Determination of the amino acid tryptophan and the biogenic amine tryptamine in foods by the heavy atom induced-room temperature phosphorescence methodology

Very simple and selective methods are presented to determine the amino acid tryptophan (Trp) and the biogenic amine tryptamine (Tryp), both compounds with an indole-type molecular structure by the methodology named Heavy Atom Induced-Room Temperature Phosphorescence (HAI-RTP) which constitutes the first time that HAI-RTP has been used to detect compounds with non-naphthalenic structures in their molecules. Different variables affecting the phosphorescence signal (heavy atom perturber and sodium sulfite concentration) were carefully studied. The analytical curves give a linear dynamic range of 15-100 ng ml(-1) and a detection limit of 4 ng ml(-1) for Trp and 94-400 ng ml(-1) and 28 ng ml(-1) for Tryp. The methods have been successfully applied to the analysis of complex food matrices such as the presence of tryptophan in yoghurt and tryptamine in bottled beer. A single alkaline hydrolysis to release Trp from yoghurt proteins and two methods for extracting Tryp from beer samples are proposed and optimised. A total Trp content of 374 mg of Trp per kg of yoghurt was quantified by the standard addition method of calibration and a recovery of 90% was obtained for 250 ng ml(-1) of Tryp in spiked non-alcoholic beer samples.     

The modulating possibilities of dicarbollide clusters: optimizing the Kharasch catalysts

exo-Cluster dicarbollides substitution has allowed tuning of the E degrees (Ru(II)/Ru(III)) potential to obtain the best-performing Kharasch catalyst. We postulate that this is possible through the to-and-fro electron movement between the boron cluster and the sulfonium moieties.     

High performance liquid chromatography post-column chemiluminescence determination of sulfonamide residues in milk at low concentration levels using bis[4-nitro-2-(3,6,9-trioxadecyloxycarbonyl)phenyl] oxalate as chemiluminescent reagent

The determination of seven sulfonamides by means of HPLC with chemiluminescence detection is proposed for the first time. The analytes are derivatized with fluorescamine, separated and subsequently they participate in the post-column chemiluminescence (CL) peroxyoxalate system using imidazole as a catalyst. Among the different peroxyoxalates tested, bis[4-nitro-2-(3,6,9-trioxadecyloxycarbonyl)phenyl] oxalate provides higher sensitivities and stabilities, avoiding precipitation problems. A rigorous optimization of the significant variables by means of experimental designs has been developed in order to reconcile the chromatographic conditions with the CL reaction. The method provides detection limits in the low microgl(-1) range and has been satisfactorily applied to the analysis of spiked raw milk samples.     

Simultaneous determination of propacetamol and paracetamol by derivative spectrophotometry

The present paper describes a procedure that phenols in air were preconcentrated in a membrane cell and their content was determined by adsorptive polarography. First, the phenols in air samples were preconcentrated in a membrane cell using 2.0 M NaOH solution, then in a pH 1.3 buffer solution p-bromophenylamine forms a diazoate with NaNO(2), and into the mixture the collected phenols were added to form azo-compound in a pH 13 buffer solution. The azo-compound can be adsorbed at the mercury electrode and yields a sensitive oscillopolarographic wave. Over the range 2.0x10(-8)-2.0x10(-5) M, the peak currents are linearly proportional to the concentration of phenols. The detection limit is 5.0x10(-9) M.     

Pyrylium-containing polymers as sensory materials for the colorimetric sensing of cyanide in water

A sensory polymeric material for the colorimetric sensing of cyanide in water has been developed based on the reactivity of this anion with the pyrylium cation.     

Size evolution of the vibrational predissociation process in Br2...Nen clusters: simulation and kinetic study

A hybrid quantum-classical simulation of the vibrational predissociation of Br2...Nen, (n = 2-11) clusters in the B electronic state is carried out. The time-evolution of the reactants, products, and intermediates is analyzed by a kinetic mechanism consisting of three elementary steps: direct vibrational predissociation (VP), intramolecular vibrational redistribution (IVR), and evaporative cooling (EC). The importance of intramolecular vibrational redistribution followed by evaporative cooling relative to direct vibrational predissociation is shown to increase rapidly with increasing cluster size. Final product state distributions reveal that only one or less Br2 stretching quantum per neon atom is required in order to achieve complete dissociation (n quanta for n < or = 9 and n - 1 for n = 10 and 11). The proportion of available energy going into translation is proposed as a parameter to study the statistical behavior of the Van der Waals clusters. It is shown to depend only on the number of remaining degrees of freedom, a characteristic of a statistical behavior, for n > or = 3.     

Developing an on-line derivatization of FAs by microwave irradiation coupled to HPLC separation with UV detection

The development of analytical methods for routine simultaneous identification and quantification of carboxylic fatty acids (CFAs) are required in different fields, such as, pharmaceutical cosmetics, food products and formulations of water–microemulsion–oil systems. Determination of CFAs has been developed mainly by gas chromatography (GC). As an alternative to GC, liquid chromatography (LC) has better sensitivity and selectivity. However, most CFAs show no useful absorption in ultraviolet–violet (UV–Vis) region, one of the more used detection technique in high-performance liquid chromatography (HPLC). In order to allow the use of UV–Vis detection, the use of pre-column derivatization has been reported to increase sensitivity and selectivity. Therefore, establishment of a simpler and faster on-line method with complete separation is needed for the screening of large numbers of samples. 2,4-Dinitrophenylhydrazine (2,4-DNPH.), benzoil chloride (BC), and phenylhydrazine (PH) were used for derivatization of different FAs by microwaves radiation (MW). After the on-line derivatization, products were separated and quantified by HPLC. Reactor coil was placed inside of microwaves oven at 450 W. Parameters as flow, amount of reagents, irradiation time, and chromatographic conditions were optimized. The continuous analysis using the MW–HPLC–UV system provided high sensitivity and reduced both the amount of reagent used and the analysis times. This proposed method can be used for the routine analysis of FAs contained in water–microemulsion–oil systems, to quantify the total acid fraction in each phase.     

Interfacial properties of self-organized TiO<Subscript>2</Subscript> nanotubes studied by impedance spectroscopy

The semiconductor properties of the interface TiO₂/electrolyte in high organized porous oxide structures were analyzed by means of impedance spectroscopy near the flat band potential. The impedance and capacitance studies performed on the as-anodized and thermally treated samples (anatase) indicate the presence of a duplex structure formed by (1) the oxide at the bottom of the pores and (2) the walls of pores with different donor densities and surface state concentrations.     

Palladium-arene interactions in catalytic intermediates: an experimental and theoretical investigation of the soft rearrangement between eta1 and eta2 coordination modes

A series of dichloro-bridged arylbicycloheptylpalladium complexes have been synthesized and characterized by means of NMR spectroscopy. The compound [(C16H19)PdCl]2*CH2Cl2 with ortho and para methyl substituents at the arene has been characterized by means of X-ray diffraction techniques. The C(ipso) atom of the arene lies almost at the fourth planar coordination site of the metal [Pd-C(ipso) = 2.22(1) A (average)], and due to the arene's tilting, the substituted C(ortho) atom is relatively close to the metal atom [2.54(1) A (average)]. The coordinated C(ipso)-C(ortho) linkage, in a seemingly dihapto coordination, is anti with respect to the CH2 bridge of the bicycloheptyl unit. Variable-temperature NMR experiments for the para-substituted dimer 9 reveal restricted rotation of the two aryl groups about the corresponding C-C(ipso) bonds (DeltaE < or =17 kcal x mol(-1)). DFT-B3LYP calculations have been carried out on the known and similar monomer (phenylbicycloheptenyl)Pd(PPh3)I (4) and its related substituted derivatives. The essential results are as follows: (i) The potential energy surface for twisting the phenyl ring away from the symmetric eta(1) coordination in 4 is very flat (DeltaE < or = 1 kcal x mol(-1)) whereas an Atoms in Molecules analysis excludes the existence of an actual Pd-C(ortho) bond in the seemingly eta2-type conformer. (ii) Complete rotation of the unsubstituted phenyl ring is not facile but feasible. A significant strain affects the transition-state structure featuring a Pd-HC(aryl) agostic-type bond. The calculated destabilization of 10.3 kcal x mol(-1), with respect to the ground state, can be compared to the experimental barrier of the dimer 9. (iii) Various methyl-substituted derivatives of 4 have been optimized, and their structural and energetic trends are discussed. An almost ideal eta1 coordination is shown by the anti conformer of the C(ortho)-substituted complex due steric effects. For all of the other cases, a slipped eta2 coordination may be described. As a general conclusion, the unsaturated metal center receives pi electron density of the arene mainly through its C(ipso) atom. The effect may be slightly improved if the C(ortho) atom also gets closer to the metal, but in no case, does the slipped eta2 coordination seem to be crucial for the stability of the system.     

Copper(II) complexes with 4-amino-N-[4,6-dimethyl-2-pyrimidinyl]benzenesulfonamide. Synthesis, crystal structure, magnetic properties, EPR, and theoretical studies of a novel mixed mu-carboxylato, NCN-bridged dinuclear copper compound

New Cu(II) complexes of sulfamethazine (4-amino-N-[4,6-dimethyl-2-pyrimidinyl]benzenesulfonamide, HL) [Cu(2)(CH(3)COO)(2)(L)(2)].2dmf (1) and ([Cu(L)(2)].2H(2)O)(infinity) (2) were prepared and structurally characterized. Compound 1 crystallizes in the monoclinic system, space group P2(1)/n, with a = 8.9486(9) A, b = 15.0956(12) A, c = 16.542(3) A, beta = 105.584(15) degrees, and Z = 2. Compound 2 crystallizes in the monoclinic system, space group P2(1)/c, with a = 13.8097(8) A, b = 14.5765(4) A, c = 13.7853(15) A, beta = 96.033(9) degrees, and Z = 1. In compound 1 two copper ions are linked by two syn-syn acetates and two nonlinear NCN bridging groups pertaining to the deprotonated sulfamethazine ligands. Each copper center presents a nearly square planar geometry. Magnetic susceptibility data for 1 show a strong antiferromagnetic coupling with 2J = -216.7 cm(-)(1). The EPR spectra at the X- and Q-band frequencies present the signals corresponding to the dinuclear entity, being the zero-field splitting parameter, D = 0.265 cm(-)(1). The antiferromagnetic exchange coupling is discussed using DFT calculations on some model compounds with NCN bridging ligands and also on model structures with mixed mu-acetato and NCN bridges. The copper in the polymeric compound 2 is five coordinate. The CuN(5) chromophore has a highly distorted square pyramidal geometry with small axial N-Cu-N angles of 65.53(14) and 59.90(13) degrees. In the structure a sulfamethazinate anion binds to one copper through the sulfonamido and pyrimidine N atoms and to an adjacent copper via the amino N atom.