5-氟尿嘧啶在pH敏感型分子筛控释载体中的缓释行为

以肠溶性的羟丙基甲基纤维素邻苯二甲酸酯(HPMCP)作为包覆材料,制备了HPMCP包覆的SBA-15介孔分子筛药物控释载体(HPMCP/SBA-15),并考察了抗癌药物5-氟尿嘧啶(5-Fu)负载于控释载体后,在不同pH释放环境中的释放行为.结果表明,在模拟胃液中(pH=1.2),HPMCP能明显地延缓5-Fu的释放速度;药物释放4h后,其释放率仅为15%.而在模拟肠液中(pH=7.5)HPMCP迅速溶解,对5-Fu释放速度的影响甚微;药物释放4h后,释放率可达到80%.与此同时,包覆膜的干燥温度影响5-Fu的释放行为,干燥温度越高,药物在模拟胃液中的释放速度越慢.     

高耐甲醇性和稳定性的纳米复合阴极催化剂

报导了一种由酞菁氧钛、铂金属纳米簇和氮杂化碳纳米角结构基元组装而成的新型纳米复合电化学催化剂(TiOPc-Pt/NSWCNH)的制备、表征及电催化性能. 在TiOPc-Pt/NSWCNH催化剂中, 氮杂化碳纳米角堆积形成多孔导电网络, 铂纳粒子均匀地分散于上述多孔导电网络中, 部分铂纳粒子与TiOPc微晶直接接触. 在甲醇存在的条件下, TiOPc-Pt/NSWCNH对氧还原反应表现出高催化活性和优良的选择性与稳定性. 在甲醇浓度为0.5 mol·L^-1的高氯酸水溶液中, TiOPc-Pt/NSWCNH催化氧还原反应的起始电位比商购Pt/C-JM催化剂提高了260 mV, 其质量活性和比活性(0.85 V (参比电极为可逆氢电极(RHE)))分别为83.5 A·g^-1和0.294 mA·cm^-2, 远高于Pt/C-JM催化剂. 在含氧气氛下, 于甲醇高氯酸水溶液中, 对TiOPc-Pt/NSWCNH和TiOPc-Pt/C催化剂进行了循环伏安法加速老化实验研究(0.6-1.0 V, 15000个循环), 结果表明TiOPc-Pt/NSWCNH具有更高的稳定性. TiOPc-Pt/NCNH催化剂的高耐醇性可能得益于由TiOPc微晶向Pt纳米粒子的电子转移, 其高稳定性主要得益于氮杂化碳纳米角的高石墨化程度及纳米角堆积而成网络结构.     

R&D of an LLRF control system for a 162.5 MHz radio frequency system

This paper describes a low level radio frequency control system that was developed by the Institute of Modern Physics Chinese Academy of Sciences, and will be used in Injector of the China-ADS project. The LLRF control system consists of an RF modulated front end, fast analog-to-digital converter (ADC) modules, and a digital signal processing board based on a field programmable gate array. The system has been tested on a room temperature cavity with 12-hr, and the results illustrate that the stability of amplitude and phase achieved ±0.32% and ±0.35 degrees, respectively.     

H可积下的相依随机变量和的完全收敛性质

在满足H可积的条件下,利用随机变量的截尾方法,以及相关引理,给出了行内两两NQD序列以及p混合条件的随机组列部分和的完全收敛定理以及强大数定理．     

表面等离激元共振生物传感分析及应用

基于物理中发生在金属表面的表面等离激元现象 ,阐述表面等离激元共振生物传感分析原理 ;进而建立表面等离激元共振生物传感成像。给出应用表面等离激元共振研究生物单元相互作用的实例。     

Probing Lattice Vibrations at SiO_2/Si Surface and Interface with Nanometer Resolution

Recent advances in monochromatic aberration corrected electron microscopy make it possible to detect the lattice vibrations with both high-energy resolution and high spatial resolution. Here, we use sub-10 meV electron energy loss spectroscopy to investigate the local vibrational properties of the SiO_2/Si surface and interface. The energy of the surface mode is thickness dependent, showing a blue shift as z-thickness(parallel to the fast electron beam)of SiO_2 film increases, while the energy of the bulk mode and the interface mode keeps constant. The intensity of the surface mode is well-described by a Bessel function of the second kind. The mechanism of the observed spatially dependent vibrational behavior is discussed and compared with dielectric response theory analysis. Our nanometer scale measurements provide useful information on the bonding conditions at the surface and interface.     

双面半色调印刷品Kubelka-Munk色彩预测模型

建立双面印刷品的色彩预测模型一直是印刷中的一个重要课题。将入射到印刷品的光根据其在垂直于印刷品中所走过的路径的不同, 将其分成四大部分, 即: 从正面油墨进入, 经过纸张, 再从反面油墨出射; 从正面油墨进入, 从纸张出射; 从正面空白区域入射, 从反面油墨出射以及直接穿过纸张。所建立的相关的模型以Kubelka-Munk四能流理论为基础, 通过对上述四部分的反射率与透射率相加便得到了整个双面印刷品的反射率与透射率。     

基于多物理场模拟的阳极支撑微管燃料电池的结构优化设计

High volumetric power density (VPD) is the basis for the commercial success of micro-tubular solid oxide fuel cells (mtSOFCs). To find maximal VPD (MVPD) for anode-supported mtSOFC (as-mtSOFC), the effects of geometric parameters on VPD are analyzed and the anode thickness, t_an, and the cathode length, l_ca, are identified as the key design parameters. Thermo-fluid electrochemical models were built to examine the dependence of the electrical output on the cell parameters. The multiphysics model is validated by reproducing the experimental I-V curves with no adjustable parameters. The optimal l_ca and the corresponding MVPDs are then determined by the multiphysics model for 20 combinations of r_in, the inner tube radius, and t_an. And all these optimization are made at 1073.15 K. The results show that:(i) significant performance improvement may be achieved by geometry optimization, (ii) the seemingly high MVPD of 11 and 14 W/cm³ can be easily realized for as-mtSOFC with single-and double-terminal anode current collection, respectively. Moreover, the variation of the area specific power density with l_ca2(2 mm, 40 mm) is determined for three representative (r_in, t_an) combinations. Besides, it is demonstrated that the current output of mtSOFC with proper geometric parameters is comparable to that of planar SOFC.     

乙醇/水混合溶剂热法制备不同形貌的CuO晶体

以Cu(NO3)2·3H2O为原料,加入NaOH或NaOH+Na2CO3水溶液沉淀剂,生成Cu(OH)2或Cu2(OH)2CO3沉淀作前驱物,采用乙醇/水混合溶剂热法制备CuO.用FT-IR、XRD、SEM等方法对产物进行了表征.研究了溶剂的组成、前驱物的种类等因素对产物形貌及生成速率的影响.实验结果显示:以Cu2(OH)2CO3作前驱物,溶剂组成为V(C2H5OH):V(H2O)=1:2、150 ℃处理12 h可得形状规整的片状CuO;而以Cu(OH)2作前驱物,在相同条件下处理所得产物形貌为纺锤形.     

N,N'-二苄基乙二胺二乙酸盐的一锅法合成

以苯甲醛和乙二胺为原料,用一锅法经缩合、还原,成盐得产物N,N'-二苄基乙二胺二乙酸盐.产物通过质谱、核磁共振谱及元素分析,对其结构进行确证.与传统的方法相比产率有很大提高,而且反应条件温和,缩短了时间,简化了操作步骤.