Enhanced optical and hydrophilic properties of V and La co-doped ZnO thin films

V and La co-doped and undoped ZnO thin films were deposited on a glass substrate via the sol–gel method to investigate the structural, optical, and wettability of ZnO thin film by changing the V-doping concentration. Microstructure and water contact angles of the films were measured by SEM and contact angle goniometer, respectively. SEM studies revealed that the grain size and surface roughness of the film were changed by doping concentration. In addition, the contact angles were studied to find the possible effects of doping on the hydrophilicity of the film, indicating that the ZnO films were hydrophobic in nature. Finally, a good correlation was observed between the SEM micrographs and contact angle results, and the nature of ZnO film was found to be changed from hydrophobic to hydrophilic.     

Analysis of the photon–photon resonance influence on the direct modulation bandwidth of dual-longitudinal-mode distributed feedback lasers

The paper explores the possibilities to extend the direct modulation bandwidth in dual-longitudinal-mode distributed feedback lasers by exploiting the photon–photon resonance induced by the interaction of the two modes in the laser cavity. The effects on the direct amplitude modulation and on the direct modulation of the difference frequency between the two modes are analyzed using simulation and experimental results. When the photon–photon resonance, which occurs at the difference frequency between the two modes, is properly placed at a higher frequency than the carrier-photon resonance, the small-signal amplitude modulation (AM) bandwidth of the laser can be significantly increased. However, both simulations and experiments point out that a high small-signal AM bandwidth does not lead to a high large-signal AM bandwidth if the small-signal modulation response has significant variations across the modulation bandwidth. The paper shows that a high large-signal AM bandwidth is obtained when the two modes are significantly unbalanced, whereas a high-bandwidth difference frequency modulation can be best detected when the two modes are balanced and the DC bias is properly chosen.     

Novel optical polarizer design based on metasurface nano aperture for biological sensing in mid-infrared regime

Since Metasurfaces are playing important roles in optical devices such as optical polarizers and detectors, in this article, we have proposed a novel shape of nano aperture antenna for mid-infrared applications such as bio-sensing and other potential optical applications based on plasmonic characteristic of the gold layer over the SiN substrate. The transmittance tensor is obtained for vertical and horizontal linear polarization and base on boundary condition of the metasurface, the circular polarizations are extracted which are confirmed by the electric field distributions. We have shown by the parametric studies that the phase difference is altered by the gap and slot width and so with the dimension modification, we are able to achieve circular polarizer in the optical range. The biological materials with a thickness of 80 nm have then been placed over the metasurface layer and the figures of merits have been obtained. We have revealed that when the circular polarization is osculated to the metasurface at a special frequency the linear polarization is obtained in the other side of the metasurface. The nano aperture has been modeled and the finite difference time domain calculations are performed in CST Microwave Studio as a commercial full wave simulation software.     

Current gain and external quantum efficiency modeling of GeSn based direct bandgap multiple quantum well heterojunction phototransistor

This paper aims to provide the performance characteristics of proposed, strain balanced direct band gap multiple quantum wells (MQWs) hetero phototransistor (HPT) made of SiGeSn/GeSn alloys grown on Si substrate which is compatible with recent CMOS fabrication technology. This also presents a comprehensive comparison of this proposed structure with the existing HPT structure made of indirect gap Ge/SiGe MQWs. Alloys of Ge and Sn grown on Si platform shows about tenfold increase in absorption over Ge at C and L-bands due to direct nature of band gap in GeSn. Initial work begins the solution of continuity equation to solve the different terminal current densities and optical gain of the multiple quantum well structure. Main analysis was concentrated on finding the external quantum efficiency depending on the doping variations of emitter and base, base width etc. Finally the photocurrent density variations are estimated for the structure and compared with existing indirect band gap HPT. The calculated values for direct band gap GeSn HPT device are found to be comparable with those for indirect band gap SiGe device to flourish as a potential candidate of photo detectors for the present day telecommunication network.     

Synthesis,characterization, and cytotoxicity evaluation of high-magnetization multifunctional nanoclusters

The paper presents the synthesis, characterization, and in vitro cytotoxicity tests of Fe₃O₄ magnetic nanoclusters coated with ethylenediaminetetraacetic acid disodium salt (EDTA). Electron microscopy analysis (SEM) evidences that magnetite nanoparticles are closely packed into the clusters stabilized with EDTA with well-defined near spherical shapes and sizes in the range 100–200 nm. From XRD measurements, we determined the mean size of the crystallites inside the magnetic cluster about 36 nm. The saturation magnetization determined for the magnetic clusters stabilized with EDTA has high value, about 81.7 emu/g at 300 K. X-ray photoelectron spectroscopy has been used to determine both the elemental and chemical structure of the magnetic cluster surface. In vitro studies have shown that the magnetic clusters at low doses did not induce toxicity on human umbilical vein endothelial cells or lesions of the cell membrane. In contrast, at high doses, the magnetic clusters increased the lipid peroxidation and reduced the leakage of a cytoplasmic enzyme, lactate dehydrogenase (LDH), in parallel with increasing the antioxidant defense.

Open image in new window

Graphical abstract SEM images of EDTA-coated magnetic clusters (MCs) and the HUVEC viability at different MC doses

     

Computational study of plasma-assisted photoacoustic response from gold nanoparticles irradiated by off-resonance ultrafast laser

The gold nanoparticles (AuNPs) are capable of enhancing the incident laser field in the form of scattered near field for even an off-resonance irradiation where the incident laser wavelength is far away from the localized surface plasmon resonance (LSPR). If the intensity of the pulse laser is large enough, this capability can be employed to generate a highly localized free electron (plasma) in the vicinity of the particles. The generated plasma can absorb more energy during the pulse, and this energy deposition can be considered as an energy source for structural mechanics calculations in the surrounding media to generate a photoacoustic (PA) signal. To show this, in this paper, we model plasma-mediated PA pressure wave propagation from a 100-nm AuNPs and the surrounding media irradiated by an ultrashort pulse laser. In this model, the AuNP is immersed in water and the laser pulse width is ranging from 70 fs to 2 ps at the wavelength of 800 nm (off-resonance). Our results qualitatively show the substantial impact of the energy deposition in plasma on the PA signal through boosting the pressure amplitudes up to ～1000 times compared to the conventional approach.     

Transport and abatement of fluorescent silica nanoparticle (SiO<Subscript>2</Subscript> NP) in granular filtration: effect of porous media and ionic strength

The extensive production and application of engineered silica nanoparticles (SiO₂ NPs) will inevitably lead to their release into the environment. Granular media filtration, a widely used process in water and wastewater treatment plants, has the potential for NP abatement. In this work, laboratory-scale column experiments were performed to study the transport and retention of SiO₂ NPs on three widely used porous materials, i.e., sand, anthracite, and granular activated carbon (GAC). Synthetic fluorescent core-shell SiO₂ NPs (83 nm) were used to facilitate NP detection. Sand showed very low capacity for SiO₂ filtration as this material had a surface with limited surface area and a high concentration of negative charge. Also, we found that the stability and transport of SiO₂ NP were strongly dependent on the ionic strength of the solution. Increasing ionic strength led to NP agglomeration and facilitated SiO₂ NP retention, while low ionic strength resulted in release of captured NPs from the sand bed. Compared to sand, anthracite and GAC showed higher affinity for SiO₂ NP capture. The superior capacity of GAC was primarily due to its porous structure and high surface area. A process model was developed to simulate NP capture in the packed bed columns and determine fundamental filtration parameters. This model provided an excellent fit to the experimental data. Taken together, the results obtained indicate that GAC is an interesting material for SiO₂ NP filtration.     

Monitoring nanotechnology using patent classifications: an overview and comparison of nanotechnology classification schemes

Patents are an essential information source used to monitor, track, and analyze nanotechnology. When it comes to search nanotechnology-related patents, a keyword search is often incomplete and struggles to cover such an interdisciplinary discipline. Patent classification schemes can reveal far better results since they are assigned by experts who classify the patent documents according to their technology. In this paper, we present the most important classifications to search nanotechnology patents and analyze how nanotechnology is covered in the main patent classification systems used in search systems nowadays: the International Patent Classification (IPC), the United States Patent Classification (USPC), and the Cooperative Patent Classification (CPC). We conclude that nanotechnology has a significantly better patent coverage in the CPC since considerable more nanotechnology documents were retrieved than by using other classifications, and thus, recommend its use for all professionals involved in nanotechnology patent searches.     

DNA-assisted decoration of single-walled carbon nanotubes with gold nanoparticles for applications in surface-enhanced Raman scattering imaging of cells

Single-walled carbon nanotubes (SWNTs) are 1D nanostructures with distinct physical and chemical properties that have shown great promise for applications in many fields, including biomedicine. Since for biomedical application the water solubility is crucial and SWNTs have low solubility, various methods (including polymer and biopolymer wrapping, chemical modifications) have been developed to solubilize and disperse them in water. Due to their unique optical properties such as photoluminescence in the NIR and strong resonant Raman signatures, they can be used as nanoprobes in biomedical imaging and phototherapies. Furthermore, decoration of SWNTs with noble metal nanoparticles will induce an excellent surface-enhanced Raman scattering (SERS) effect of the nanoparticles-SWNTs composites, with applications in cell imaging. Herein, we present a new and facile strategy for the DNA-assisted decoration of SWNTs with gold nanoparticles (AuNPs) and their application in SERS imaging. By ultrasonication at room temperature of SWNTs with AuNPs functionalized with synthetic DNA, SWNT-AuNPs nanocomposites with enhanced Raman signal were obtained. Among the important advantages of the proposed method are the presence of the free DNA overhangs around the SWNT-AuNPs suitable for post-synthetic modification of nanocomposite through hybridization of complementary DNA strands containing molecules of interest attached by well-developed bio-conjugation chemistry.

Open image in new window

Graphical abstract ?

     

Co-delivery of doxorubicin and AS1411 aptamer by poly(ethylene glycol)-poly(<Emphasis Type="Italic">β</Emphasis>-amino esters) polymeric micelles for targeted cancer therapy

Recently, targeted drug delivery systems (TDDS) have offered a great potential and benefits towards the anti-tumor drug delivery. In this work, we designed the TDDS using a biocompatible poly(ethylene glycol)-poly(β-amino esters) amphiphilic block copolymer (PEG-PAEs) synthesized by Michael addition polymerization for combinatorial therapy. Further, the chemotherapeutic agents’ doxorubicin (DOX) and AS1411 DNA aptamer (Apt) are encapsulated in the PEG-PAEs NPs (PDANs) for co-delivery therapeutics. PDANs have shown the monodisperse spherical shape, smooth surface with a net positive charge (average diameter—183.1 ± 27.2 nm, zeta potential—31.2 ± 6.3 mV), and good colloidal stability (critical micelle concentration of PEG-PAEs is about 6.3 μg/mL). The pH-sensitive PAEs endowed PDANs both pH-triggered drug release characteristics and enhanced endo/lysosomal escape ability, thus improving the localization and cytotoxicity of DOX. AS1411 Apt conjugated PDANs precisely targeted nucleolin and their uptake correlates to a significant activity enhancement only in tumor cells (MCF-7) but not in normal cells (MCF-10A). Thus, PDANs can be a very promising targeted drug delivery platform for effective breast cancer therapy.

Open image in new window

Graphical abstract Scheme 1 Schematic illustration of the preparation and cellular uptake of targeted co-delivery system