石墨烯负载高活性Pd催化剂对乙醇的电催化氧化

以石墨粉为原料, 采用Hummers法液相氧化合成了氧化石墨(GO), 然后用化学一步还原制得石墨烯负载钯催化剂. X射线衍射(XRD)、透射电镜(TEM)表征表明, Pd在石墨烯载体上有较好的分散度, 粒径为3-5 nm. 电化学活性面积(EASA)、循环伏安(CV)、计时电流(CA)和计时电位(CP)等电化学测试表明, 与传统Pd/Vulcan XC-72相比, Pd/石墨烯催化剂对碱性介质中乙醇电催化氧化的催化活性有了很大的提高.     

Fabrication of lead titanate single crystalline nanowires by hydrothermal method and their characterization

Single crystalline nanowires of lead titanate (PbTiO₃) were fabricated by hydrothermal method at 200°C using lead acetate and n-tetrabutyl titanate as starting materials, where sodium hydroxide was served as a mineralizer. Crystalline phases, microstructure and optical properties of PbTiO₃ nanowires were investigated. The PbTiO₃ nanowires were uniform and continuous along the long axis, and were composed of single crystalline PbTiO₃ with a tetragonal perovskite structure. The diameter of a single nanowire was around 12 nm and the length reached up to 3 μm. The chemical composition of the samples and the valence states of elements were determined by X-ray photoelectron spectroscopy (XPS). The ultraviolet/visible absorption spectroscopic investigation suggested that the absorption edge of optical transition of the first excitonic state occurred at around 320 nm. A blue-green light emission peaking at about 471 nm (2.63 eV) is observed at room temperature, and the intensity of this emission increased with increasing excitation wavelength. Oxygen vacancies are responsible for the light emission of PbTiO₃ nanowires.     

Unusual magnetic properties of one-dimensional molecule-based magnets associated with a structural phase transition

Three ion-pair complexes, [RbzPy](+)[Ni(mnt)(2)](-) (mnt(2)(-) = maleonitriledithiolate; [RbzPy](+) = 4-R-benzylpyridinium; R = Br (1), Cl (2), and NO(2) (3)), with unusual magnetic properties have been synthesized and characterized. The crystal structures of 1 and 2 have been solved. The two complexes belong to the P2(1)/c space group with Z = 4 and C(20)H(11)BrN(5)NiS(4), a = 12.0744(17) A, b = 26.369(4) A, c = 7.440(3) A, and beta = 102.63(3) degrees for 1 and C(20)H(11)ClN(5)NiS(4), a = 12.105(2) A, b = 26.218(4) A, c = 7.374(2) A, and beta = 102.55(2) degrees for 2, respectively. The [Ni(mnt)(2)](-) anions in 1-3 form uniformly spaced one-dimensional (1-D) magnetic chains of s = 1/2 at room temperature. The temperature dependences of the susceptibility for 1-3 show that they undergo phase transitions. All three complexes are paramagnetic in their high-temperature (abbreviation HT) phase and diamagnetic in the low-temperature (abbreviation LT) phase because of strong dimerization along the stacking direction. The results of thermal analysis (DSC) further confirm that the phase transition for 1 and 2 is first-order but maybe second-order for 3. The phenomena observed in this study are similar to those of the 1-D radical systems.     

TiO2与ZnO复合纳米结构电极的光电化学研究

利用尿素加压共沉淀法以Ti(SO4)2与Zn(NO3)2为原料制备了TiO2-ZnO复合纳米粒子, 其纳米结构电极的光电化学研究结果表明, 反应物摩尔比为3∶1, 于530 ℃煅烧制备的复合纳米结构电极的光电转换效率最高. 对吸附染料RuL2(SCN)2∶2TBA的纳米结构TiO2和各种复合纳米粒子的纳米结构电极进行光电研究的结果表明, 染料对各纳米结构电极都起到了敏化作用, 其中也是由反应物摩尔比为3∶1, 于530 ℃煅烧制备的纳米结构电极的光电转换效率最高. 对聚3-甲基噻吩修饰的纳米结构TiO2和摩尔比为3∶1, 于530 ℃煅烧的复合纳米粒子构成的纳米结构电极进行光电性能研究, 结果表明, 聚3-甲基噻吩与半导体纳米粒子之间存在p-n结, 在一定条件下p-n结的存在有利于光生电子/空穴的分离, 从而提高了光电转化效率.     

Composite Electrode SnO2／TiO2 for Dye-Sensitized Solar Cells

Composite nanoporous electrode SnO2/TiO2 was fabricated for the dye sensitized solar cell (DSSC) with N3 (Cis-Ru). After introducing of TiO2, the open-circuit photovoltage (Voc) was higher than that of the pure SnO2 electrode, while short-circuit photocurrent (Isc) was varied with the ratio of the TiO2. Appropriate content of the TiO2 can be beneficial to the efficiency of the solar cell, and it gives negative impact on the composite electrode when the content of TiO2 is higher.     

Characterization and electrochemical investigation of boron-doped mesocarbon microbead anode materials for lithium ion batteries

The structure and anodic performance of boron-doped and undoped mesocarbon microbeads (MCMBs) have been comparatively studied and the results obtained by XPS, XRD, SEM, Raman spectroscopy and electrochemical measurements are discussed. It is found that boron doping introduces a depressed d ₀₀₂ spacing and the larger amount of "unorganized carbon", which induces vacancy formation in the graphite planes and leads to a quite different morphology from that of the undoped material. Electrochemical charge/discharge cycle tests indicated that after boron doping the lithium intercalation was carried through at a somewhat higher potential, being attended by greater irreversible capacity loss. Electronic Publication     

Enantioselective iodolactonization catalyzed by chiral quaternary ammonium salts derived from cinchonidine

Chiral quaternary ammonium salts derived from cinchonidine have been applied to catalyze the stereoselective iodolactonizations of trans-5-aryl-4-pentenoic acids leading to a mixture of two regioselectively iodolactonized products with fair to excellent yield (37-98%) and moderate enantioselectivity (exo = 42.0% ee, endo = 31.0% ee) under mild conditions. This work is the first example of asymmetric iodolactonization reaction in the presence of less than a stoichiometric amount of chiral reagent.     

Synthesis of a Photolabeling Probe for the Study of Antiviral Mechanism of Ribavirin

Ribavirin has been used in urgency to treat SARS patients recently. In order to study its antiviral mechanism by photolabeling approach, we have synthesized and characterized 5-azido-1-β-D-ribofuranosyl-1,2,4-triazole-3-carboxiamide 1 as a photolabeling probe of ribavirin. The azidotriazole nucleoside showed rapid and clean photochemical reaction, suggesting that 1 is a promising probe to study the antiviral mechanism ofribarivin by photolabeling.     

双8-羟基喹啉端开链冠醚金属络合物的光物理性质

设计合成了双8-羟基喹啉端的开链冠醚QP3Q,研究了金属离子铝或锌与其形成络合物的组成和发光性质,并测定了络合物的激发态寿命.这些络合物在溶液中有较高的荧光量子产率,所得到的络合物固体具有较强的蓝光发光性能.结果表明,有可能通过QP3Q与不同离子形成的络合物得到不同发光波长的发光材料.     

流动分析法同时测定铬（Ⅵ）及铬（Ⅲ）过程中铈（Ⅳ）氧化剂的影响

以Ｃｅ（Ⅳ）为氧化剂，采用流动分析在线氧化技术，实现了对Ｃｒ（Ⅵ）和Ｃｒ（Ⅲ）的同时在线分析，发现Ｃｅ（Ⅳ）氧化剂在测定过程中产生负干扰，在而Ｃｒ（Ⅲ）存在时会使Ｃｒ（Ⅵ）的测定结果偏高，本文提出了一个校正模型，通过数学方法消除上述干扰，所建立的分析方法对Ｃｒ（Ⅵ）和Ｃｒ（Ⅲ）分析的平均相对误差不大于６．５％。