness of spring has been derived from the linear elastic fracture mechanics theory as the inverse of the compliance matrix calculated using stress intensity factors and strain energy release rate expression. Some examples have been given to explain the proposed method and investigate the effects of the depth and location of cracks on the natural frequencies and mode shapes. The results of current study and those in the literature are compared and good agreements have been found. Consequently it is showed that proposed method is reliable and simple. (© 2015 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim)     

Synthesis,spectroscopic (FT-IR and NMR), DFT and molecular docking studies of ethyl 1-(3-nitrophenyl)-5-phenyl-3-((4-(trifluoromethyl)phenyl)carbamoyl)-1H-pyrazole-4-carboxylate

Research on Chemical Intermediates - Trifluoromethyl group containing pyrazole-3-carboxamide derivative is synthesized and the structure of the molecule (E3N5PC) has been verified by using FT-IR,...     

A Comparison of Four Different Electrode Matrices on the Performance of Amperometric Hydrogen Peroxide (Bio)Sensors

A comparison of the analytical performances of four different (bio)sensor designs in H₂O₂ determination is discussed. The (bio)sensor designs developed were based on the use of (i) multiwalled carbon nanotubes (MWCNT), zinc oxide nanoparticles (ZnONP), prussian blue (PB); (ii) MWCNT, ZnONP, PB and ionic liquid (IL); (iii) MWCNT, ZnONP and horseradish peroxidase (HRP) and (iv) MWCNT, ZnONP, HRP and IL modified glassy carbon electrode (GCE). A performance comparison of (bio)sensors showed that the one based on HRP/IL-MWCNT-ZnONP/GCE showed the best analytical characteristics with a linear dynamic range of 9.99×10⁻⁸–7.55×10⁻⁴ M, detection limit of 1.37×10⁻⁸ M and sensitivity of 17.00 μA mM⁻¹.     

A new Approach for the Voltammetric Sensing of the Phytoestrogen Genistein at a Non-modified Boron-doped Diamond Electrode

An effective electrochemical sensor was constructed using an unmodified boron-doped diamond electrode for determination of genistein by square-wave voltammetry. Cyclic voltammetric investigations of genistein with HClO₄ solution indicated that irreversible behavior, adsorption-controlled and well-defined two oxidation peaks at about +0.92 (P_A1) & +1.27 V (P_A2). pH, as well as supporting electrolytes, are important in genistein oxidations. Quantification analyses of genistein were conducted using its two oxidation peaks. Using optimized experiments as well as instrumental conditions, the current response with genistein was proportionately linear in the concentrations range of 0.1 to 50.0 μg mL⁻¹ (3.7×10⁻⁷−1.9×10⁻⁴ mol L⁻¹), by the detection limit of 0.023 μg mL⁻¹ (8.5×10⁻⁸ mol L⁻¹) for P_A1 and 0.028 μg mL⁻¹ (1.1×10⁻⁷ mol L⁻¹) for P_A2 in 0.1 mol L⁻¹ HClO₄ solution (in the open circuit condition at 30 s accumulation time). Ultimately, the developed method was effectively applied to detect genistein in model human urine samples by using its second oxidation peak (P_A2).     

Sensitive,Accurate and Selective Determination of Cd(II) Using Anodic Stripping Voltammetry with in-situ Hg-Bi Film Modified Pencil Graphite Electrode After Magnetic Dispersive Solid Phase Microextraction

This paper describes a novel approach to detect Cd(II) using the combination of the differential pulse anodic stripping voltammetry and magnetic nanoparticle based dispersive solid phase microextraction as an efficient, green and accurate method. Currents of Cd(II) increased linearly in the range from 75 to 2000 ng L⁻¹ Cd(II) with a detection limit of 21.6 ng L⁻¹. The RSD values of 2.6 and 6.0 % for 1.00 and 0.10 μg L⁻¹ respectively showed that proposed method has an acceptable repeatability. Recovery values between 92.3 and 98.6 % showed that this approach can be successfully used for determination of Cd(II) in water samples.     

Substituent effects on the ring‐opening mechanism of gem‐dibromospiropentanes to related allenes: a theoretical study

Density functional theory computations at B3LYP and X3LYP levels were performed for ring openings of substituted gem‐dibromospiropentanes (R = ―H, ―Cl, ―Br, ―CH₃, ―SiH₃, ―OH, ―OCH₃, ―CF₃, ―BF₂, and ―SH) to related allenes. The conversion of spiropentanoids 5a , 5b , 5c , 5d , 5e , 5f , 5g , 5h , 5i , 5j to the corresponding allenes 7a , 7b , 7c , 7d , 7e , 7f , 7g , 7h , 7i , 7j can proceed in both concerted and stepwise mechanism except for R = ―H. Both ring‐opening mechanisms have similar activation energy barriers to open the spiropentanylidene ring and generate the structure of allene at all theoretical levels used herein. Generally the π electron‐donating group (―OH or ―SH) decreases the activation barrier for the follow‐up reaction of 1‐bromo‐1‐lithiospiropentanoid and free spiropentanylidene. Hence, both bearing electron‐donating substituents are more reactive than those with electron‐withdrawing group, and the first one to open the ring to the LiBr–allene complex does so more readily than the second. The sEDA index used to measure sigma‐electron excess/deficiency of the cyclopropylidene ring is mutually correlated for the studied systems. Copyright © 2015 John Wiley & Sons, Ltd.     

Multi‐crystalline silicon solar cells with metal‐assisted nano‐texturing using HNO3 as hole injection agent

In this study, metal‐assisted etching (MAE) with nitric acid (HNO₃) as a hole injecting agent has been employed to texture multi‐crystalline silicon wafers. It was previously proven that addition of HNO₃ enabled control of surface texturing so as to form nano‐cone shaped structures rather than nanowires. The process parameters optimized for optically efficient texturing have been applied to multi‐crystalline wafers. Fabrication of p‐type Al:BSF cells have been carried out on textured samples with thermal SiO₂/PECVD‐SiN_x stack passivation and screen printed metallization. Firing process has been optimized in order to obtain the best contact formation. Finally, j_sc enhancement of 0.9 mA/cm² and 0.6% absolute increase in the efficiency have been achieved. This proves that the optimized MAE texture process can be successfully used in multi‐crystalline wafer texturing with standard passivation methods.

J –V curves and SEM images of the nano and iso‐textured samples. j_sc enhancement of 0.9 mA/cm² together with 0.6% absolute efficiency gain was observed on nano‐textured samples.     

A mini-landscape of exact MSSM spectra in heterotic orbifolds

We explore a “fertile patch” of the heterotic landscape based on a Z₆-II${\mathbb{Z}}_6\text{-II}$ orbifold with SO(10) and E₆ local GUT structures. We search for models allowing for the exact MSSM spectrum. Our result is that of order 100 out of a total 3×¹⁰⁴$3\times {10}^4$ inequivalent models satisfy this requirement.