Phospholipase cleavage of D- and L-chiro-glycosylphosphoinositides asymmetrically incorporated into liposomal membranes

The nature of chiro-inositol-containing inositolphosphoglycans (IPGs), reported to be putative insulin mediators, was studied by examination of the substrate specificities of the phosphatidylinositol-specific phospholipase C (PI-PLC) and the glycosylphosphatidylinositol-specific phospholipase D (GPI-PLD) by using a series of synthetic D- and L-chiro-glycosylphosphoinositides. 3-O-alpha-D-Glucosaminyl- (3) and -galactosaminyl-2-phosphatidyl-L-chiro-inositol (4), which show the maximum stereochemical similarity to the 6-O-alpha-D-glucosaminylphosphatidylinositol pseudodisaccharide motifs of GPI anchors, were synthesized and asymmetrically incorporated into phospholipid bilayers in the form of large unilamellar vesicles (LUVs). Similarly, 2-O-alpha-D-glucosaminyl- (5) and -galactosaminyl-1-phosphatidyl-D-chiro-inositol (6), which differ from the corresponding pseudodisaccharide motif of the GPI anchors only in the axial orientation of the phosphatidyl moiety, were also synthesized and asymmetrically inserted into LUVs. The cleavage of these synthetic molecules in the liposomal constructs by PI-PLC from Bacillus cereus and by GPI-PLD from bovine serum was studied with the use of 6-O-alpha-D-glucosaminylphosphatidylinositol (7) and the conserved GPI anchor structure (8) as positive controls. Although PI-PLC cleaved 3 and 4 with about the same efficiency as 7 and 8, this enzyme did not accept 5 or 6. GPI-PLD accepted both the L-chiro- (3 and 4) and the D-chiro- (5 and 6) glycosylinositolphosphoinositides. Therefore, IPGs containing L-chiro-inositol only are expected to be released from chiro-inositol-containing GPIs if the cleavage is effected by a PI-PLC, whereas GPI-PLD cleavage could result in both L-chiro- and D-chiro-inositol-containing IPGs.     

On the observation of electron–hole liquid luminescence under low excitation in Al2O3‐passivated c‐Si wafers

We report on low‐temperature photoluminescence (PL) from aluminum oxide (Al₂O₃)‐passivated c‐Si wafers, which surprisingly exhibits clear signature of the formation of the so‐called electron–hole liquid (EHL), despite the use of excitation powers for which the condensed phase is not usually observed in bulk Si. The elevated incident photon densities achieved with our micro‐PL setup together with the relatively long exciton lifetimes associated with a good quality, indirect band‐gap semiconductor such as our float‐zone c‐Si, are considered the key aspects promoting photogenerated carrier densities above threshold. Interestingly, we observe a good correlation between the intensity of the EHL feature in PL spectra and the passivation performance of the Al₂O₃ layer annealed at different temperatures. The change in the extension of the sub‐surface space‐charge region that results from the balance between the induced fixed charge in the Al₂O₃ and the defect states at the alumina/Si interface is at the origin of the observed correlation. (© 2014 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Laplace deep level transient spectroscopy: Embodiment and evolution

This paper is to commemorate the work of Leszek Dobaczewski¹ who devoted much of his life to the development and application of high resolution DLTS.     

Site preference and magnetism of Fe3−xCrxAl0.5Si0.5

In order to gain better insight into the origin of the observed differences between Fe_3−xCr_xAl and Fe_3−xCr_xSi, alloys of Fe_3−xCr_xAl_0.5Si_0.5 (x=0, 0.125, 0.250, 0.375 and 0.5) were prepared and studied by means of X-ray and neutron diffraction as well as by magnetization measurements. Electronic structure calculations of these alloys have been performed by means of TB-LMTO-ASA method. It was expected, and experimentally verified, that the presence of silicon and aluminum atoms in 1:1 proportion will result in the independence of the lattice parameter on the iron/chromium concentration. All samples have been proved to be a single phase of the DO₃-type of structure. Theoretical and experimental results indicate that chromium atoms locate preferentially in B sublattice. Cr magnetic moments are oriented antiparallel to Fe magnetic moments. Neutron measurements show a linear dependence of the magnetic moments of Fe(A,C), Fe(B) and Cr(B) as a function of Cr concentration. However the calculated total magnetic moment decreases faster with chromium content than indicated by the experiment.     

Antioxidant, antimicrobial and tyrosinase inhibitory activities of xanthones isolated from Artocarpus obtusus F.M. Jarrett

One of the most promising plants in biological screening test results of thirteen Artocarpus species was Artocarpus obtusus FM Jarrett and detailed phytochemical investigation of powdered dried bark of the plant has led to the isolation and identification of three xanthones; pyranocycloartobiloxanthone A (1), dihydroartoindonesianin C (2) and pyranocycloartobiloxanthone B (3). These compounds were screened for antioxidant, antimicrobial and tyrosinase inhibitory activities. Pyranocycloartobiloxanthone A (1) exhibited a strong free radical scavenger towards DPPH free radicals with IC50 value of 2 μg/mL with prominent discoloration observed in comparison with standard ascorbic acid, α-tocopherol and quercetin, The compound also exhibited antibacterial activity against methicillin resistant Staphylococcus aureus (ATCC3359) and Bacillus subtilis (clinically isolated) with inhibition zone of 20 and 12 mm, respectively. However the other two xanthones were found to be inactive. For the tyrosinase inhibitory activity, again compound (1) displayed strong activity comparable with the standard kojic acid.     

The design and characterisation of sol–gel coatings for the controlled-release of active molecules

The controlled release of active agents from a matrix has become increasingly important for oral, transdermal or implantable therapeutic systems, due to the advantages of safety, efficacy and patient convenience. Controlled-release hybrid (organic–inorganic) sol–gel coating synthesis has been performed to create a sol with an active molecule included (procaine). Synthesis procedures included acid-catalysed hydrolysis, sol preparation, the addition of a procaine solution to the sol, and the subsequent gelation and drying. The alkoxide precursors used were triethoxyvinylsilane and tetraethyl-orthosilicate (TEOS) in molar ratios of 1:0, 9:1, 8:2 and 7:3. After the determination of the optimal synthesis parameters, the material was physicochemically characterised by silicon-29 nuclear magnetic resonance (²⁹Si-NMR) and Fourier transform infrared spectroscopy, contact angle analysis and electrochemical impedance spectroscopy tests. Finally, the materials were assayed in vitro for their ability to degrade by hydrolysis and to release procaine in a controlled manner. The sustained release of procaine over a 3-day period was demonstrated. A close correlation between release and degradation rates suggests that film degradation is the main mechanism underlying the control of release. Electrochemical analysis reveals the formation of pores and water uptake during the degradation. The quantity of TEOS is one of the principal parameters used to determine the kinetics of degradation and procaine release.     

火箭布雷发射系统可靠性试验的综合评判

本应用灰色关联分析原理,讨论了火箭布雷发射系统可靠性试验的综合质量评判问题。     

Double-Gyroid Nanostructure Formation by Aggregation-Induced Atropisomerization and Co-Assembly of Ionic Liquid-Crystalline Amphiphiles

We report a new molecular-design principle for creating double-gyroid nanostructured molecular assemblies based on atropisomerization. Ionic amphiphiles containing two imidazolium rings close to each other were designed and synthesized. NMR data revealed that the rotation of the imidazolium rings is restricted, with an activation energy as high as 63 kJ mol⁻¹ in DMSO-d₆ solution (DFT prediction for a model compound in the vacuum: 90–100 kJ mol⁻¹). Due to the restricted rotation, the amphiphiles feature “double” atropisomeric axes in their ionic segments and form three stable atropisomers: meso, R, and S. These isomers co-organize into -type bicontinuous cubic liquid-crystalline mesophases through nanosegregation of the ionic and non-ionic parts. Considering the intrinsic characteristic of -type bicontinuous cubic structures that they are composed of intertwined right- and left-handed single gyroids, we propose that the simultaneous presence of both R- and S-atropisomers is an important contributor to the formation of double-gyroid structures.     

Glycine Substitution Effects on the Supramolecular Morphology and Rigidity of Cell-Adhesive Amphiphilic Peptides

Self-assembling peptides that are capable of adopting β-sheet structures can generate nanofibers that lead to hydrogel formation. Herein, to tune the supramolecular morphologies, mechanical properties, and stimuli responses of the hydrogels, we investigated glycine substitution in a β-sheet-forming amphiphilic peptide. Glycine substitution generally enhances conformational flexibility. Indeed, glycine substitution in an amphiphilic peptide weakened the hydrogels or even inhibited the gelation. However, unexpectedly, glycine substitution at the center of the peptide molecule significantly enhanced the hydrogel stiffness. The central glycine substitution affected the molecular packing and led to twisted β-sheet structures and to nanofiber bundling, which likely led to the stiffened hydrogel. Importantly, the supramolecular structures were accurately predicted by molecular dynamics simulations, demonstrating the helpfulness of these techniques for the identification of self-assembling peptides. The hydrogel formed by the amphiphilic peptide with the central glycine substitution had cell adhesive function, and showed a reversible thermal gel-to-sol transition. Thus, glycine substitution is effective in modulating self-assembling structures, rheological properties, and dynamics of biofunctional self-assembling peptides.