Chromatographic and column stability at pH 7 of a C18 dimethylurea polar stationary phase

Chromatographic evaluations of a C18 dimethylurea phase in 150 mm x 3.9 mm HPLC columns were performed using the Tanaka and Engelhardt test mixtures. The applicability of the new C18 dimethylurea phase was also evaluated with a mixture of some herbicides and their metabolites. An artificial aging procedure was also performed by passing a potassium phosphate mobile phase buffered at pH 7.0 through C18 50 mm x 3.9 mm dimethylurea columns. The column stability was evaluated by means of the chromatographic parameters obtained for the separation of some compounds from the Neue test mixture, using apolar, polar and highly basic analytes.     

Titanium as a chemical modifier for the determination of cobalt in marine sediments

The determination of cobalt in marine sediments by electrothermal atomic absorption spectrometry was studied using no modifier and magnesium and titanium as modifiers. Titanium is one of the major sediment constituents, which widely affects the cobalt determination and it was studied as a chemical modifier since it was the only concomitant that increased the cobalt signal in the concentration range usually found in sediments. The performance of Mg and Ti as chemical modifiers was compared relative to maximum pyrolysis and atomization temperatures, linear calibration range, sensitivity and matrix effects. The pyrolysis curves showed that the analyte could be stabilized up to 1400 °C when either Ti or Mg(NO₃)₂ was present, while only 1000 °C could be used in the absence of a modifier. The optimum atomization temperature was 2500 °C in all cases. Analytical curves were compared using no modifier, 5 μg Ti and 100 μg Mg(NO₃)₂ as modifiers, and the linear range found was up to approximately 4 ng Co whether a modifier was used or not. With Ti as a chemical modifier, analytical curves for cobalt in aqueous solution and in a synthetic matrix resulted in the same sensitivity (m₀=55 pg), whereas the use of Mg led to characteristic mass values of 59 and 72 pg in aqueous solution and in a synthetic matrix, respectively, showing some matrix effect. The detection limits (3σ, n=10) were 0.4 μg g⁻¹ using no modifier and 0.3 μg g⁻¹ with Ti as a modifier in the original matrix. A reference estuarine sediment NIST 1646 with a non-certified content of 10.5 μg g⁻¹ Co was analyzed and the found value of 10.9±2.4 μg g⁻¹, (n=3), using Ti as chemical modifier and calibration against aqueous standards, was in good agreement with the recommended value.     

Mechanism of action of 4-hydroxymethyl-1,6,8-trimethylfuro[2,3-h]quinolin-2(1H)-one, a very active angular furocoumarin-like sensitizer

The molecular structure of 1,4,6,8-tetramethylfuro[2,3-h]quinolin-2(1H)-one (FQ), a recent furocoumarin-like photosensitizer, has been modified with the aim of reducing its strong genotoxicity, by replacing the methyl group at 4 position with a hydroxymethyl one, and so obtaining 4-hydroxymethyl-1,6,8-trimethylfuro[2,3-h]quinolin-2(1H)-one (HOFQ). This modification gave rise to a strong reduction of lipophilicity and dark interaction with DNA. The formation of monoadducts (MA) was deeply affected, whereas the induction of bifunctional adducts between DNA and proteins (DPC(L>0)) was replaced by an efficient production of DNA-protein cross-links at zero length (DPC(L=0)), probably via guanine damage. Because of its angular molecular structure, HOFQ does not form interstrand cross-links (ISC): therefore, DPC(L=0) and MA represent the main lesions induced by HOFQ in DNA. In comparison with FQ (which induces MA and DPC(L>0)) and 8-methoxypsoralen (8-MOP) (MA, ISC, DPC(L>0)), HOFQ seems to be a more selective agent. In fact, contrary to FQ and 8-MOP, HOFQ, together with a noticeable antiproliferative activity, shows low levels of point mutations in bacteria and of clastogenic effects in mammalian cells. HOFQ is also an efficient apoptosis inducer, especially in comparison with 8-MOP, when tested at equitoxic experimental conditions; this property might be correlated with the complete HOFQ inability of inducing skin erythemas, a well-known side effect of classic furocoumarin photosensitization.     

Alysis of the volatile constituents of food by headspace GC-MS with reversal of the carrier gas flow during sampling

A technique has been developed for performing headspace GC-MS analysis of volatile components of food, in which the carrier gas flow is reversed during sampling in order to overcome problems caused by the diffusion of substances not retained by the cold trap. Chromatographic profiles of volatile compounds from cheeses, obtained at room temperature, provide confirmation of the validity of the reversed flow technique, and the versatility of the system is evidenced by its successful application to both solid and liquid matrixes: the absence of any discrimination against the various components reveals its efficacy for compounds with a wide range of volatility. Addition of internal standards to the sample enables the use of the technique for quantitative analysis.     

Effects of Adsorbed Polyaniline on Redox Process on MoO3 Surface

The effects exhibited by adsorbed conducting polyaniline on the redox process on a molybdenum oxide surface were studied. Thermogravimetric results indicate a 4% polyaniline deposition. Cyclic voltammograms of the adsorbed polymer on MoO3 show that polyaniline exerts remarkable effects on the molybdenum blue oxidation-reduction process, with oxidation and reduction potentials of 0.33 and 0.18 V, respectively. This effect strongly enhances the electrode response, and can be used as an important tool in qualitative and/or quantitative determinations of molybdenum in solution as well as in any substrate. Copyright 1999 Academic Press.     

Staphylococcus aureus bicomponent gamma-hemolysins, HlgA, HlgB, and HlgC, can form mixed pores containing all components

Staphylococcal gamma-hemolysins are bicomponent toxins forming a protein family with leucocidins and alpha-toxin. Two active toxins (AB and CB) can be formed combining one of the class-S components, HlgA or HlgC, with the class-F component HlgB. These two gamma-hemolysins form pores with marked similarities to alpha-toxin in terms of conductance, nonlinearity of the current-voltage curve, and channel stability in the open state. AB and CB pores, however, are cation-selective, whereas alpha-toxin is anion-selective. gamma-Hemolysins' pores are hetero-oligomers formed by three or four copies of each component (indicated as 3A3B and 3C3B or 4A4B and 4C4B). Point mutants located on a beta-strand of the class-S component that forms part of the protomer-protomer contact region can prevent oligomer assembly. Interestingly, these mutants inhibit growth of pores formed not only by their natural components but also by nonstandard components. This lead to the hypothesis that mixed ABC pores could also be formed. By studying the conductance of pores, assembled in the presence of all three components (in different ratios), it was observed that the magnitudes expected for mixed pores were, indeed, present. We conclude that the gamma-hemolysin/leucocidin bicomponent toxin family may form a larger than expected number of active toxins by cross-combining various S and F components.     

Hetero Diels-Alder reactions (HDAR) of α,α′-dioxothiones on solid support

Solid-supported α,α′-dioxothiones are easily obtained starting from β-ketoester modified Wang and hydroxymethylated polystyrene resins. The hetero Diels-Alder reactions (HDAR) of these species, used either as electron-poor dienes or dienophiles, followed by a simple cleavage of the products from the resin by trans-esterification with sodium methoxide, allowed the isolation of the desired cycloadducts in overall yields up to 90%.     

Copper-assisted oxidation of catechols into quinone derivatives

Catechols are ubiquitous substances often acting as antioxidants, thus of importance in a variety of biological processes. The Fenton and Haber–Weiss processes are thought to transform these molecules into aggressive reactive oxygen species (ROS), a source of oxidative stress and possibly inducing degenerative diseases. Here, using model conditions (ultrahigh vacuum and single crystals), we unveil another process capable of converting catechols into ROSs, namely an intramolecular redox reaction catalysed by a Cu surface. We focus on a tri-catechol, the hexahydroxytriphenylene molecule, and show that this antioxidant is thereby transformed into a semiquinone, as an intermediate product, and then into an even stronger oxidant, a quinone, as final product. We argue that the transformations occur via two intramolecular redox reactions: since the Cu surface cannot oxidise the molecules, the starting catechol and the semiquinone forms each are, at the same time, self-oxidised and self-reduced. Thanks to these reactions, the quinone and semiquinone are able to interact with the substrate by readily accepting electrons donated by the substrate. Our combined experimental surface science and ab initio analysis highlights the key role played by metal nanoparticles in the development of degenerative diseases.

An antioxidant catechol transforms following intramolecular redox reactions into highly reactive oxygen species, a semiquinone and a quinone, on copper.     

Preparation via Diastereoselective Hydrogenation,Absolute Conformation and Configuration of Exogeneous Anabolic Zeranol ((3S, 7R)-3,4,5,6,7,8,9,10,11,12-Decahydro-7,14,16-trihydroxy-3-methy-1H-2-benzoxacyclotetradecin-1-one)

Hydrogenation of the ketone group in di-O-benzylderivative ( 8 ) of the known macrocyclic lactone zeralenone ( 7 ) using a novel chiral borane complex 3 . BH₃, prepared in situ, proceeded at lower temperatures with moderate diastereoselectivity (～40%, d. e. at ?60°). Unsaturated diastereomers 9 and 10 were separated, and 9 converted into zeranol ( 11 ), a known anabolic agent. Restricted conformational mobility at lower temperatures is assumed for the intermediate 8 on the basis of the temperature-dependent CD spectra of its acetyl congeners 18 and 19 . X-Ray structure analysis of 7-O-acetylderivative ( 13 ) of 11 revealed the (R)-configuration at C(7). Two crystallographically independent H₂O molecules are involved in the H-bonds, one of them (O(21)) rises the helices of the molecules of 13 along b. Small positive torsional angle [C(16)-]C(161)-C(1) [=O] (+19.3°), transoid(E) conformation of the lactone group, and nearly achiral arrangement of the C(11)-C(12) bond (torsional angle [C(11)-]C(12)-C(121)[C(161)] is ?93°) are the main conformational features that differentiate the macrocylic RAL (resorcinic-acid lactone) derivatives from the 6-membered lactone derivative 20 , studied earlier by CD. Consequently, the rules developed for the CD effects within conjugation band (around 270 nm), and n→π* band (around 255 nm) of the latter compound, cannot be applied the macrocyclic lactones.     

Synthesis, Electrochemistry and Crystal Structure of the [Ni36Pt4(CO)45]6− and [Ni37Pt4(CO)46]6− Hexaanions

The [Ni₃₆Pt₄(CO)₄₅]^6- and [Ni₃₇Pt₄(CO)₄₆]^6- clusters have been obtained in mixture upon reaction in acetonitrile of [Ni₆(CO)₁₂]^2- salts with K₂PtCl₄ in a 2.5:1 molar ratio. The two hexaanions were indistinguishable by spectroscopic techniques. Crystallization of their trimethylbenzylammonium salts led to crystals of composition 0.5[NMe₃CH₂Ph]₆[Ni₃₆Pt₄(CO)₄₅]-0.5[NMe₃CH₂Ph]₆[Ni₃₇Pt₄(CO)₄₆]·C₃H₈O, hexagonal,space group P6₃ (No. 173), a=17.853(9), c=27.127(13) Å, Z=2; final R=0.057. The metal core of the [Ni₃₆Pt₄(CO)₄₅]^6- anion consists of a Pt₄ tetrahedron fully encapsulated in a shell of 36 Ni atoms belonging to a very distorted and incomplete ₅ tetrahedron. The [Ni₃₇Pt₄(CO)₄₆]^6- hexaanion derives from the former by capping the unique triangular face of the metal polyhedron with an additional Ni(CO) fragment. The [Ni₃₆Pt₄(CO)₄₅]^6--[Ni₃₇Pt₄(CO)₄₆]^6- mixture is rapidly degraded to the known [Ni₉Pt₃(CO)₂₁]^4- cluster by exposure to carbon monoxide. Its reaction with protic acids initially affords the corresponding [H_6-nNi₃₆Pt₄(CO)₄₅]^n--[H_6-nNi₃₇Pt₄(CO)₄₆]^n- (n=5, 4) derivatives, and eventually leads to rearrangement to the known [H_6-n Ni₃₈Pt₆(CO)₄₈]^n- species. Both [Ni₃₆Pt₄(CO)₄₅]^6--[Ni₃₇Pt₄(CO)₄₆]^6- and [HNi₃₆Pt₄(CO)₄₅]^5--[HNi₃₇Pt₄(CO)₄₆]^5- mixtures have been chemically and electrochemically reduced to their corresponding [Ni₃₆Pt₄(CO)₄₅]^n--[Ni₃₇Pt₄(CO)₄₆]^n- (n=7–9) and [HNi₃₆Pt₄(CO)₄₅]^n--[HNi₃₇Pt₄(CO)₄₆]^n- (n=6–8) mixtures.