Polarization experiments with the SPIN setup at the ITEP synchrotron

New experimental data on the spin-rotation parameters A and R measured for elastic π ^± p scattering in the resonance region and on the asymmetry in pC scattering at primary momenta in the range 1.35–2.02 GeV/c, as well as in quasielastic proton scattering on nuclei in the same momentum range, are summarized. All these data were recently obtained by using the proton synchrotron installed at the Institute of Theoretical and Experimental Physics (ITEP, Moscow). The spectrum and features of seven isospin-3/2 baryon resonances that form a peak in the total cross section at a c.m. energy of 1.9 GeV are analyzed on the basis of new data on the parameters A and R, and the results of this analysis are presented. The experiments surveyed in this article were performed by a collaboration of researchers from ITEP and the Petersburg Nuclear Physics Institute (PNPI, Gatchina), the ITEP-PNPI collaboration.     

Structural and lithium intercalation studies of Mn(0.5−x)CaxTi2(PO4)3 phases (0≤x≤0.50)

Materials from the Mn_(0.5−x)Ca_xTi₂(PO₄)₃ (0≤x≤0.50) solid solution were obtained by solid-state reaction in air at 1000 °C. Selected compositions were investigated by powder X-ray diffraction analysis, ³¹P nuclear magnetic resonance (NMR) spectroscopy and electrochemical lithium intercalation. The structure of all samples determined by Rietveld analysis is of the Nasicon type with the R space group. Mn²⁺/Ca²⁺ ions occupy only the M1 sites in the Ti₂(PO₄)₃ framework. The divalent cations are ordered in one of two M1 sites, except for the Mn_0.50Ti₂(PO₄)₃ phase, where a small departure from the ideal order is observed by XRD and ³¹P MAS NMR. The electrochemical behaviour of Mn_0.50Ti₂(PO₄)₃ and Mn_(0.5−x)Ca_xTi₂(PO₄)₃ phases was characterised in Li cells. Two Li ions can be inserted without altering the Ti₂(PO₄)₃ framework. In the 0≤y≤2 range, the OCV curves of Li//Li_yMn_0.50Ti₂(PO₄)₃ cells show two main potential plateaus at 2.90 and 2.50–2.30 V. Comparison between the OCV curves of Li//Li_(1+y)Ti₂(PO₄)₃ and Li//Li_yMn_0.50Ti₂(PO₄)₃ shows that the intercalation occurs first in the unoccupied M1 site of Mn_0.50Ti₂(PO₄)₃ at 2.90 V and then, for compositions y>0.50, at the M2 site (2.50–2.30 V voltage range). The effect of calcium substitution in Mn_0.50Ti₂(PO₄)₃ on the lithium intercalation is also discussed from a structural and kinetic viewpoint. In all systems, the lithium intercalation is associated with a redistribution of the divalent cation over all M1 sites. In the case of Mn_0.50Ti₂(PO₄)₃, the stability of Mn²⁺ either in an octahedral or tetrahedral environment facilitates cationic migration.     

Reaction of 3-Alkoxy-7-methylenebicyclo[3.3.1]non-2-ene with N-Halosuccinimides

Russian Journal of General Chemistry -     

An Alternative Approach to Obtain the Exact Wave Functions of Time-Dependent Hamiltonian Systems Involving Quadratic, Inverse Quadratic, and (1/x)p+p(1/x) Terms

By using the Lewis-Riesenfeld theory and algebraic method, we present an alternative approach to obtain the exact solution of time-dependent Hamiltonian systems involving quadratic, inverse quadratic and (1/x)p+p(1/x) terms. This solution is discussed and compared with that obtained by Choi, J. R. (2003). International Journal of Theoretical Physics 42, 853]. PACS: 03.65Ge; 03.65Fd; 03.65Bz     

The Role of a Specific Response of Media in the Vavilov-Cherenkov Effect

It is shown that the condition υ > υ_p (ω), which is necessary in order to trigger the Vavilov-Cherenkov effect, determines the interval of radiated frequencies and it alone cannot establish a strong restriction to the velocity of the particle. It is exhibited that it is possible to define a general lower bound for the velocity of the particle, which does not depend on the frequency when both, a specific response of the medium is taken into account and the mentioned condition is considered. The minimum value of the phase velocity of light in the medium determines the existence of such general lower bound.     

Assessment of thermal expansion coefficient of methylsilsesquioxane thin film

For the methylsilsesquioxane film whose optical birefringence is almost zero, it was recently reported that its vertical thermal expansion coefficient (CTE) was approximately one order of magnitude larger than the lateral CTE. Though the birefringence is not an absolute predictor of anisotropic behavior, the discrepancy in both the CTEs was so remarkable that it was essential to investigate whether the anisotropy was intrinsic property or not. If the effect of Poisson's ratio is considered in the calculation of the vertical CTE and when elastic modulus measured by surface acoustic wave spectroscopy is used in the assessment of the lateral CTE, both the CTEs are coincident with each other. Therefore, it can be concluded that the discrepancy in the CTEs can be attributed to a higher in‐plane polymer chain orientation but it can also arise from the misleadingly assumed modulus and Poisson's ratio. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3109–3120, 2006     

Spectral hole burning of photosynthetic antenna of blue-green algae

Photosystem II core antenna of blue-green algae Synechococcus isolated in gel was studied by optical hole burning spectroscopy at 4·2 K. Persistent holes were burned into fluorescence spectra throughout the region 680–696 nm. The hole width extrapolated to zero burning fluence yielded a value 1·0±0·2 cm^–1. A theoretical interpretation of the hole profile in fluorescence is presented. The dependence of saturated hole depth on burning wavelength is related to inhomogeneous site distribution function.Authors would like to thank F. Vácha from the Dept. of Biochemistry, Faculty of Nature Sciences, Charles University, for the preparation of the samples.     

Prompt gamma cold neutron activation analysis applied to biological materials

Summary Cold neutrons at the external neutron guide laboratory (ELLA) of the KFA Jülich are used to demonstrate their profitable application for multielement characterization of biological materials. The set-up and experimental conditions of the Prompt Gamma Cold Neutron Activation Analysis (PGCNAA) device is described in detail. Results for C, H, N, S, K, B, and Cd using synthetic standards and the “ratio” technique for calculation are reported for several reference materials and prove the method to be reliable and complementary with respect to the elements being determined by INAA. IAEA fellow at the KFA from 6. 3. 91 to 2. 9. 91 on contract No. VIE/9016R.