Quantitation of homoharringtonine in plasma by high-performance liquid chromatography with amperometric detection

A high-performance liquid chromatographic procedure was developed for the quantitation of homoharringtonine in plasma. Harringtonine was used as an internal standard, and 1 ml of sample was required. The single-step extraction with dichloromethane resulted in almost 100% recovery for homoharringtonine and harringtonine. Analysis was performed on a reversed-phase CN column with amperometric detection. Chromatography was completed in 12 min. At an oxidation potential of +1.0 V, the detection limit was 1 ng/ml at a signal-to-noise ratio of 2. The mean analytical recovery for homoharringtonine was 99.5%. The within-run precision and between-run precision were both less than 11%. The method is equally applicable for plasma or serum, and it has been demonstrated to be applicable for study of the pharmacokinetics of homoharringtonine in patients suffering from acute non-lymphocytic leukaemia.     

High-frequency magnetoimpedance in nanocomposites

The transmission of millimeter-range electromagnetic waves (30–50 GHz) through a magnetic nanocomposite thin film exhibiting tunnel magnetoresistance (TMR) is calculated. The relative change of transmission coefficient in an applied magnetic field due to the magnetorefractive effect is approximately linear with TMR and strongly depends on nanocomposite resistivity and film thickness. The obtained results are in a good agreement with experiment.     

Biphotonic recording effect of polarization gratings based on dye-doped liquid crystal films

This study investigates a holographic recording effect of biphotonic polarization gratings (BPGs) written on dye-doped liquid crystal (DDLC) films. One linearly polarized green light (λ_G = 514.5 nm) and a polarization-modulated interference pattern formed by two mutually coherent orthogonal (±45° with respect to the polarization of the green light) polarized red lights simultaneously excite the DDLC films to generate a BPG. The formation of BPGs depends primarily on the dichroism of the dye molecules and a sequence of mechanisms: photoisomerization, anisotropic adsorption and inhibition of dye adsorption. The cis-isomer absorbance-modulated distribution associated with the red polarization-modulation pattern induces the dye adsorption-modulated pattern, in turn, yielding the permanent BPG which generates a modulated twisted nematic (TN) structure pattern in the sample. It is found that each BPG is verified to be electrically switchable and thermally erasable. The switching time is in the order of milliseconds. Additionally, the recording time to form a BPG decreases with increasing intensity of the green pump beam.     

Electrical and magnetic properties of CoFeAlO thin films

Influences of oxygen-partial pressure and annealing on the electrical and magnetic properties of CoFeAlO thin films were systematically investigated by means of resistivity, permeability, magnetization and ferromagnetic resonance (FMR) measurements. It was found that, with increasing oxygen-partial pressure or under annealing, the electrical resistivity of the film increased and the magnetic softness decreased, which is attributed to the microstructural change of the film. Interestingly, an as-deposited Co_45.30Fe_20.65Al_19.34O_14.71 film was found to exhibit an inverted hysteresis loop with negative coercivity, and this peculiar phenomenon disappeared upon effects of oxygen-partial pressure and annealing. It was also found that the as-deposited films owned a narrow FMR line width that increased with increasing oxygen-partial pressure or under annealing.     

Singlet versus triplet dynamics of β-carotene studied by quantum control spectroscopy

Biomolecules very often present complex energy deactivation networks with overlapping electronic absorption bands, making their study a difficult task. This can be especially true in transient absorption spectroscopy when signals from bleach, excited state absorption and stimulated emission contribute to the signal. However, quantum control spectroscopy can be used to discriminate specific electronic states of interest by applying specifically designed laser pulses. Recently, we have shown the control of energy flow in bacterial light-harvesting using shaped pump pulses in the visible and the selective population of pathways in carotenoids using an additional depletion pulse in the transient absorption technique. Here, we apply a closed-loop optimization approach to β-carotene using a spatial light modulator to decipher the energy flow network after a multiphoton excitation with a shaped ultrashort pulse in the near-IR. After excitation, two overlapping bands were detected and identified as the S₁ state and the first triplet state T₁. Using the transient absorption signal at a specific probe delay as feedback, the triplet signal could be optimized over the singlet contribution.     

Bimodal fission in binary and ternary spontaneous fission of 252Cf

The hot bimodal fission of ²⁵²Cf is reexamined with new high-statistics data. We constructed a γ-γ-γ coincidence cube for binary fission and LCP-gated γ-γ matrix for ternary fission. By identifying the secondary fission fragments from their γ-ray transitions, we measured the yields for various fission splits. The normal neutron yield distribution is found to be Gaussian for Xe-Ru. However, the binary fission split of Ba-Mo is found to exhibit a bimodal neutron distribution with the “hot mode” corresponding to ≈3.1% of the total yield. In α ternary fission, the first measurements of yields for specific fission splits are presented. The Te-α-Ru and Xe-α-Mo neutron yields fit well with a single mode, but the Ba-α-Zr split shows evidence for an enhanced hot mode with an intensity of ≈13.8% of the normal mode. The text was submitted by the authors in English.     

High-frequency characteristics of CoFeVAlONb thin films

High-frequency characteristics of CoFeVAlONb thin films were studied. A thin film of Co_43.47Fe_35.30V_1.54Al_5.55O_9.93Nb_4.21 is observed to exhibit excellent magnetic properties; magnetic coercivity of 1.24 Oe, uniaxial in-plane anisotropy field of 66.99 Oe, and saturation magnetization of 19.8 kG. The effective permeability of the film is as high as 1089 and is stable up to 1.8 GHz, and with ferromagnetic resonance over 3 GHz. This film also has very high electrical resistivity of about 628 μΩ cm. These superior properties make it ideal for high-frequency magnetic applications.     

Analysis of Decomposition Algorithms with Benders Cuts for p-Median Problem

In this paper the algorithms for solving the p-median problem based on the Benders decomposition are investigated. A family of problems hard for solving with such algorithms is constructed and then generalized to a special NP-hard case of the p-median problem. It is shown that the effectiveness of the considered algorithms depends on the choice of the optimal values of the dual variables used in Benders cuts. In particular, the depth of the cuts can be equal to one.     

Property changes of electroplated Cu/Co alloys and multilayers by organic additives

We investigated the change of magnetic properties of the electroplated Cu/Co alloys and multilayers caused by organic additives and high temperature annealing. When plated with a pure Cu/Co electrolyte, the alloy contained ∼25% of Cu and ∼75% of Co. The alloy was made of hcp-Co, fcc-Co and Cu(1 1 1) and was super-paramagnetic at room temperature. As we add a few organic additives in the plating electrolyte, the hcp-Co of the films disappeared. The organic additives contained in the electrolytes changed paramagnetic Cu/Co multilayers to ferromagnets. High-temperature thermal annealing increased coercivity due to the growth of the Co grains.