Antireflective characteristics of triangular shaped gratings

It is well known that conventional multi-layers are oftenused for antireflective coatings[1,2]. There are, however,only a handful of optical materials available, thus limit-ing the performance that could ideally be achieved. Onthe other hand, sub-wavelength structure surfaces, whichare surface-relief gratings with periods smaller than theincident wavelength, have been researched and foundto have antireflective properties[3,8]. Compared withstandard optical thin-film coating technologies, the h…     

Effect of Microstructure of TiO2 Thin Films on Optical Band Gap Energy

TiO2 coatings are prepared on fused silica with conventional electron beam evaporation deposition. After annealed at different temperatures for four hours, the spectra and XRD patterns of TiO2 thin film are obtained. XRD patterns reveal that only anatase phase can be observed in TiO2 coatings regardless of the different annealing temperatures, and with the increasing annealing temperature, the grain size gradually increases. The relationship between the energy gap and microstructure of anatase is determined and discussed. The quantum confinement effect is observed that with the increasing grain size of TiO2 thin film, the band gap energy shifts from 3.4 eV to3.21 eV. Moreover, other possible influence of the TiO2 thin-film microstructure, such as surface roughness and thin film absorption, on band gap energy is also expected.     

Influence of coating material on laser damage threshold of TiO_2 films

The optical property,structure,surface properties(roughness and defect density)and laser-induced dam- age threshold(LIDT)of TiO_2 films deposited by electronic beam(EB)evaporation of TiO_2(rutile),TiO_2 (anatase)and TiO_2 Ta_2O_5 composite materials are comparatively studied.All films show the polycrys- talline anatase TiO_2 structure.The loose sintering state and phase transformation during evaporating TiO_2 anatase slice lead to the high surface defect density,roughness and extinction coefficient,and low LIDT of films.The TiO_2 Ta_2O_5 composite films have the lowest extinction coefficient and the highest LIDT among all samples investigated.Guidance of selecting materials for high LIDT laser mirrors is given.     

用e+e－→h′s反应中类双喷注事例研究部分子末态的色联接

借助JETSET事例产生器对e⁺e^－→h′s反应中的类双喷注事例进行研究.研究发现,在QCD微扰与非微扰的界面上,部分子系统的色中性流和色分离单态两种不同色联接方式导致了强子末态某些可观测量的显著差别.因此,它们可以用于判别部分子的色联接方式.     

二极管伏安特性曲线测试电路的改进

指出了文献中所给出的伏安法测二级管特性曲线电路存在的问题，并给出了改进电路。     

Y2O3稳定ZrO2薄膜的结构和光学特性

用电子束蒸发法制备出四种不同Y2O3含量的Y2O3稳定ZrO2（YSZ）薄膜,用X射线衍射和透射光谱测定薄膜的结构和光学性能.结果表明：随着Y2O3含量的增加,ZrO2薄膜从单斜相向高温相（四方相和立方相）转变,获得了结构稳定的YSZ薄膜;YSZ薄膜的晶粒尺寸都比ZrO2薄膜的大,但随着Y2O3加入量的增加,晶粒尺寸有减小的趋势,薄膜表面也趋向光滑平整.所有YSZ薄膜的透射谱线都与ZrO2薄膜相似,在可见光和红外光区都有较高的透过率.Y2O3的加入还可以改变薄膜的折射率,在一定范围内可得到所需的任意折射率.     

ICP／AES操作条件及氢化物发生条件对As,Se和Ge光谱信号影响的…

本文较系统地研究了ＩＣＰ／ＡＥＳ操作条件及酸介质。ＨａＢＨ４溶液溶度对Ａｓ，Ｓｅ和Ｇｅ谱线强度以及信背比的影响，讨论了这些元素的最佳检测条件，考察了一些共存元素对氢化物光谱信号的影响，观察到Ａｓ，Ｓｅ和Ｇｅ氢化物发生中Ｇｅ的光谱信号的一些特殊行为，及Ｃｕ对Ｇｅ的氢化物光谱信号的增强。     

溅射气压对X射线多层膜反射率的影响

本文在不同的溅射气压的情况下制备了具有相同结构参量的Mo/Si多层膜,测出了其对应的小角度X衍射曲线,在北京同步辐射实验室测量了多层膜的软X射线反射率.小角X射线衍射谱表明:随着溅射气压升高,多层膜的小角X射线衍射曲线的高次峰的峰高急剧变小,半峰宽变大.反射率测量结果也表明:多层膜的X射线反射率随溅射气压的升高而急剧降低.     

周期性梯度折射率多层膜的软X射线反射率

由于界面互扩散的存在,实际的超薄多层膜很难具有清晰的界面结构.假设超薄多层膜为具有周期性梯度折射率的多层膜结构,用直线模型和余弦模型模拟了周期性梯度折射率多层膜的软X射线反射率.结果证明,折射率余弦渐变的多层膜虽然不具有清晰的界面,但它同样具有很高的反射率.     

论浮力的计算

通过讨论物体下表面不与液体接触时浮力的计算,总结浮力计算的一般方法.