Simulation of Patterns and Qualitative Analysis of Pattern Rotation in an End-Pumped Nd：YVO4 Laser

We simulate some laser output patterns observed in our previous experiment employing superposition of Laguerre- Gaussian modes. The rotating pattern is qualitatively analysed from the point of contemporary spatial burning hole effect of the lasing crystal.     

Formation of Interfacial Layers in LaAlO3/Silicon during Film Deposition

We have studied the interracial reactions between amorphous LaAlO3 thin films and Si substrates, using high- resolution transmission electron microscopy and x-ray photoelectron spectroscopy. It has been shown that the interracial layer between LaAlO3 film and Si substrate chemical states show that the ratio of La 4d3/2 to Al 2p is SiLaxAlyOz. The depth distributions of La, Si and Al of the interfacial layer remains unchanged with the depth compared to that of the LaAlO3 film. Moreover, the Si content, in the interracial layer gradually decreases with increasing thickness of the interracial layer. These results strongly suggest that the Al element is not deficient in the interracial layer, as previously believed, and the formation of a SiLaxAlyOz interracial layer is mainly due to the diffusion of Si from the substrate during the LaAlO3 film deposition. With the understanding of the interracial layer formation, ones can control the interface characteristics to ensure the desired performances of devices using high-k oxides as gate dielectrics.     

Generation of four-photon W state via cavity QED

This paper proposes an alternative scheme for generating four-photon W state via cavity QED. The scheme bases on the resonant interaction of a A-type three level atom with two bimodal cavities. The detection of atom collapses the cavity to the desired state. Comparing with previous schemes, the advantage of this scheme is that the interaction time can be greatly shortened since it uses the resonant interaction between atom and cavities. Moreover, the proposed scheme is more experimentally feasible than the previous ones.     

良性前列腺增生组织对钛宝石激光的吸收和散射特性

研究了经尿道等离子体双极电切除术(PKRP)切除和经尿道前列腺电切术(TURP)切除的前列腺增生(BPH)组织对640, 660, 680, 700, 720, 740, 760, 780, 800, 820, 840, 860和880 nm波长的钛宝石激光的光学特性及其差异,实验采用双积分球测量系统以及反向倍增法获取BPH组织的吸收和散射特性参数。结果表明：PKRP和TURP切除的BPH组织对这1３个不同波长的激光的吸收系数和约化散射系数都是随着激光波长增大而明显减小的,PKRP切除的BPH组织对这同一波长的激光的吸收系数和约化散射系数都明显较TURP切除的BPH组织对相应的波长的激光的吸收系数和约化散射系数要小,PKRP和TURP切除的BPH组织的吸收系数以及约化散射系数的最大值都在640 nm,其值分别为(0.885±0.022)和(0.955±0.024)mm-1以及(1.564±0.039)和(1.658±0.042)mm-1,其差异分别为7.91%以及6.01%,其最小值都在880 nm,其值分别为(0.443±0.011)和(0.455±0.011)mm-1以及(1.117±0.028)和(1.197±0.030)mm-1,其差异分别为2.71%以及7.16%。PKRP和TURP切除的BPH组织对660 nm的吸收系数的差异最大,其值为8.95%,其差异最小在860 nm,其值为1.75%,PKRP和TURP切除的BPH组织对800 nm的约化散射系数的差异最大,其值为9.13%,其差异最小在640 nm,其值为6.01%。     

北京谱仪III上利用神经网络方法进行粒子鉴别的研究

本文描述了一种多层感知器的神经网络系统在BESIII粒子鉴别技术中的应用。网络按照子探测器分别进行训练, 输出结果可以作为后续网络的输入或者可以为似然函数方法构建概率密度函数。蒙特卡罗模拟样本的检验结果表明, 利用神经网络方法可以在BESIII上获得较好的粒子鉴别效果。     

应用于微电容超声换能器的信号处理电路设计*

针对微电容超声换能器的输出信号特征及检测要求,文中设计了换能器的微弱信号处理电路,包括基于跨阻的微弱电流信号检测和多重反馈带通滤波电路。通过搭建水下测试平台,对电路性能及功能进行实际测试,并进行水下测距实验。实验结果表明,该电路可对微电容超声换能器输出的400 k Hz信号进行检测放大与滤波;电路的线性度为0.18%,滤波电路中心频率为396 k Hz,带宽为55 k Hz。该电路可用于CMUT的接收信号处理并应用于超声测距及成像的前端信号处理。     

An energy sum constraint of event mixing for Bose-Einstein correlations in reactions with ππX final states around 1 GeV

We present a new event mixing technique for measuring two-pion Bose-Einstein correlations(BEC)in reactions with only two identical bosons among three final state particles.This new mixing method contains a missing mass consistency(MMC)cut and an energy sum order(ESO)cut.Unlike the previous proposed pion energy cut,which abandons nearly half the original events,the ESO cut does not eliminate any original events and hence improves the statistics of both original events and mixed events.Numerical tests using theγp→π~0π~0p events around1 Ge V are carried out to verify the validity of the ESO cut.This cut is able to reproduce the relative momentum distribution of the original events in the absence of BEC effects.In addition,its ability to observe BEC effects is tested by an event sample in the presence of BEC effects.Simulation results show the BEC effects can be observed clearly as an enhancement in the correlation function,and the BEC parameters extracted by this event mixing cut are consistent with the input BEC parameters.     

NO在Ir(111)表面吸附与解离的第一性原理研究

本文系统研究了NO在Ir(111)表面的吸附,解离,以及可能的N_2生成机理.结果表明,顶位吸附的NO,其解离能垒较高(3.17 eV),不会发生解离,而三重Hcp和Fcc空位吸附的NO发生解离,能垒分别为1.23和1.28 eV.N_2是唯一的生成物,不会有副产物N_2O的产生.其最可能的反应路径为N和NO经过N_2O中间体而生成N_2,而不是直接N提取和N-N聚合产生N_2的机理.     

分光计实验教学中的体会

分析了分光计实验教学中的难点和学生在分光计调节中经常碰到的问题,重点分析了望远镜和双面镜组成的成像系统的成像光路图像以及两像移动的规律,提出了分光计实验教学中需要指导学生运用光路知识分析具体的实验现象从而指导实验操作,对教学实践具有良好的指导意义和参考价值。     

脉管制冷机内流场与温度场的时空特性

为了进一步探究脉管制冷机内部流场与温度场的复杂时空特性,采用数值模拟方法,详细研究和分析了基本型、小孔型和双向进气型脉管制冷机的关键部件—回热器和脉管组件内流场与温度场的时空变化持性,得到了相应的时空分布图,有助于直观地理解回热器与脉管组件内热力参数的动态变化情况。与此同时,通过分析小孔阀和双向进气阀对脉管冷热端温度波动的影响规律,进一步指出:小孔阀和双向进气阀均会导致脉管冷热端的温度波动,且小孔阀造成的温度波动幅度要大于双向进气结构,因此,小孔阀是导致脉管冷热端温度不规则变化的主要因素。