Uranium determination by133Xe in meteorites; comparative study with fission track and/or239Np methods and thermal release character of133Xe

Uranium concentrations in three types of inclusions of the Allende (C III), a bulk sample of the Plainview (H5), and a bulk and 5 to 15 density separates of the Huckitta pallasite were determined and discussed by comparing the results from homogenized fission track and/or²³⁹Np analyses with the¹³³Xe results. Stepwise heating experiment revealed that the¹³³Xe release from the Plainview is bimordal and incomplete by a simple heating at 1600 °C, and that the¹³³Xe releases in the Huckitta bulk and metallic samples are multitudinous but can be extracted rather completely at 1600–1700 °C. In the Huckitta, uranium-rich phase (∼100 ppb) was in the lightest density fraction of d=2.9–3.3, but the bulk uranium was found to be mostly from the heavy metal-rich fraction of d>4.2.     

Two-dimensional network formation of cardiac myocytes in agar microculture chip with 1480 nm infrared laser photo-thermal etching

We have developed a new method that enables agar microstructures to be used to cultivate cells and that allows cell network patterns to be controlled. The method makes use of non-contact three-dimensional photo-thermal etching with a 1480 nm infrared focused laser beam, which is strongly absorbed by water and agar gel, to form the shapes of agar microstructures. It allows microstructures to be easily formed in an agar layer within a few minutes, with cell-culture holes formed by the spot heating of a 100 mW laser and tunnels by the tracing of a 100 microm s(-1), 40 mW laser. We cultivated rat cardiac myocytes in adjacent microstructures and observed synchronized beating in them 90 min after they had made physical contact. Our results indicate that the system can make and use microstructures for cell-network cultivation in a minimal amount of time without any expensive microfabrication facilities or complicated procedures.     

Electrodeposition of manganese and molybdenum mixed oxide thin films and their charge storage properties

Manganese and molybdenum mixed oxides in a thin film form were deposited anodically on a platinum substrate by cycling the electrode potential between 0 and +1.0 V vs Ag/AgCl in aqueous manganese(II) solutions containing molybdate anion (MoO(4)2-). A possible mechanism for the film formation is as follows. First, electrooxidation of Mn2+ ions with H2O yields Mn oxide and protons. Then, the protons being accumulated near the electrode surface react with MoO(4)2- to form polyoxomolybdate through a dehydrated condensation reaction (by protonation and dehydration). The condensed product coprecipitates with the Mn oxide. Cyclic voltammetry of the Mn/Mo oxide film-coated electrode in aqueous 0.5 M Na2SO4 solution exhibited a pseudocapacitive behavior with higher capacitance and better rate capability than that of the pure Mn oxide prepared similarly, most likely as a result of an increase in electrical conductivity of the film. Electrochemical quartz crystal microbalance and X-ray photoelectron spectroscopy clearly demonstrated that the observed pseudocapacitive behavior results from reversible extraction/insertion of hydrated protons to balance the charge upon oxidation/reduction of Mn3+/Mn4+ in the film.     

Liquid chromatographic assay for constituent disaccharides of hyaluronic acid and chondroitin sulphate isomers

An improved high-performance liquid chromatographic (HPLC) method for unsaturated disaccharides prepared from hyaluronic acid and various chondroitin sulphate and dermatan sulphate isomers was developed, which involves an ion-exchange resin prepared from a sulphonated styrene-divinylbenzene copolymer. The retention times of the individual unsaturated disaccharides were unique and reproducible, the disaccharides appearing in the following order: unsaturated non-sulphated disaccharide derived from hyaluronic acid, then unsaturated 6-sulphated, non-sulphated and 4-sulphated disaccharides from chondroitin sulphate isomers. Unsaturated disulphated disaccharide G had a much shorter retention time than the unsaturated non-sulphated disaccharide derived from hyaluronic acid. The contents of these individual unsaturated disaccharides could be determined with similar sensitivities on the basis of their ultraviolet absorbance. Selective and unique retention times and good resolutions were found for various unsaturated disulphated and trisulphated disaccharides. The proposed method can be used to determine various chondroitin sulphate and dermatan sulphate isomers in addition to hyaluronic acid in amounts as small as 100 ng to 8 micrograms. The practicality of this method was verified by its application to the separation and determination of the different types of chondroitin sulphate and dermatan sulphate isomers derived from human arteries in the presence of appreciable amounts of hyaluronic acid.     

Oligothiophene-containing coumarin dyes for efficient dye-sensitized solar cells

We have developed oligothiophene-containing coumarin dyes fully functionalized for dye-sensitized nanocrystalline TiO(2) solar cells (DSSCs). DSSCs based on the dyes gave good performance in terms of incident photon-to-current conversion efficiency (IPCE) in the range of 400-800 nm. A solar energy-to-electricity conversion efficiency (eta) of 7.4% was obtained with a DSSC based on 2-cyano-3-[5'-(1,1,6,6-tetramethyl-10-oxo-2,3,5,6-tetrahydro-1H,4H,10H-11-oxa-3a-aza-benzo[de]anthracen-9-yl)-[2,2']bithiophenyl-5-yl]acrylic acid (NKX-2677) under simulated AM 1.5G irradiation (100 mW cm(-2)) with a mask: short-circuit current density (J(sc)) = 13.5 mA cm(-2); open-circuit voltage (V(oc)) = 0.71 V; fill factor (FF) = 0.77. Transient absorption spectroscopy measurements indicated that electron injection from NKX-2677 to the conduction band of TiO(2) is very rapid (<100 fs), which is much faster than the emission lifetime of the dye (1.0 ns), giving a highly efficient electron injection yield of near unity.     

Improving the properties of the proton exchange membranes by introducing α-methylstyrene in the pre-irradiation induced graft polymerization

New proton exchange membranes (PEMs) were prepared by pre-irradiation induced grafting of α-methylstyrene (AMS)/styrene (STY)/divinylbenzene (DVB) into the crosslinked polytetrafluoroethylene (RX-PTFE) films and successively sulfonated. The new PEMs showed the improved glass transition temperature and chemical stability as compared with the PEMs prepared by pre-irradiation induced grafting of STY/DVB. The balance of the cost, grafting kinetic, thermal properties and the properties of the resulted proton exchange membrane is the key point of this work.     

Correlation between the structure of water in the vicinity of carboxybetaine polymers and their blood-compatibility

The structure and hydrogen bonding of water in the vicinity of carboxybetaine homopolymer (poly[1-carboxy-N,N-dimethyl-N-(2'-methacryloyloxyethyl)methanaminium inner salt] (PolyCMB), and a random copolymer of CMB and n-butyl methacrylate, Poly(CMB-r-BMA), with various molecular weights were analyzed in their aqueous solutions and thin film with contours of O-H stretching of Raman and attenuated total reflection infrared (ATR-IR) spectra, respectively. The relative intensity of the collective band (C value) corresponding to a long-range coupling of O-H stretchings of the Raman spectra for aqueous solution of Poly(CMB-r-BMA) was very close to that for pure water, which is in contrast with the smaller C value in aqueous solution of ordinary polyelectrolytes. The number of hydrogen bonds collapsed by the presence of one monomer residue (N(corr) value) of PolyCMB and Poly(CMB-r-BMA) (CMB, 45 mol %) (M(w), 1.14 x 10(4) and 1.78 x 10(4), respectively) could be calculated from the C value. The N(corr) values were much smaller than those for ordinary polyelectrolytes and close to those for nonionic water-soluble polymers such as poly(ethylene glycol) and poly(N-vinylpyrrolidone). Furthermore, a water-insoluble Poly(CMB-r-BMA) with a large BMA content (M(w) = 347 kD, CMB 27 mol %) could be cast as a thin film (thickness, ca. 10 microm) on a ZnSe crystal for the ATR-IR analyses. At an early stage of sorption of water into the Poly(CMB-r-BMA) film, the O-H stretching band of IR spectra for the water incorporated in the film was similar to that for free water, which is in contrast with the drastic change in the O-H stretching band of water incorporated in polymer films such as poly(methyl methacrylate) (PMMA) and poly(n-butyl methacrylate) (PBMA). The theoretical vibrational frequency for water molecules hydrating a betaine molecule calculated by using a density functional method supported the experimental results. The adhesion of human platelets to Poly(CMB-r-BMA) films was much less than that to PMMA and PBMA. With an increase in the content of CMB residue, the number of platelets adhered to the Poly(CMB-r-BMA) film drastically decreased and then gradually increased, probably due to the increase in the roughness of the film surface. These results suggest that the carboxybetaine monomer residues with a zwitterionic structure do not significantly disturb the hydrogen bonding between water molecules in both aqueous solution and thin film systems, resulting in the excellent blood-compatibility of the carboxybetaine polymers.     

High throughput screening of O-glycosylation conditions

We report a novel methodology for rapid and quantitative screening of O-glycosylation reactions of application to the analysis of parallel reaction systems. Our system exploits perdeuterated benzyl (Bn-d₇) ether, and stereoselectivity and yield are evaluated by ¹H NMR and MALDI-TOF MS, respectively. This paper summarizes over 240 screenings of 1 → 3 linkage formation between glucose residues targeting the α-isomer in high yield.     

Statevector reduction in discrete time: A random walk in Hilbert space

A simple model is presented in which the statevector evolves every seconds in one of two ways, according to a particular probability rule. It is shown that this random walk in Hilbert space results in reduction of the statevector. It is also shown how the continuous spontaneous localization (CSL) theory of statevector reduction is achieved as a limiting case of this model, exactly as Brownian motion is a limiting case of ordinary random walk. Finally, a slightly different but completely equivalent form of the CSL equations suggested by the simple model given here is discussed.