Solution properties of poly p-isopropyl α-methylstyrene

Two series (S and F) of poly p-isopropyl α-methylstyrene were characterized by viscometry, light scattering (LS), osmometry and gel permeation chromatography (GPC). S-samples were prepared by bulk anionic polymerization whereas F-samples were obtained on fractionation by preparative GPC of a polymer also prepared in bulk but with a different initiator. The K parameter in the Mark-Houwink relation was 5.55 × 10^?4 for series-S and 4.50 × 10^?4 for series-F, whereas the exponent a was 0.55 for both series. The Mark-Houwink equations for series-S and -F hold good at 25 and 30° for both toluene and tetrahydrofuran as solvents and have been corrected for polydispersity. The chain dimensions obtained with LS were much higher than those computed from the viscosity data indicating that the hydrodynamic theories in their present state should not be used for the calculation of chain dimensions. The deviations from the GPC universal calibration curve of polystyrene observed with some samples were attributed to structural differences among the polymers and to their high polydispersity.     

Intradiffusion coefficients in perchloric acid solutions: Water at 5°C; water and perchlorate ion at 25°C

Intradiffusion coefficients for tritiated water (³HHO) and perchlorate ion (³⁶ClO ₄ ^- ) were measured in perchloric acid solutions. At 5°C the diffusion coefficient measured for the tritiated species increases to a maximum near 1.3 mol-dm^–3. The data at 25°C have been used to calculate distinct diffusion coefficients, D _ij ^d . As a precursor for those calculations, new estimates were made of the Onsager phenomenological coefficients, l _ij . The l _ij and D _ij ^d are similar to the respective coefficients in hydrochloric acid solutions.     

Equilibrium anionic polymerization of α-methylstyrene in p-dioxane

The equilibrium anionic polymerization of α-methylstyrene in p-dioxane, with potassium as initiator, has been investigated at 5, 15, 25, and 40°C by using high-vacuum techniques. The comparison of these results with those obtained previously for the equilibrium polymerization of α-methylstyrene in tetrahydrofuran revealed that, although the values of ΔG_1c, the free-energy change upon the polymerization of 1 mole of liquid monomer to 1 bases-mole of liquid amorphous polymer of infinite chain length, are the same for both systems, there is a distinct effect of the solvent. This effect is reflected in the value of monomer equilibrium concentration and its variation with polymer concentration and is explained in terms of a solvent–monomer and solvent–polymer interaction parameter.     

Small-angle x-ray scattering studies on epoxidized butadiene-styrene block copolymers

Small-angle x-ray scattering (SAXS) and scanning electron microscopy (SEM) investigations for epoxidized butadiene-styrene (BS) block copolymers were performed. For unepoxidized copolymers, the SAXS curve exhibits a maximum which indicates that the copolymer has heterogeneity domain morphology. Using the standard theory for a two-phase system, mean distances between domains, the correlation length l _p , and the thickness of the phase boundary were calculated from the SAXS data. It was found that the epoxidation of BS copolymers decreases the ability of the copolymer to separate the individual components. As the content of the epoxide groups increases, the dimensions of the domains decrease until they disappear, the boundary between domains and the matrix becomes less and less definite, and the copolymer composes a homogeneous system. The disappearance of the two-phase structure of the BS copolymers indicates an increase in the compatibility of polystyrene and epoxidized polybutadiene. According to the method of Van Krevelen, the solubility parameters of polystyrene and epoxypolybutadiene were calculated. Small differences between these parameters support the conclusions drawn from the SAXS investigations     

High-Performance Thin-Layer Chromatographic Determination of Satranidazole in its Dosage Form

JPC – Journal of Planar Chromatography – Modern TLC - A high-performance thin-layer chromatographic method has been developed for determination of a new antiamoebic drug, satranidazole,...     

Thermal conductivity of C60 and C70 crystals

We have performed thermal conductivity measurements on C₆₀ and C₇₀ crystals grown by sublimation. For single crystal C₆₀, the thermal conductivity k is 0.4 W/m K at room temperature and is nearly temperature independent down to 260K. We observed a sharp orientational phase transition at 260K, indicated by a 25% jump in k. Below 90K, k is time dependent, which manifests itself as a shoulder-like structure at 85K. The temperature and time dependence of k below 260K can be described by a simple model which accounts for the thermally activated hopping of C₆₀ molecules between two nearly degenerate orientations, separated by an energy barrier of 240 meV. It is found that solvents have a strong influence on the physical properties of C₇₀ crystals. For solvent-free C₇₀ crystal, k is about constant above 300K. There is a broad first-order phase transition in k at 300K with a 25% jump. We associate this transition with the aligning of the fivefold axes of the C₇₀ molecules along the c-axis of the hexagonal lattice. Upon further cooling, k increases and is time independent.     

Phase transitions,ferroelectric behavior and second-order nonlinear optics of a new mixed sodium dihydrogen phosphate–arsenate

Aiming at the development of new proton conducting solids, recent studies of the NaH₂PO₄·H₂O–NaH₂AsO₄·H₂O system have lead to the synthesis of a new compound NaH₂(PO₄)_0.48(AsO₄)_0.52·H₂O (NDAP). Calorimetric studies have confirmed the presence of four reversible phase transitions (abbreviated by PhT), at 257/270 (PhT, IV), 261/290 (PhT, III), 267/301 (PhT, II) and 317/317.5 K (PhT, I) (for cooling/heating processes, respectively). It is shown that the III and IV phase transitions are of a first order type, with a “order-disorder and displacive” character, accompanied by specific dielectric anomalies. The behavior of the dielectric constant ε′_r and of tan δ shows that, at 272 K, the (PhT, IV) could be ferroelectric–paraelectric. As for the (PhT, III) at 296 K, it leads to a superionic–protonic phase; a jump in the conductivity is associated to this transition with an unusual high value of conductivity 1.07×10^?4 Ω^?1 cm^?1 and a low activation energy 0.39 eV (Kh. Jarraya et al.). Quandratic nonlinear (NLO) properties of NDAP powder was confirmed efficiency of the grown crystal by the Kurtz and Perry second harmonic generation (SHG) technique.     

Simulative analysis of co-existing 2.5 G/10 G asymmetric XG-PON system using RZ and NRZ data formats

In this paper, a fiber optic communication system has been employed using co-existing 10 G/2.5 G asymmetric gigabit passive optical network (XG-PON) architecture. In this system, bidirectional optical fiber has been used for upstream and downstream data transmission. The system performance has been investigated for non-return-to-zero (NRZ) and return-to-zero (RZ) data formats operating at varying bit rates by varying the length of the fiber for analyzing the feasibility of this co-existence. The results have been compared for NRZ and RZ formats for upstream and downstream data in terms of Q value and eye opening. It is observed that RZ modulation format is superior as compared to conventional NRZ format and the faithful transmission of signal has been carried up to 90 km at 1577 nm for downstream and 140 km at 1270 nm for upstream.