Unroofing history of the Sillai Patti granite gneiss, Pakistan: constraints from zircon fission-track dating

A group of alkaline igneous rocks is exposed in the north of the Peshawar Plain, extending from Tarbela in the east up to Loe–Shilman near the Pakistan–Afghanistan border in the west. The alkaline rocks consist mainly of granites, syenites, gabbros, ijolites and carbonatites. Granitic gneisses of Paleozoic age are exposed at the Malakand and further westward at Sillai Patti. However, the fission-track dating studies on zircon, based on the present work, indicate that the age of the Sillai Patti granite gneiss is less than the absolute age of granite gneisses. Therefore, the zircon fission-track age of 24.28±2.97 Ma of the Sillai Patti granite gneiss, represents a time of post-metamorphic denudation history of the area, when these rocks passed through the 210°C isotherm, corresponding to a depth of about 6.7 km inside the earth's crust from their present position if a paleogeothermal gradient of 30°C/km is assumed to have prevailed. Our average fission-track zircon age of 24.28±2.97 Ma is very similar to the average fission-track zircon age of 25.4±0.7 Ma of Mansehra granites. Average cooling rates of the Mansehra and Sillai Patti granite gneisses have been computed to be (8.00±0.22)°C/Ma and (8.00±0.98)°C/Ma, while the average denudation rates of the Mansehra and Sillai Patti granite gneisses have been computed to be (0.262±0.007) and (0.274±0.034) mm/yr, respectively, on the basis of zircon fission-track ages for the period between 25 Ma and the present time. This indicates that the two complexes have experienced similar average cooling/uplift-induced denudation histories during the last 25 Ma or so.     

Septic spline solutions of sixth-order boundary value problems

Septic spline is used for the numerical solution of the sixth-order linear, special case boundary value problem. End conditions for the definition of septic spline are derived, consistent with the sixth-order boundary value problem. The algorithm developed approximates the solution and their higher-order derivatives. The method has also been proved to be second-order convergent. Three examples are considered for the numerical illustrations of the method developed. The method developed in this paper is also compared with that developed in [M. El-Gamel, J.R. Cannon, J. Latour, A.I. Zayed, Sinc-Galerkin method for solving linear sixth order boundary-value problems, Mathematics of Computation 73, 247 (2003) 1325–1343], as well and is observed to be better.     

Immobilization and Characterization of <Emphasis Type="Italic">E. gracilis</Emphasis> Extract with Enriched Laminaribiose Phosphorylase Activity for Bienzymatic Production of Laminaribiose

Immobilization methods and carriers were screened for immobilization of Euglena gracilis extract with laminaribiose phosphorylase activity. The extract was successfully immobilized on three different carriers via covalent linkage. Suitable immobilization carriers were Sepabeads EC-EP/S and ECR 8209M with epoxy groups and ECR 8309M with amino groups as functional units. Immobilization on Sepabeads EC-EP/S resulted in highest retained activity (65%). The immobilizates were characterized for pH, temperature, and buffer molarity preferences. The immobilized enzyme lost 48% of its activity when used seven times. Together with sucrose phosphorylase, laminaribiose phosphorylase was successfully applied for bienzymatic production of laminaribiose from sucrose and glucose with a final laminaribiose concentration of 14.3 ± 2.1 g/L (20% yield).     

Reversed-phase dispersive liquid-liquid microextraction with central composite design optimization for preconcentration and HPLC determination of oleuropein

A reversed-phase dispersive liquid-liquid microextraction (RP-DLLME) method was developed for the preconcentration and direct HPLC determination of oleuropein in olive's processing wastewater (OPW) and olive leaves extracts. In conventional DLLME, the sedimented phase is a micro-drop of a chlorinated organic solvent that is not compatible with RP-HPLC. Therefore, solvent evaporation and reconstitution with an appropriate solvent is often required. In RP-DLLME, this problem was overcome by overturning the solvent polarity in the ordinary DLLME and replacing the organic solvent with water. A central composite chemometrics design was used for multivariate optimization of the effects of five different parameters influencing the extraction efficiency of the method. In the optimized conditions, a mixture of 1.4 mL of an ethyl acetate extract of sample and 40 μL water (pH 5.0) was rapidly injected into 5.3 mL of cyclohexane. After centrifugation of the formed cloudy mixture, a micro-drop of the aqueous phase was sedimented at the conical bottom of the centrifuge tube. This phase, that contained the preconcentrated and partially purified analyte, was directly injected into an RP-HPLC column for analysis. A mean extraction recovery of 102.5 (±4.5) % with enrichment factors exceeding 38, was obtained for five replicated analysis. The detection limit of the method (3σ) for OE was 0.02 μg L⁻¹ for OPW and 2 × 10⁻³ mg kg⁻¹ for olive leaves samples. The results showed that, RP-DLLME is a promising technique which is quick, easily operated and can be directly coupled to HPLC.     

An EQCM study on the influence of saccharin on the corrosion properties of nanostructured cobalt and cobalt-iron alloy coatings

Nanostructured cobalt (Co) and cobalt-iron (CoFe) alloy coatings were electrodeposited from sulfate solutions in the presence and absence of saccharin. The effects of saccharin on the corrosion behavior of Co and CoFe alloy coatings were investigated using the electrochemical quartz crystal microbalance (EQCM) technique coupled with cyclic voltammetry (CV) measurements. Saccharin was added to the electrolyte as a grain refiner and brightener. Interestingly, opposite corrosion behaviors were found for all nanostructured coatings in 0.1 M H₂SO₄ and 0.1 M NaOH. The use of saccharin as an additive in the plating solution accelerated the anodic reaction for all deposits in acidic medium. The mass decreases while dissolution rate increased with higher saccharin concentration. Meanwhile, formation of a thick passive film on the Co electrode surface were enhanced while a hindering effect was observed for CoFe alloy coatings deposited in the presence of saccharin in alkaline solution. The anodic and cathodic curves obtained from potentiodynamic polarization experiments were also in agreement with the EQCM results.     

Intramolecular cyclization of <Emphasis Type="Italic">N</Emphasis>-propargyl anilines: a new synthetic entry into highly substituted indoles

Indole derivatives are an important class of heterocycle found in a large number of natural products and synthetic pharmaceuticals. Given the low cost and easy availability of N-propargyl anilines, synthesis of indole cores from these versatile structural motifs has attracted a lot of attention in the past decade. In this review, we summarize the most representative and interesting reports on this rapidly advancing area, with special emphasis on mechanistic aspects of the reactions.     

Resource allocation based on cost efficiency

In this paper, we consider a resource allocation (RA) problem and develop an approach based on cost (overall) efficiency. The aim is to allocate some inputs among decision making units (DMUs) in such way that their cost efficiencies improve or stay unchanged after RA. We formulate a multi-objective linear programming problem using two different strategies. First, we propose an RA model which keeps the cost efficiencies of units unchanged. This is done assuming fixed technical and allocative efficiencies. The approach is based on the assumption that the decision maker (DM) may not have big changes in the structure of DMUs within a short term. The second strategy does not impose any restrictions on technical and allocative efficiencies. It guarantees that none of the cost efficiencies of DMUs get worse after RA, and the improvement for units is possible if it is feasible and beneficial. Two numerical examples and an empirical illustration are also provided.     

Capture of the complex [Ni(dto)2]2- (dto2- = dithiooxalato ligand) in a Mo12 ring: synthesis, characterizations, and application toward the reduction of protons

The encapsulation of the complex [Ni(dto)(2)](2-) within an oxothiododecamolybdic cyclic cluster has been investigated. The resulting molybdenum ring, [Mo(12)O(12)S(12)(OH)(12)(Ni(dto)(2))](2-), corresponds to the first example of the {Mo(2)O(2)S(2)}-based assembly arranged around a 3d transition-metal complex. It was unambiguously characterized in the solid state and in solution by FT-IR spectroscopy, single-crystal X-ray diffraction, NMR, UV-visible spectroscopy, and electrospray ionization-high-resolution mass spectrometry (ESI-HRMS). The latter technique revealed to be a powerful tool for the characterization of templated molybdenum ring systems in solution and gave excellent results in high resolution. The electronic spectrum of [Mo(12)O(12)S(12)(OH)(12)(Ni(dto)(2))](2-) evidenced a strong red shift of the LMCT bands attributed to the complex [Ni(dto)(2)](2-), suggesting significant variations of the electronic properties upon its encapsulation within the Mo(12) ring. These differences were demonstrated by electrochemical studies in CH(3)CN, which also revealed, for both compounds [Ni(dto)(2)](2-) and [Mo(12)O(12)S(12)(OH)(12)(Ni(dto)(2))](2-), electrocatalytic properties for the reduction of protons. These results evidence the ability of dithioxalato complexes to act as electrocatalysts for the hydrogen evolution reaction (HER) and confirm such a property for oxothiomolybdenum rings.