FR4相对电容率测量实验设计

采用由微带线与射频信号源、频谱分析仪构成的简易实验装置,可准确测量出FR4介质板的相对电容率,降低了射频电路或微带天线设计实验的成本.     

SrMn0.5Fe0.5O3的自旋玻璃态和过渡金属离子价态的研究

采用固相反应法制备了SrMn_0.5Fe_0.5O₃陶瓷样品,并对样品的晶体结构,磁性和离子价态进行了系统的表征与分析. X射线衍射谱的Rietveld拟合表明样品属于理想的立方钙钛矿型结构,Mn离子和Fe离子随机占据B位的O八面体中心. X射线光电子能谱表明Mn离子为+3和+4的混合原子价态,Fe离子为+3价. 样品在大于230K的高温区域呈现Curie顺磁特性,在小于230 K的低温区域样品表现出自旋玻璃态行为,这种特性源于Mn离子和Fe离子之间的交换作用及自身价态和分布的不均匀性. 由于Fe³⁺离子占据O八面体的中心,对顺磁区的Mssbauer谱测量表现为四级分裂.     

多阵元光纤相干列阵的理论与实验研究

基于Fraunhofer衍射理论,建立了六角形相干列阵远场分布的理论模型,采用Strehl比和能量集中度作为评价参数,分析了列阵排列方式、振幅、填充因子对远场分布的影响.并由爬山法相位控制技术和六棱台合束器,构建了七阵元光纤相干列阵实验系统.在066填充因子情况下,获得了Strehl比为070、能量集中度为040七阵元合成光束,以及获得了能量集中度分别为045和018的二阵元线阵和四阵元矩形阵合成光束.     

非包覆型油井水泥自修复剂的制备与评价

采用反向悬浮聚合法,丙烯酸(AA)和丙烯酰胺(AM)为单体,过硫酸钾（KBS）作引发剂,N,N-亚甲基双丙烯酰胺(MBA)作交联剂,制备了一种非包覆遇水膨胀型自修复剂LF-1,其结构经SEM和IR表征。结果表明,LF-1分散均匀,表观形态呈多孔、粗糙褶皱状。将2%LF-1加入水泥浆中,水泥浆流动度为20.1 cm,失水52 mL,稠化时间217 min;用5000 mg/L的盐水养护造缝水泥石,12 h内即无渗透性;水泥石24 h抗压强度为16.1 MPa,抗折强度为4.92 MPa。      

尾缘凹陷轴流风轮内流特性分析与降噪研究

为减少空调室外机用低压轴流风轮叶片的颤振,改善音质,降低噪音和电机功率。本文设计了尾缘凹陷新型三叶轴流风轮,同时除对前缘局部加厚处理外,对叶片其他区域整体减薄。文中采用Navier-Stokes方程对新风轮和原风轮的内流及气动特性进行了三维数值模拟,同时对两者的流量压力曲线和噪音频谱进行了实验研究。研究表明:对轴流风轮叶片尾缘进行凹陷设计,对前缘以外的区域减薄设计,能够减轻风轮重量,降低电机负荷同时减弱转子尾迹;对叶轮前缘进行局部加厚处理可以减小叶尖颤振,降低叶片旋转频率峰值噪音,从整体上降低噪音,改善音质。     

叶型偏差对整机环境中涡轮性能的影响

叶型加工和装配的误差可能会对涡轮部件乃至发动机整机的性能产生显著的影响。本文针对某整机环境中的涡轮部件,采用数值模拟结合实验的方法,研究了涡轮叶型偏差对其气动性能的影响。结果表明:在整机环境中,叶型偏差首先导致涡轮部件气动性能的微小变化,而整台发动机的工作点随之改变,导致涡轮部件的来流条件、各级涡轮的转速和速度三角形以及其内部的流动细节均会发生明显的变化,最终叶型偏差对涡轮部件气动性能的影响被显著放大。     

Study on the pre-chopper in CSNS LEBT

Physical designing of the pre-chopper in CSNS LEBT is carried out, which includes the deflecting voltage, the length and the width of the deflecting plates, and the gap between the deflecting plates. The most outstanding feature of the design is that both the gap and the width vary with the beam envelope size. So both the requried deflecting voltage and the loaded capacitance are lowered. In order to avoid destruction of the space charge neutralization by the pre-chopper in the whole LEBT, an electron-trapping electrode is arranged to confine the electrostatic field of the pre-chopper to the local area. To examine the reliability of the pre-chopping design in CSNS LEBT, a similar pre-chopping design in ADS RFQ LEBT is set up and an experiment on the pre-chopper is prepared. 3-dimensional simulations are carried out to determine the loaded capacitance and the applied voltage of the electron-trapping electrode.     

Fast-Scale and Slow-Scale Subharmonic Oscillation of Valley Current-Mode Controlled Buck Converter

A valley current-mode （VCM） controfled buck converter with current source load （CSI） has complex phenomena of fast-scale and slow-scale subharmonic oscillations. The piecewise smooth switching model of the VCM controlled buck converter with CSI is established. It is found that attractive regions of fast-scale and slow-scale subharmonic oscillations exist in the bifurcation diagram, and two tori exist in the corresponding Poincare mapping. The research results by time-domain simulation indicate that U-type subharmonic oscillation （SO） constituted by SO and frequency-reduced subharmonic oscillation （FSO） exists in inductor current, and sine-type SO constituted by fast scale and low scale exists in output voltage respectively. Experimental results are given to verify the analysis and simulation results.     

Influence of O2 Flux on Compositions and Properties of ITO Films Deposited at Room Temperature by Direct-Current Pulse Magnetron Sputtering

Indium tin oxide （ITO） films were deposited on glass substrates at room temperature by dc pulse magnetron sputtering. Varying 02 flux, ITO films with different properties are obtained. Both x-ray diffractometer and x-ray photoelectron spectrometer are used to study the change of crystalline structures and bonding structures of ITO films, respectively. Electrical properties are measured by four-point probe measurements. The results indicate that the chemical structures and compositions of ITO films strongly depend on the O2 flux. With increasing O2 flux, ITO films display better crystallization, which could decrease the resistivity of films. On the contrary, ITO films contain less O vacancies with increasing O2 flux, which could worsen the conductive properties of films. Without any heat treatment onto the samples, the resistivity of the ITO film could reach 6.0 × 10^-4 Ω·cm, with the optimal deposition parameter of 0.2 scem O2 flux.     

Analysis of Hysteretic Strongly Nonlinearity for Quad Iced Bundle Conductors

A new hysteretic nonlinear model of quad iced bundle conductors is constructed. The bifurcation equation is obtained by applying the undetermined fundamental frequency method of the complex normal form. The transition set and bifurcation diagrams for the singularity are presented. Then the corresponding relations between the unfolding parameters and the system parameters are given, and the sensitivity parameters and its range of values are obtained to analyze and to control the galloping of the quad iced bundle conductor.