Influence of Intertube Additional Atoms on Sliding Behaviors of Double-Walled Carbon Nanotube

The effects of intertube additional atoms on the sliding behaviors of double-walled carbon nanotubes(DWCNTs) are investigated using molecular dynamics(MD) simulation method.The interaction between carbon atoms is modeled using the second-generation reactive empirical bond-order potential coupled with the Lennard-Jones potential.The simulations indicate that intertube additional atoms of DWCNT can significantly enhance the load transfer between neighboring tubes of DWCNT.The improvement in load transfer is guaranteed by the addition of intertube atoms which are covalently bonded to the inner and outer tubes of DWCNT.The results also show that the sliding behaviors of DWCNT are strongly dependent of additional atom numbers.The results presented here demonstrate that the superior mechanical properties of DWCNT can be realized by controlling intertube coupling.The general conclusions derived from this work may be of importance in devising high-performance CNT composites.     

Lowest-lying spin-1/2 and spin-3/2 baryon magnetic moments in chiral perturbation theory

We review some recent progress in our understanding of the lowest-lying spin-1/2 and spin-3/2 baryon magnetic moments （MMs） in terms of Chiral Perturbation Theory （ChPT）.In particular,we show that at next-to-leading-order ChPT can describe the MMs of the octet baryons quite well.We also make predictions for the decuplet MMs at the same chiral order.Among them,the MMs of the Δ＋＋ and Δ ＋ are found to agree well with data within the experimental uncertainties.     

Degradation of current–voltage and low frequency noise characteristics under negative bias illumination stress in InZnO thin film transistors

The instabilities of indium–zinc oxide thin film transistors under bias and/or illumination stress are studied in this paper. Firstly, illumination experiments are performed, which indicates the variations of current–voltage characteristics and electrical parameters(such as threshold voltage and sub-threshold swing) are dominated by the stress-induced ionized oxygen vacancies and acceptor-like states. The dependence of degradation on light wavelength is also investigated. More negative shift of threshold voltage and greater sub-threshold swing are observed with the decrease of light wavelength.Subsequently, a negative bias illumination stress experiment is carried out. The degradation of the device is aggravated due to the decrease of recombination effects between ionized oxygen vacancies and free carriers. Moreover, the contributions of ionized oxygen vacancies and acceptor-like states are separated by using the mid-gap method. In addition, ionized oxygen vacancies are partially recombined at room temperature and fully recombined at high temperature. Finally, low-frequency noise is measured before and after negative bias illumination stress. Experimental results show few variations of the oxide trapped charges are generated during stress, which is consistent with the proposed mechanism.     

高二年级下学期期末复习

1)本章的重点：①平面的基本性质(三个公理和三个推论)是研究立体几何的基础．②空间直线、直线和平面及两个平面之间的特殊关系——平行与垂直的判定与性质；三垂线定理及其逆定理是证明线线垂直的重要结论．③空间角和空间距离的计算．“作(或找)、证、算”是解决这类问题的基本步骤．④空间向量的运算和应用．注意掌握空间向量共线、共面、垂直的充要条件，     

快速分离柱高效液相色谱法测定卷烟主流烟气中的主要羰基化合物

选择2,4-二硝基苯肼(DNPH)为羰基化合物的衍生化试剂,建立了快速分离柱高效液相色谱测定卷烟主流烟气中8种羰基化合物的方法。采用经2,4-二硝基苯肼酸性溶液处理过的剑桥滤片捕集烟气,再用含2%（体积分数）吡啶的乙腈溶液进行萃取,以ZORBAX Stable Bound色谱柱(50 mm×4.6 mm,1.8 μm)进行快速分离,最后由二极管阵列检测器于365 nm下进行检测。该方法的回收率为89.1%～99.2%,相对标准偏差（RSD)在6.0%以下。该方法分析时间短,流动相消耗少,且操作简便、重复性好、回收率高。     

P(DMAA-co-AM)水凝胶制备及其固定α-淀粉酶研究

采用氧化还原引发体系,水溶液聚合法制备P(DMAA-co-AM)水凝胶,并以其作为载体固定α-淀粉酶。采用单一变量法研究交联剂(N,N’-亚甲基双丙烯酰胺)用量、引发剂(过硫酸铵)用量、单体浓度和单体配比对凝胶性能的影响。以水凝胶的最大平衡溶胀度为指标,得出制备P(DMAA-co-AM)水凝胶的优化条件:交联剂用量为0.3%,引发剂用量为0.6%,单体浓度为20%,N,N′-二甲基丙烯酰胺与丙烯酰胺的摩尔比为2∶1。在优化条件下,采用原位聚合法固定α-淀粉酶,测定不同单体配比的P(DMAA-co-AM)水凝胶固定化α-淀粉酶的活性。     

基于核酸适配体的微流控芯片酶反应器用于蛋白质的分析

将核酸适配体作为胰蛋白酶固定化介质,制备了一种新型的微流控芯片酶反应器,并与高效液相色谱-串联质谱联用,搭建了在线分析平台;分别使用标准蛋白及混合蛋白样品对芯片的酶解效率及联用平台的分析能力进行了初步评价。结果表明,5 ng肌红蛋白经该平台分析后肽段覆盖率可达到37%;对500 ng混合蛋白进行3次平行分析,肽段覆盖率及相对标准偏差分别为44.3%、6.5%(牛血清白蛋白), 65.0%、2.7%(肌红蛋白)和62.0%、5.6%(细胞色素c);初步实验表明,该在线分析平台具有检测灵敏度高、重现性好、酶解效率高的特点,有望在蛋白质组学分析中发挥重要作用。     

无机砷甲基化研究进展

砷是一种生物活性元素。长期接触砷会导致癌症、心脏病、糖尿病等疾病的发生。无机砷甲基化是砷在动物体内的主要代谢方式,被公认为砷元素的解毒过程,因此无机砷甲基化的研究引起了科学家们的广泛关注并取得了重要进展。本文综述了近年来国内外学者及作者研究组在"砷甲基化酶","无机砷甲基化机制"及"无机砷甲基化抑制"等方面的研究进展。     

银辅助化学刻蚀半导体材料

微电子器件的发展趋势是小型化和多功能化,这就对半导体材料的加工技术提出了更高的要求。与传统的加工技术相比,近年发展起来的贵金属粒子辅助化学刻蚀半导体材料制备微结构技术因操作简单、不需要精密设备、反应迅速和可批量生产等优点引起了国内外学者的广泛关注。本文以Si为主,详细介绍了Ag辅助化学刻蚀半导体材料的机理、反应现象及影响因素,总结了各种微结构的制备技术及其应用。此外,对Ge,Si1-xGex和GaAs等其他半导体材料的贵金属粒子辅助化学刻蚀技术也进行了综述。同时分析了贵金属粒子辅助化学刻蚀半导体目前存在的问题,并对未来的研究方向进行了展望。     

Eu2+掺杂KCaCl3晶体的生长及发光性能

通过坩埚下降法生长出不同物质的量分数Eu²⁺掺杂的KCa_1-xEu_xCl₃(x=0.005、0.01、0.02、0.03、0.05)单晶,并对晶体进行了X射线粉末衍射、热重、透过率、光致发光光谱、衰减时间、X射线激发发射光谱等测定。通过相图及结构分析,判断出该晶体为一致熔融化合物,并得出其为正交结构,晶胞参数为a=0.75604 nm,b=1.04823 nm,c=0.72657 nm,空间群为Pnma(62)。在紫外光的激发下,晶体在434 nm左右有一个宽的发射峰,对应于Eu²⁺的4f⁶5d¹→4f⁷跃迁;光致衰减时间1.473μs,晶体在X射线激发下的发光强度随Eu²⁺离子浓度增加而增强。