Microchip free-flow electrophoresis on glass substrate using laser-printing toner as structural material

In this work, a microfluidic free-flow electrophoresis device, obtained by thermal toner transferring on glass substrate, is presented. A microdevice can be manufactured in only 1 h. The layout of the microdevice was designed in order to improve the fluidic and electrical characteristics. The separation channel is 8 microm deep and presents an internal volume of 1.42 microL. The deleterious electrolysis effects were overcome by using a system that isolates the electrolysis products from the separation channel. The Joule heating dissipation in the separation channel was found to be very efficient up to a current density of 8.83 mA/mm(2) that corresponds to a power dissipation per unit volume of running electrolyte of 172 mW/microL. Promising results were obtained in the evaluation of the microdevices for the separation of ionic dyes. The microfluidic device can be used for a continuous sample pretreatment step for micro total analysis system.     

Spectroscopic alterations on enamel and dentin after nanosecond Nd:YAG laser irradiation

Laser irradiation on hard tissue has produced a resistant surface that is likely to prevent caries. In this study, human enamel and dentine were exposed to nanosecond pulsed Nd:YAG laser with energy densities of 20-40 J/cm(2) and pulse width of 6 ns inducing chemical changes in these tissues. Infrared analysis of human dental enamel and dentine was performed using the KBr method (2mg sample/300 mg KBr). A correlation between non-lased and lased spectra was performed that gives an indication of the changes in organic and inorganic compounds after laser-tissue interaction. Spectra of teeth simultaneously show the inorganic and organic parts of the tissue. The principal bands: amide bands A, I, II, and III from the collagen-matrix, phosphate from the mineral content, and carbonate bands were identified. The normalized area of peak versus peak position was determined. Changes of the bands attributed to the collagen matrix were verified after Nd:YAG irradiation. The present results suggest a chemical modification of organic and mineral compounds by laser. The spectral results indicated an alteration in the absorption bands relative to, essentially, organic compounds.     

Interaction of giant extracellular Glossoscolex paulistus hemoglobin (HbGp) with zwitterionic surfactant N-hexadecyl-N,N-dimethyl-3-ammonio-1-propanesulfonate (HPS): effects of oligomeric dissociation

The present work focuses on the interaction between the zwitterionic surfactant N-hexadecyl-N,N-dimethyl-3-ammonio-1-propanesulfonate (HPS) and the giant extracellular hemoglobin of Glossoscolex paulistus (HbGp). Electronic optical absorption, fluorescence emission and circular dichroism spectroscopy techniques, together with Gel-filtration chromatography, were used in order to evaluate the oligomeric dissociation as well as the autoxidation of HbGp as a function of the interaction with HPS. A peculiar behavior was observed for the HPS–HbGp interaction: a complex ferric species formation equilibrium was promoted, as a consequence of the autoxidation and oligomeric dissociation processes. At pH 7.0, HPS is more effective up to 1 mM while at pH 9.0 the surfactant effect is more intense above 1 mM. Furthermore, the interaction of HPS with HbGp was clearly less intense than the interaction of this hemoglobin with cationic (CTAC) and anionic (SDS) surfactants. Probably, this lower interaction with HPS is due to two factors: (i) the lower electrostatic attraction between the HPS surfactant and the protein surface ionic sites when compared to the electrostatic interaction between HbGp and cationic and anionic surfactants, and (ii) the low cmc of HPS, which probably reduces the interaction of the surfactant in the monomeric form with the protein. The present work emphasizes the importance of the electrostatic contribution in the interaction between ionic surfactants and HbGp. Furthermore, in the whole HPS concentration range used in this study, no folding and autoxidation decrease induced by this surfactant were observed. This is quite different from the literature data on the interaction between surfactants and tetrameric hemoglobins, that supports the occurrence of this behavior for the intracellular hemoglobins at low surfactant concentration range. Spectroscopic data are discussed and compared with the literature in order to improve the understanding of hemoglobin–surfactant interaction as well as the acid isoelectric point (pI) influence of the giant extracellular hemoglobins on their structure–activity relationship.     

Determination of arsenic in diesel, gasoline and naphtha by graphite furnace atomic absorption spectrometry using microemulsion medium for sample stabilization

A procedure for the determination of As in diesel, gasoline and naphtha at μg L⁻¹ levels by GFAAS is proposed. Sample stabilization was achieved by the formation of three component solutions prepared by mixing appropriate volumes of the samples propan-1-ol and nitric acid aqueous solution. This mixture resulted in a one-phase medium, which was indefinitely stable. No changes in the analyte signals were observed over several days in spiked samples, proving long-term stabilization ability. The use of conventional (Pd) and permanent (Ir) modification was investigated and the former was preferred. Central composite design multivariate optimization defined the optimum microemulsion composition as well as the temperature program. In this way, calibration using aqueous analytical solutions was possible, since the same sensitivity was observed in the investigated microemulsion media and in 0.2% v/v HNO₃. Coefficients of correlation larger than 0.999 and an As characteristic mass of 22 pg were observed. Recoveries (n=4) obtained from spiked samples were 98±4, 99±3 and 103±5%, and the limits of detection in the original samples were 1.8, 1.2 and 1.5 μg L⁻¹ for diesel, gasoline and naphtha, respectively. Validation was performed by the analysis of a set of commercial samples by independent comparative procedures. No significant difference (Student’s t-test, p<0.05) was observed between comparative and proposed procedure results. The total determination cycle lasted 4 min for diesel and 3 min for gasoline and naphtha, equivalent to a sample throughput of 7 h⁻¹ for diesel and 10 h⁻¹ for gasoline and naphtha.     

Effect of analyte properties on the kinetic performance of liquid chromatographic separations

Advances in modern high-performance liquid chromatography (HPLC) have led to increased interest in the comparison of the ultimate performance limits of methodologies aimed at increasing the resolving power per unit time. Kinetic plot-based methods have proven invaluable in facilitating such evaluations. However, in bridging the gap between fundamental comparisons and the eventual practical applicability of kinetic performance data, the effect of analyte properties have thus far largely been neglected. Using pharmaceutical compounds as representative real-life analytes, it is demonstrated that noteworthy differences in the optimal kinetic performance of a chromatographic system are observed compared to data for common test compounds. For a given stationary phase particle size, higher optimal- and maximum plate numbers, corresponding to increased analysis times, are measured for pharmaceutical compounds. Moreover, it is found that the optimal particle size/maximum pressure combination depends on the analyte under investigation, with the beneficial range of efficiencies for small particles shifted towards higher plate numbers for drug molecules. It is further demonstrated that the pH of the mobile phase plays a crucial role in determining the kinetic performance of pharmaceutical compounds. These data clearly indicate that data for test compounds do not reflect the performance attainable for pharmaceutical compounds and highlights the importance of using real-life samples to perform kinetic evaluations.     

Computational study and analysis of the kinetic isotope effects of the rearrangement of cis-bicyclo[4.2.0]oct-7-ene to cis,cis-cycloocta-1,3-diene

[reaction: see text] On the basis of KIE experiments, the ring opening of cis-bicyclo[4.2.0.]oct-7-ene has been suggested as an anti-Woodward-Hoffmann reaction candidate. We hereby report the results of a high-level computational study of the alternate reaction pathways which proves that the energy profiles show a clear preference for the conrotatory (W-H allowed) ring opening followed by double-bond isomerization. Computed KIE values for the aforementioned mechanism are in good agreement with the experimental values.     

Stereospecific oxidation by compound I of cytochrome P450 does not proceed in a concerted synchronous manner

Calculations show that the transition structure for the synchronous oxygen transfer by Compound I is a second order saddle point. The process is unlikely.     

Dititanium-containing 19-tungstodiarsenate(III) [Ti2(OH)2As2W19O67(H2O)]8-: synthesis, structure, electrochemistry, and oxidation catalysis

The dititanium-containing 19-tungstodiarsenate(III) [Ti(2)(OH)(2)As(2)W(19)O(67)(H(2)O)](8-) (1) has been synthesized and characterized by IR, TGA, elemental analysis, electrochemistry, and catalytic studies. Single-crystal X-ray analysis was carried out on Cs(8)[Ti(2)(OH)(2)As(2)W(19)O(67)(H(2)O)].2CsCl.12H(2)O (Cs-1), which crystallizes in the monoclinic system, space group P2(1)/m, with a=12.7764(19), b=19.425(3), c=18.149(3) A, beta=110.234(3) degrees, and Z=2. Polyanion 1 comprises two (B-alpha-As(III)W(9)O(33)) Keggin moieties linked through an octahedral {WO(5)(H(2)O)} fragment and two unprecedented square-pyramidal {TiO(4)(OH)} groups, leading to a sandwich-type structure with nominal C(2v) symmetry. Synthesis of 1 was accomplished by reaction of TiOSO(4) and K(14)[As(2)W(19)O(67)(H(2)O)] in a 2:1 molar ratio in aqueous, acidic medium (pH 2). Polyanion 1 could also be isolated as a tetra-n-butyl ammonium (TBA) salt, {(n-C(4)H(9))(4)N}(5)H(3)[Ti(2)(OH)(2)As(2)W(19)O(67)(H(2)O)] (TBA-1). TBA-1 was studied by cyclic voltammetry in acetonitrile (MeCN) solutions containing 0.1 M LiClO(4) and compared with the results obtained with Cs-1 in aqueous media. In MeCN, the Ti(IV) and W(VI) waves could not be separated distinctly. An important adsorption phenomenon on the glassy carbon working electrode was encountered both in cyclic voltammetry and in controlled potential electrolysis and was confirmed by Electrochemical Quartz Crystal Microbalance (EQCM) studies on a carbon film. TBA-1, dissolved in MeCN, reacts with H(2)O(2) to give peroxo complexes stable enough for characterization by UV-visible spectroscopy, cyclic voltammetry, and EQCM. TBA-1 shows high catalytic activity (TOF=11.3 h(-1)) in cyclohexene oxidation with aqueous H(2)O(2) producing products typical of a heterolytic oxidation mechanism. The stability of TBA-1 under turnover conditions was confirmed by using IR, UV-visible spectroscopy as well as cyclic voltammetry.     

J-aggregation of a water-soluble tetracationic porphyrin in mixed LB films with a calix[8]arene carboxylic acid derivative

The molecular organization of a mixed film, containing a water-soluble tetracationic porphyrin (TMPyP) and a p-tert-butyl calix[8]arene octacarboxylic acid derivative (C8A), at the air-water interface and on a solid support (LB film), has been investigated. Although the TMPyP aggregation was not detected at the air-water interface, TMPyP J-aggregates have been found in the LB films (Y-type). Unlike tetraanionic porphyrins, for example TSPP, the TMPyP J-aggregates are not induced by a zwitterion formation. The TMPyP J-aggregation is a result of a "double comb" configuration, where porphyrins from opposite layers are interwoven in a linear infinite J-aggregate. Our results confirm that TMPyP molecules tend to self-aggregate strongly, provided the electrostatic repulsions of their peripheral groups are cancelled by the anionic groups of the C8A matrix.