High-Efficiency ZnCdSe/ZnSSe/ZnMgSSe Green Light-Emitting Diodes

Green light-emitting diodes (LEDs) were fabricated employing a ZnCdSe/ZnSSe triple quantum-well (TQW) active region surrounded by ZnMgSSe cladding layers grown on an n-type (100) GaAs substrate by molecular beam epitaxy (MBE). A 3.5 mW pure green emission was observed for the surface-emitting LED device at a peak wavelength of 513.3 nm (2.415 eV) with a spectral half-width of 11.7 nm (55 meV) under a 20 mA (4.6 V) direct current at room temperature (25°C). These correspond to an external quantum efficiency of 7.2%, a power conversion efficiency of 3.8%, a luminous current efficiency of 66 lm/A, and a luminous efficiency of 14 lm/W.     

Precise measurement of positronium hyperfine splitting using the Zeeman effect

Positronium is an ideal system for the research of the quantum electrodynamics (QED) in bound state. The hyperfine splitting (HFS) of positronium, Δ_HFS, gives a good test of the bound state calculations and probes new physics beyond the Standard Model. A new method of QED calculations has revealed the discrepancy by 15 ppm (3.9σ) of Δ_HFS between the QED prediction and the experimental average. There would be possibility of new physics or common systematic uncertainties in the previous all experiments. We describe a new experiment to reduce possible systematic uncertainties and will provide an independent check of the discrepancy. We are now taking data and the current result of Δ_HFS?=?203.395 1 ±0.002 4 (stat., 12 ppm) ±0.001 9 (sys., 9.5 ppm) GHz has been obtained so far. A measurement with a precision of O(ppm) is expected within a year.     

Mechanically strengthened new Hagi porcelain developed by controlling the chemical environment of iron

In order to enhance the mechanical strength of Hagi Porcelain (Hagiyaki), one of the oldest and famous potteries in Japan, new preparation condition was examined. Tempered Hagi porcelain, denominated as ‘Hagi Porcelain B’, was prepared with the Porcelain clay originating from Daido district, Yamaguchi Prefecture, Japan. Structural change of ‘Hagi Porcelain B’ was investigated by means of ⁵⁷Fe-Mössbauer spectroscopy, X-ray diffractometry (XRD) and three-point bending test. Mechanical strength of the ‘original Hagi Porcelain B’ was estimated to be 43.1 MPa by means of the three-point bending test, while much larger value of 104.5 MPa could be achieved when tempered by a chemical modification. Mössbauer spectrum of the ‘original Hagi porcelain B’ was composed of a paramagnetic doublet and a magnetic sextet due to Fe(III) of γ-Fe₂O₃(maghemite), while only one paramagnetic doublet due to to octahedral Fe(II)O₆ was observed for the ‘tempered Hagi Porcelain B’ with isomer shift and quadrupole splitting values of 1.13 and 2.15 mm s^?1, respectively. It is considered that the absence of magnetic phase causes an increase of the mechanical strength because the maghemite phase has a defect spinel structure. These results indicate that mechanical strength of the ‘Hagi porcelain B’ could be enhanced by controlling the sintering condition.     

Storage and retrieval of a squeezed vacuum

Storage and retrieval of a squeezed vacuum was successfully demonstrated using electromagnetically induced transparency. The squeezed vacuum pulse having a temporal width of 930 ns was incident on the laser cooled 87Rb atoms with an intense control light in a coherent state. When the squeezed vacuum pulse was slowed and spatially compressed in the cold atoms, the control light was switched off. After 3 mus of storage, the control light was switched on again, and the squeezed vacuum was retrieved, as was confirmed using the time-domain homodyne method.     

STM imaging of a model surface of Ru(4,4′-dicarboxy-2,2′-bipyridine)2(NCS)2 dye-sensitized TiO2 photoelectrodes

A TiO₂(1 1 0)-(1 × 1) surface was prepared in an ultra-high vacuum, transported in laboratory air, and observed with a scanning tunneling microscope (STM) operated in a vacuum of 10⁻⁴ Pa. Empty state images showed atomically flat terraces separated by single-height steps, on which 5-fold-coordinated surface Ti atoms were observed as spots arranged in a rectangular lattice. The Ru(4,4′-dicarboxy-2,2′-bipyridine)₂(NCS)₂ (N3) dye was adsorbed on the TiO₂ surface by immersing the TiO₂ wafer into an acetonitrile solution of the dye. In the empty state images, individual N3 molecules were observed as oval particles protruding by 0.6 nm from the TiO₂ surface. The oval shape elongated to the [1  0] directions was attributed to electron tunneling from tip to unoccupied states localized at the two carboxyl groups bound to the TiO₂ surface.     

Study on the single crystal growth of concentration gradient Ce:YAP rod and the dopant concentration dependence on the scintillation properties

Micro-pulling down (μ-PD) method allows to prepare single crystals quickly and relatively inexpensively. Since it is a melt growth and taking into account segregation phenomena, the μ-PD method allows also to obtain single crystals characterized by dopant concentration gradients. Especially, taking the advantage of the grown crystal high aspect ratio, it allows to prepare crystalline samples with variable and wide range concentrations of dopants. These samples can help in understanding the correlation between dopant concentration and luminescence properties.     

Spin-lattice relaxation times of bound water—Its determination and implications for tissue discrimination

Measurements were made of T1 of bound water (T1b) and bound water fraction () for gelatin solutions and human tissues (sera, brain tumor, cerebral white matter). Bound water fraction in each sample was measured by means of thermal analysis (differential scanning calorimetry: DSC). T1 values were measured by FONAR QED 80-. T1b values were calculated by an equation derived from the fast-exchange two-state model. In the study of gelatin solutions, the relationship between T1 and water content differed depending on the sort of solutions. This was considered to be due to differences in T1b values. In each biological tissue the values of T1b and had different distributions. These results indicate that values of T1b and for biological tissues may be altered in correspondence to the changes in pathophysiological states in those tissues.     

Generalized phase-shifting algorithm for dynamic phase measurement in electron-wave interferometry

A generalized phase-shifting algorithm is implemented in the electron-wave interferometry with a transmission electron microscope, based on simultaneous measurement of the initial phases of the interferograms. The initial phase of each interferogram that has inherent linear carrier fringes is calculated using the Fourier co-efiicients of the interferogram itself corresponding to the carrier-frequency. Taking advantage of this phase-shifting method in both spatial resolution and precision, the phase distribution of a biological weak phase object is successfully measured. This promises to be one of the most spectacular application fields for this new technology.     

Tissue gadolinium deposition in renally impaired rats exposed to different gadolinium-based MRI contrast agents: Evaluation with inductively coupled plasma mass spectrometry (ICP-MS)

ObjectivesTo quantify tissue gadolinium (Gd) deposition in renally impaired rats exposed to Gd-EOB-DTPA and other Gd-based MRI contrast agents by means of inductively coupled plasma mass spectrometry (ICP-MS), and to compare the differences in distribution among major organs as possible triggers for nephrogenic systemic fibrosis (NSF).MethodsA total of 15 renally impaired rats were injected with Gd-EOB-DTPA, Gd-DTPA-BMA and Gd-HP-DO3A. Gd contents of skin, liver, kidney, lung, heart, spleen, diaphragm and femoral muscle were measured by inductively coupled plasma mass spectrometry (ICP-MS). Histological assessment was also conducted.ResultsTissue Gd deposition in all organs was significantly higher (P = 0.005 ~ 0.009) in the Gd-DTPA-BMA group than in the Gd-HP-DO3A and Gd-EOB-DTPA groups. In the Gd-DTPA-BMA group, Gd was predominantly deposited in kidney (1306 ± 605.7 μg/g), followed by skin, liver, lung, spleen, femoral muscle, diaphragm and heart. Comparing Gd-HP-DO3A and Gd-EOB-DTPA groups, Gd depositions in the kidney, liver and lung were significantly lower (P = 0.009 ~ 0.011) in the Gd-EOB-DTPA group than in the Gd-HP-DO3A group although no significant differences were seen for any other organs.ConclusionsGd-EOB-DTPA is a stable and safe Gd-based contrast agent (GBCA) showing lower Gd deposition in major organs in renally impaired rats, compared with other GBCAs. This fact suggests that the risk of NSF onset would be low in the use of Gd-EOB-DTPA.     

Distribution of selected monaural acoustical parameters in concert halls

Acoustical parameters calculated from impulse responses are often used to evaluate the characteristics of concert halls. Representative parameters are listed in the Annex of ISO 3382 and the methods of calculation and the minimum number of measurement positions are explained in detail. However, a method for selecting measurement positions is not discussed clearly, because there are wide variations in the characteristics of sound fields. This report provides basic data to solve this problem using spatial distribution characteristics of parameters in halls. Three large-scale measurement campaigns were conducted in which impulse responses were measured at 1427, 180, and 511 locations. Relatively large differences in the obtained parameters compared with well-known difference limens suggest that determining the distributions of parameter values is important. Contour maps are therefore used to display the distributions along with mean values.