若干图类的邻强边染色

研究了若干图类的邻强边染色 .利用在图中添加辅助点和边的方法 ,构造性的证明了对于完全图 Kn和路 Lm 的笛卡尔积图 Kn× Lm,有χ′as(Kn× Lm) =△ (Kn× Lm) +1 ,其中△ (Kn× Lm)和χ′as(Kn× Lm)分别表示图 Kn× Lm的最大度和邻强边色数 .同理验证了 n阶完全图 Kn的广义图 K(n,m)满足邻强边染色猜想 .     

A novel synthesis of 5-perfluorophenyl 4,5-dihydro-1H-pyrazoles in THF or water

5-Perfluorophenyl 4,5-dihydro-1H-pyrazoles were synthesized from 1,3-dipolar cycloaddition reaction of perfluorobenyl 2,4,6-triisopropylbenzenesulfonylhydrazone and α,β-unsaturated carbonyl compounds or acrylonitrile in THF or water. It was worthy to note that better results were obtained when water was employed as the solvent, which was considered as an effective, economic and environmentally friendly method to synthesize these pyrazole derivatives.     

γ-辐照对纯Y_2SiO_5和Eu~(3+)∶Y_2SiO_5晶体光谱性能的影响

研究了γ-辐照前后纯Y2SiO5和Eu3+掺杂的Y2SiO5晶体吸收光谱的变化,辐照后,未退火和氢气退火的纯Y2SiO5晶体在260~270 nm和320 nm波段产生了附加吸收峰,分别是由F心和O-心的吸收引起的;经过空气退火的纯YSO晶体中,由于消除了氧空位,因此辐照后没有出现色心吸收峰。在Eu3+∶Y2SiO5晶体中,不但有相同的F心和O-心吸收峰,而且还有Eu2+离子在300 nm和390 nm的吸收峰。随着辐照剂量的增加,色心附加吸收峰增强。空气退火能减少Eu3+∶Y2SiO5晶体中的色心,而氢气退火能增加色心。     

Yellow‐light‐emitting cyano‐substituted poly[(1,3‐phenylene vinylene)‐alt‐(1,4‐phenylene vinylene)] derivative: Its synthesis and optical properties

A soluble cyano‐substituted poly[(1,3‐phenylene vinylene)‐alt‐(1,4‐phenylene vinylene)] derivative ( 9 ) was synthesized and characterized. Comparison between 9 and its model compound ( 10 ) showed that the chromophore in 9 remained to be well defined as a result of a π‐conjugation interruption at adjacent m‐phenylene units. The attachment of a cyano substituent only at the β position of the vinylene allowed the maximum electronic impact of the cyano group on the optical properties of the poly(p‐phenylene vinylene) material. At a low temperature (?108 or ?198 °C), the vibronic structures of 9 and 10 were partially resolved. The absorption and emission spectra of a film of 9 were less temperature‐dependent than those of a film of 10 , indicating that the former had a lower tendency to aggregate. A light‐emitting diode (LED) based on 9 emitted yellow light (λ_max ≈ 578 nm) with an external quantum efficiency of 0.03%. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 3149–3158, 2003     

Determination of polymeric aluminum in soil extracted with a modified anion-exchange resin as a solid-phase adsorbent by ICP-AES.

In the present work, a new method was established by applying solid-phase extraction (SPE) to preconcentrate and separate polymeric aluminum (Al) and using ICP-AES to determine the polymeric Al, the total monomeric Al, and the total Al in soil extracts, respectively. A modified resin was prepared with impregnated 8-hydroxyquinoline-5-sulfoxinate (HQS) on the anion-exchange resin. It has good recognition ability for Al fractions, compared to the commonly used cation ion-exchange resin, which has a better ability to adsorb cations and a weak ability to recognize detailed Al species. The optimum conditions for Al fractionation sorption, elution and separation and the interference of foreign ions were studied with the prepared resin by continuous column and batch procedures. Monomeric Al was bound to Pyrocathecol Violet (PCV) at pH 6.2, whereas the polymeric Al species did not react with PCV for at least 15 min. Because a stable complex of Al-PCV was not absorbed on the HQS modified resin, the polymeric Al could be preconcentrated on-line by the HQS-modified resin. The adsorbed polymeric Al was eluted with 3 mL of 3 mol L(-1) of HCl, and then detected by ICP-AES. The method has been applied to directly determine polymeric Al in soil extracts with high selectivity as well as a high preconcentration factor. It gives a limit of detection of 0.6 ng mL(-1) with a relative standard deviation of less than 5.7% (n = 5, 0.24 microg mL(-1) Al).     

Synthesis and gas barrier characterization of poly(ethylene isophthalate)

Poly(ethylene isophthalate) (PEI) was synthesized for this research with essentially a condensation polymerization of isophthalic acid and ethylene glycol catalyzed by zinc acetate and antimony trioxide. Several samples were obtained, and their characteristics were observed and compared with poly(ethylene terephthalate) (PET). The synthesized PEI samples were chemically identified by ¹H NMR. Thermal analysis with differential scanning calorimetry (DSC) yielded results that indicate the samples were primarily amorphous, with a glass‐transition temperature of 55–60 °C. Molecular weights of these PEI samples were also obtained through intrinsic viscosity measurements (Mark–Houwink equation). Molecular weights varied with conditions of the polymerization, and the highest molecular weight achieved was 21,000 g/mol. Finally, the diffusion coefficient, solubility, and permeability of CO₂ gas in PEI were measured and found to be substantially lower than in PET, as anticipated from their isomeric chemical structures. This is because in PET the phenyl rings are substituted in the para (1,4) positions, which allows for their facile flipping, effectively permitting gases to pass through. However, the meta‐substituted phenyl rings in PEI do not permit such ring flipping, and thus PEI may be more suitable for barrier applications. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4247–4254, 2004     

The uv-Decomposition on a Class of D.C. Functions and Optimality Conditions

In this paper,the UV-theory and P-differential calculus are employed to study second-order ex-pansion of a class of D.C.functions and minimization problems.Under certain conditions,some properties ofthe U-Lagrangian,the second-order expansion of this class of functions along some trajectories are formulated.Some first and second order optimality conditions for the class of D.C.optimization problems are given.     

一类9n2次组合混合水平正交表的构造

本文利用正交表和投影矩阵的正交分解之间的关系,给出了一类9n2次组合混合水平正交表的构造方法,作为这种方法的应用,我们构造了一些新的具有较大非素数幂水平的144次混合水平正交表,并且这些正交表具有较高的饱和率.     

胶束荧光法测定维生素B_2含量

维生素B_2(核黄素)为人体内黄酶类辅基的组成部分,参与人体内的生物氧化作用。药典规定其含量测定用分光光度法,文献报道有高效液相色谱法、荧光法等。但因维生素B_2(V_(B2))遇光易分解,尤其在碱性水溶液中,极易变质。其降解产物为感光黄素,二氢核黄素,光化色素等,因此给测定的准确度和灵敏度造成一定的麻烦,为了提     

短脉冲载荷下金属材料的层裂破坏

 本文用点炮加载聚酯薄膜飞片撞击金属靶材料，飞片速度0.714~2.24 km/s，脉冲宽度40~80 ns，击靶压力为2.280~11.952 GPa。在回收的铝、铜和钢靶样品上观察到层裂现象。通过金相分析发现它们的破坏方式与在一般较长脉冲加载下的破坏方式相似，铝和铜以延性方式破坏；钢则以脆性方式破坏。一维和二维数值模拟结果表明通常的几种层裂判据在这个应力、应变和应变率范围内也基本上适用。