全文获取类型
收费全文 | 54篇 |
免费 | 2篇 |
国内免费 | 4篇 |
专业分类
化学 | 11篇 |
晶体学 | 2篇 |
综合类 | 2篇 |
数学 | 2篇 |
物理学 | 43篇 |
出版年
2020年 | 1篇 |
2019年 | 1篇 |
2018年 | 1篇 |
2017年 | 1篇 |
2016年 | 1篇 |
2014年 | 5篇 |
2013年 | 2篇 |
2012年 | 5篇 |
2011年 | 6篇 |
2009年 | 3篇 |
2008年 | 1篇 |
2007年 | 3篇 |
2006年 | 3篇 |
2005年 | 3篇 |
2004年 | 3篇 |
2003年 | 1篇 |
2002年 | 1篇 |
2001年 | 3篇 |
2000年 | 1篇 |
1999年 | 2篇 |
1998年 | 4篇 |
1996年 | 3篇 |
1995年 | 3篇 |
1994年 | 1篇 |
1993年 | 1篇 |
1992年 | 1篇 |
排序方式: 共有60条查询结果,搜索用时 15 毫秒
51.
52.
53.
阴影叠栅相移非线性误差补偿算法研究 总被引:2,自引:2,他引:0
相移阴影叠栅干涉场的相位(高度)存在非线性关系,而传统的相移阴影叠栅技术往往忽略了相位与高度的非线性关系,从而在测量系统中引入测量误差。对此提出了一种基于迭代相位解调自调算法相移阴影叠栅技术,该方法利用最小二乘技术获得相移量估算值,利用该估算值通过迭代算法消除相移阴影叠栅的全场相位误差,从而得到正确的相位分布。模拟计算表明该方法可以有效解决相移不均产生的相位测量误差问题,且可实现光栅移动量的精确估算,其误差不超过3.4%。对比实验进一步说明了所提出方法的正确性和优越性。 相似文献
54.
本文提出了一种叠栅条纹解调技术,我们称它为频移叠栅法,它不同于相移叠栅法,前者改变了叠栅条纹分布的频率,后者只是改变了叠栅条纹的相位.本文从阴影叠栅图分布的基本公式出发,借助于相移阴影叠栅法的思想推导并得出了频移阴影叠栅法的公式,在此基础上给出了特定条件下的实用公式.同时也分析了其相位图,将其主值范围从0~π拓展到0~2π,解决了其去包裹中正负号确定问题.最后给出了实验结果,并分析和模拟了由于频移的不准确给测量结果带来的影响. 相似文献
55.
基于Mexican hat小波变换的三维轮廓术 总被引:4,自引:1,他引:3
为了提高小波变换轮廓术中小波的空域局部化能力, 提出了一种基于Mexican hat小波变换的条纹图处理方法.基于希尔伯特变换得到条纹对应的解析信号, 用Mexican hat小波计算解析信号的连续小波变换, 从小波变换的脊上提取相位信息, 恢复物体高度信息.模拟结果表明, Mexican hat小波变换法在相位快变或突变的区域有更高的相位提取精度, 测量误差可减小0.1~0.5 rad.以人脸石膏像为例, 进行了实验测量.实验结果表明, 在高度不连续或变化剧烈的区域, Mexican hat小波变换法较Morlet小波方法误差传播更小, 精度更高. 相似文献
56.
提出了两种在相位轮廓术中使用离散小波变换提取条纹相位的方法:单次分解法和多次分解法.前者用多分辨率分析的多孔算法计算变形条纹解析信号的离散小波变换,寻找每一位置的小波系数在尺度方向上的模极大值点,通过提取该点的相位就可以得到原条纹的相化值;后者是在前者的基础上,通过插值改变条纹信号的抽样率,再次进行多分辨率分析,得到冗余的小波系数,提取条纹相位.单次分解法适合处理正弦载频条纹图,多次分解法抗噪性好,可以处理带有高次谐波的准止弦载频条纹图.相对于使用连续小波变换的方法.这两种方法较适合处理离散信号,对于512 pixel × 512 pixel的条纹图计算速度分别提高90%和50%.计算机模拟和实验验证了方法的有效性. 相似文献
57.
58.
以黄冶窑四个时期的白瓷样品作为研究对象,利用X射线衍射仪(XRD)和扫描电子显微镜(SEM)对样品进行分析,结果表明:黄冶窑白瓷胎的物相基本相同,主要是莫来石、α石英和方石英、未熔石英和少量的粘土相;黄冶窑白瓷釉中有气泡存在,釉中气泡为圆形,釉中存在微米级的针状或柱状钙长石晶体,釉存在分相结构,且分相结构与析晶相伴而生;黄冶窑白瓷胎中有气孔、未熔的石英颗粒、较大的Ti颗粒、莫来石晶体和石英晶体。The white porcelain samples of the four periods of Huangye kiln were studied in this paper, and the samples were analyzed by X-ray diffraction (XRD) and scanning electron microscopy (SEM). The results show that the material phase is basically the same of the white porcelain bodies from Huangye kiln, and mainly mullite, alpha quartz and cristobalite, unmelted quartz and a small amount of clay phase; There are some round bubbles in HuangYe kiln white porcelain, glazes, so are some feldspathic crystals with micro-level needles or columnar. It is evident to observe phase separation structure, which is accompanied by the birth. Apart from some pores, unfused quartz particles, larger Ti particles, mullite crystals and quartz crystals can also be found in the embryo of Huangye kiln white porcelain. 相似文献
59.
60.
The phase modulation characteristics of a reflective liquid crystal(LC) spatial light modulator(SLM) under oblique incidence are studied by using our proposed self-interference method. The experimental setup of the method is very simple and has good robustness to mechanical vibrations. By changing the gray value of the combined grayscale loaded on the LC-SLM, different sheared fringe patterns, generated by the interference between the constant phase-modulated beam and the +1-order diffracted beam of the blazed grating, can be obtained. The amount of phase modulation of the LC-SLM is obtained by subtracting the phase of the two side lobes in the frequency domain. By turning the turntable where the SLM is mounted, the phase modulation characteristics at different incident angles can be measured. The experimental results show that the phase modulation curves do not change significantly with the small angle. When the angle is large(i.e. larger than 10°), the phase modulation curves become different, especially for the high gray levels. With the increase of the incident angle, the phase modulation depth is reduced. The results indicate that the incident angle plays an important role in the performance of the phase modulation of an LC-SLM. 相似文献