贮雾器与定量手控吸入器配合使用中的数学模型

本文针对支气管哮喘病雾化吸入疗法中的贮雾器与定量手控吸入器配合使用问题 ,通过机理分析 ,利用差分方程建立最优吸入次数的数学模型 ,给出合理的吸入次数及药物剂量结果 .     

用于糖链抗原CA19-9实时动态活检的免疫双光子荧光标记试剂盒

采用双光子荧光标记探针LP制备了免疫双光子荧光抗体LP-Ab,以特异性识别肿瘤标志物CA19-9(Ag)形成抗原-抗体复合物(LP-Ab·Ag),基于双光子诱导荧光机制用近红外激光(740 nm)激发LP-Ab·Ag,利用LP-Ab·Ag的双光子荧光实现了CA19-9的高清晰度、高灵敏度及高分辨率的量化检测和实时动态成像,并制成用于糖链抗原CA19-9检测的简单便捷的双光子荧光标记试剂盒.     

固相萃取-高效液相法测定炒货食品及坚果制品中的多种抗氧化剂

运用固相萃取和高效液相色谱技术,建立炒货食品及坚果制品中丁基羟基茴香醚(BHA)、二丁基羟基甲苯(BHT)、叔丁基对苯二酚(TBHQ)、没食子酸丙酯(PG)等人工合成的抗氧化剂和茶多酚、甘草抗氧化物、迷迭香提取物等天然抗氧化剂的测定方法。样品经甲醇、异丙醇、乙腈等混合溶剂提取,冷冻离心后经C18柱固相萃取净化,用高效液相色谱检测。各抗氧化剂残留量在6~100 mg/L范围内呈良好线性关系,加标回收率为80%~106%。     

稀释溶剂和进样方式对水中苯系物测定的影响

研究了用吹扫-捕集气相色谱法测定水中苯系物时,稀释溶剂甲醇-水对仪器响应表观灵敏度的影响,并与直接进样分析得到的仪器响应表观灵敏度进行了比较.研究结果表明,分析水中挥发性有机物时选择合适稀释溶剂和相同的分析程序对测定结果非常重要.     

3-(吗啉吡啶基)-5-取代异噁唑类化合物的合成及抗菌活性研究

以6-氯-3-吡啶甲醛为原料, 通过多步反应合成了一系列3-(吗啉吡啶基)-5-取代异噁唑类化合物, 并用IR, 1H NMR, 13C NMR和MS进行了结构确证. 这些化合物均以异噁唑为母核, 具有近似的平面结构, 在异噁唑环的3-位引入吗啉吡啶基, 而在5-位引入酯基、取代氨基、三唑环和噁唑烷酮环. 研究了这些化合物对金黄色葡萄球菌、耐甲氧西林金黄色葡萄球菌、表皮葡萄球菌、粪肠球菌和大肠杆菌的抑制活性, 发现与噁唑烷酮类上市药物利奈唑胺相比, 目标化合物均显示出更低的抗菌活性, 最低抑制浓度(MIC)大于32 mg/L, 这些试验结果表明异噁唑母核的5-位缺乏sp3杂化结构, 可能会导致抗菌活性的显著降低.     

固相微萃取-气相色谱质谱法联用测定水体中痕量多环麝香类化合物

采用固相微萃取-气相色谱质谱法联用测定了水体中痕量多环麝香类化合物。对固相微萃取条件和解析条件进行了优化,确定了微萃取条件为:选用65μmPDMS-DVB萃取头、顶空萃取模式(HS),在800 r/min,60℃条件下,萃取45 min;萃取过程中保持pH 7并且不加入NaCl;解析条件为:解析时间为3 min,插入GC深度为4 cm,进样口温度为250℃。方法的检测限为0.29～0.37 ng/L,线性范围5～1000ng/L,相对标准偏差1.5%～2.2%。对实际污水厂不同类型的水样使用优化后的实验条件进行了验证试验,目标化合物的回收率在82.5%～92.8%之间,表明优化后的试验条件适用于实际水体中痕量多环麝香类化合物的分析测定。     

Predictions of pressure-induced structural transition,mechanical and thermodynamic properties of α-and β-Si₃N₄ ceramics:ab initio and quasi-harmonic Debye modeling

The plane-wave pseudo-potential method within the framework of ab initio technique is used to investigate the structural and elastic properties of α-and β-Si3N4.The ground-state parameters accord quite well with the experimental data.Our calculation reveals that α-Si3N4 can retain its stability to at least 40 GPa when compressed at 300 K.The α→β phase transformation would not occur in a pressure range of 0-40 GPa and a temperature range of 0-300 K.Actually,the α→β transition occurs at 1600 K and 7.98 GPa.For α-and β-Si3N4,the c axes are slightly more incompressible than the a axes.We conclude that β-Si3N4 is a hard material and ductile in nature.On the other hand,β-Si3N4 is also found to be an ionic material and can retain its mechanical stability in a pressure range of 0-10 GPa.Besides,the thermodynamic properties such as entropy,heat capacity,and Debye temperature of α-and β-Si3N4 are determined at various temperatures and pressures.Significant features in these properties are observed at high temperature.The calculated results are in good agreement with available experimental data and previous theoretical values.Many fundamental solid-state properties are reported at high pressure and high temperature.Therefore,our results may provide useful information for theoretical and experimental investigations of the Si3N4 polymorphs.     

Improved atom number with a dual color magneto-optical trap

We demonstrate a novel dual color magneto–optical trap (MOT), which uses two sets of overlapping laser beams to cool and trap 87 Rb atoms. The volume of cold cloud in the dual color MOT is strongly dependent on the frequency difference of the laser beams and can be significantly larger than that in the normal MOT with single frequency MOT beams. Our experiment shows that the dual color MOT has the same loading rate as the normal MOT, but much longer loading time, leading to threefold increase in the number of trapped atoms. This indicates that the larger number is caused by reduced light induced loss. The dual color MOT is very useful in experiments where both high vacuum level and large atom number are required, such as single chamber quantum memory and Bose–Einstein condensation (BEC) experiments. Compared to the popular dark spontaneous-force optical trap (dark SPOT) technique, our approach is technically simpler and more suitable to low power laser systems.