Mo(d,x)95mTc,Mo(d,x)96gTc和Mo(d,x)97mTc反应的激发函数

用活化法和迭靶技术,测量了入射氘核能量从3.2到13.3MeV范围内,Mo(d,x)^95mTc,Mo(d,x)^96gTc和Mo(d,x)^97mTc反应的激发函数,并与复合核统计模型理论计算作了比较.     

高功率微波脉冲压缩储能谐振腔的测量与调试

储能谐振腔是高功率微波脉冲压缩系统实验的核心部件，精确测量有关储能腔参数，修正谐振腔尺寸，调整实验系统的微波参数，使储能阶段H—T的泄漏最小、谐振腔的储能效率达到最大是非常关键和必要的。介绍了L波段高功率微波（HPM）脉冲压缩谐振腔的微波参数的测量，并根据微波参数测量的结果对谐振腔进行了调整，使谐振腔的储能效果明显改善；分析了不同气体成分及充气气压与本征频率之间的关系及其抗击穿性，作为工作介质，SF6含量为30％-50％，SF6-N2混合气体综合性能较好的。     

在对称群Sm中解循环方程组

本文研究了在对称群S_m中解循环方程组:x_mX_(m+1)…x_(ω+k-1)σ_m,其中σ_m∈S_m,ω=1,2,…,s,确定了这个循环方程组有解的充分必要条件和解的个数,而且给出了求解过程。     

船舶典型结构损耗因子实验及应用

损耗因子是衡量系统阻尼特性并决定其振动能量耗散能力的重要参数,对船舶水下噪声预报分析具有重要影响。针对船舶结构特点,选取内底板、舱壁板和甲板等典型结构建立实验模型,基于瞬态衰减法,对船舶典型结构损耗因子进行测试,分析、掌握其特性规律。在此基础上,开展船舶典型结构损耗因子水下噪声预报应用研究,结果表明,损耗因子对船舶水下噪声预报具有较大影响,尤其高频段水下辐射噪声对损耗因子更为敏感,进行船舶水下噪声预报时需开展相关损耗因子测试。     

Preparation and tribological properties of DLC/Ti filmby pulsed laser arc deposition

This paper reports that DLC (diamond like carbon)/Ti and DLC films were prepared by using pulsed laser arc deposition. R-ray diffraction, Auger electron spectroscopy, Raman spectroscopy, atomic force microscopy, nanoindenter, spectroscopic ellipsometer, surface profiler and micro-tribometer were employed to study the structure and tribological properties of DLC/Ti and DLC films. The results show that DLC/Ti film, with $I(D)/I(G)$ 0.28 and corresponding to 76{\%} sp$^{3}$ content calculated by Raman spectroscopy, uniform chemical composition along depth direction, 98 at{\%} content of carbon, hardness 8.2 GPa and Young's modulus 110.5 GPa, compressive stress 6.579 GPa, thickness 46~nm, coefficient of friction 0.08, and critical load 95mN, exhibits excellent mechanical and tribological properties.     

基于套管-水泥环-地层热固耦合作用的多层套管环空附加压力预测模型

深水油气井生产阶段受地层高温流体的影响,会产生套管环空圈闭压力上升现象,严重威胁井筒完整性。本文推导出了基于套管-水泥环-地层热固耦合作用下的环空流体介质、自由段与封固段套管的位移函数,建立了多层套管环空附加压力矩阵方程,提出了套管环空压温比计算公式,分析了环空流体介质热弹性、套管壁厚和弹性参数、水泥环弹性参数等因素对各层套管环空附加压力分布规律的影响。结果表明:各层套管环空附加压力沿井筒上升方向逐渐增加,油层套管与生产管柱之间的A环空产生的压力附加值最大,增加环空流体压缩性、提高套管壁厚和提升水泥环弹性参数可有效降低套管环空附加压力,保障井筒安全.     

H^＋注入锗酸铋晶体表面层的性质

Ｈ＾＋注入锗酸铋（Ｂｉ４Ｇｅ３Ｏ１２或ＢＧＯ）晶体引起某些效应，如辐射损伤，光学吸收和近表层区域的晶体分解。经Ｈ＾＋注入后，ＢＧＯ晶体的颜色变成棕色，但实验中证实不了该变化是由色心的产生所引起。此外，实验中也示观察到Ｈ＾＋注入ＢＧＯ晶体中有离子束诱发的光学活性变化。可见在注入过程中，未发生从Ｂｉ４Ｇｅ３Ｏ１２转变到Ｂｉ１２ＧｅＯ２０的结构相变，由此预见，注入过程中可能发生离子束引起的晶体分解。Ｈ＾     

关于Yb~(3 )—Er~(3 )激活的上转换磷光体的效率

本文通过Er~(3 )离子激发过程的效率和最终发射过程的效率测定了Yb~(3 )—Er~(3 )激活的上转换磷光体的效率。激发过程依赖于红外激发强度。我们用不同的基质晶格,激发到选定的Er~(3 )能级,测量了发射过程的效率,而且作为Yb~(3 )和Er~(3 )浓度的函数。现在知道的最好的上转换磷光体之一,α-NaYF_4—0.20Yb—0.03Er的绿色发光效率约为6％。     

Mixed noise removal algorithm of EBAPS image under low illumination condition based on FPGA北大核心CSCD

In order to solve the problem that single median filtering and gaussian filtering algorithm is not effective in suppressing impulse noise and poisson noise simultaneously in low illumination image, and the edge detail protection is insufficient, an open and close mix-median-gaussian (OCMMG) filtering algorithm based on field programmable gate array (FPGA) was proposed. Firstly, the minimum four-direction difference was used to detect the anomaly degree of each pixel point, the weight was allocated according to the threshold of pulse noise discrimination, and the first step was filtering. Then, the four-direction edge detection algorithm was used to extract image edges, and the second step was filtered according to the set edge confidence characterization value. Finally, the images collected by electron bombarded active pixel sensor (EBAPS) under the condition of 1×10−3 lx illumination were processed by FPGA in real time. The experimental results show that the FPGA processing results are consistent with the software simulation processing results. Compared with the median filtering and gaussian filtering algorithm, the peak signal-to-noise ratio (PSNR) of the algorithm is improved by 3.23% and 16.34%, the structural similarity is improved by 14.66% and 33.86%, and the edge retention index is improved by 0.49% and 4.21%, respectively, which can effectively remove the mixed noise of EBAPS image and meet the real-time requirements. © 2022 Editorial office of Journal of Applied Optics. All rights reserved.