排序方式: 共有53条查询结果,搜索用时 15 毫秒
1.
2.
3.
4.
臧宏亮 叶沿林 李智焕 王建松 楼建玲 李奇特 葛愉成 杨晓菲 李晶 蒋伟 冯俊 刘强 杨彪 陈志强 刘洋 吴鸿毅 牛晨阳 李晨光 王春光 王翔 刘威 高见 余翰舟 马军兵 马朋 白真 杨彦云 金仕纶 卢飞 《中国物理C(英文版)》2018,42(7):074003-074003
An experiment for p(~(14)C,~(14)C~*→~(10)Be+α)p inelastic excitation and decay was performed in inverse kinematics at a beam energy of 25.3 Me V/u.A series of~(14)C excited states,including a new one at 18.3(1)Me V,were observed which decay to various states of the final nucleus of~(10)Be.A specially designed telescope system,installed around zero degrees,played an essential role in detecting the resonant states near theα-separation threshold.A state at 14.1(1)Me V is clearly identified,being consistent with the predicted band-head of the molecular rotational band characterized by theπ-bond linear chain configuration.Further clarification of the properties of this exotic state is suggested by using appropriate reaction tools. 相似文献
5.
In the excitation of the resonant state followed by the sequential cluster-decay,the in-plane angular correlation method is usually employed to determine the spin of the mother nucleus.However,the correlation pattern exhibited in a two-dimensional angular-correlation spectrum depends on the selected coordinate system.In particular,the parity-symmetric and axial-symmetric processes should be presented in a way to enhance the correlation pattern,whereas the non-symmetric process should be plotted separately to reduce the background.In this study,three coordinate systems previously adopted for correlation patterns in the literature are described and compared to each other.The consistency among these systems is evaluated based on the experimental data analysis for the 10.29-MeV state in ~(18) O.A spin-parity of 4~+ is obtained for all three coordinate systems. 相似文献
6.
采用紫外光接枝法对聚醚醚酮(PEEK)表面进行化学修饰和生物分子固定化.首先向PEEK表面引入亲水性的丙烯酰胺,并以此为反应位点通过戊二醛将胶原和胶原蛋白固定在PEEK表面.用接触角测定仪、扫描电镜、荧光标记和X射线光电子能谱等对改性薄膜进行了表征.结果表明,PEEK上丙烯酰胺的接枝密度高达50.9μg/cm~2;改性薄膜表面浸润性显著提高,水接触角最低降至(22±3)°.荧光标记胶原固定的PEEK薄膜荧光发射光谱强度最高,并在X射线光电子能谱中检测到N元素,表明胶原已固定化,固定胶原蛋白的浓度为10.2μg/cm~2. 相似文献
7.
8.
为研究某嵌入式计算机上电时无法启动的异常故障,根据产品架构建立硬件系统无法启动故障树,通过故障树分析法,对故障分支逐个分析,最终确定故障原因为复位二极管控制管脚准位倾斜度大于3°,在高低温环境下,二极管玻壳与打印轮之间刚性接触,产生过应力,导致器件失效.分析结论为同类计算机产品复位器件进行失效分析和焊接工艺改进提供研究... 相似文献
9.
李朋杰 李智焕 陈志强 吴鸿毅 田正阳 蒋伟 李晶 冯骏 臧宏亮 刘强 牛晨阳 杨彪 陶龙春 张允 孙晓慧 王翔 刘洋 李奇特 楼建玲 李湘庆 华辉 江栋兴 叶沿林 《原子核物理评论》2017,34(2):177-183
介绍了利用硅探测器的脉冲形状甄别进行粒子鉴别的原理。详细叙述了基于数字化方法的脉冲形状甄别的实现。采样频率和位数是数字化方法的两个重要参数。对于硅探测器信号,采用100 MS/s,12 bit的Digitizer可以满足脉冲形状甄别法对时间分辨的要求。同时对该方法粒子鉴别的特征和能量阈值做了简要的分析和对比。粒子背面入射硅探测器的所得的阈值低于正面入射的情况。例如对于氖周围的同位素,背面入射情况的阈值约为100 MeV,为正面入射情况下鉴别阈值的二分之一,相当与ΔE-E方法中ΔE探测器厚度约为60 μm情况下的阈值。最后定性讨论了硅探测器的电阻率不均匀性和沟道效应对粒子鉴别性能的影响。In this paper Pulse Shape Discrimination(PSD) for silicon detector has been briefly introduced. The emerging digital method successfully applied to detector signal processing makes digital PSD method one of the most promising particle identification methods. Sampling frequency and the number of bits are two key parameters of digital method. For silicon detector signal, adopting 100 Ms/s, 12 bit Digitizer can satisfy the time resolution requirement of PSD method. The identification characteristic and energy threshold of this method have been discussed and compared with both front injection and rear injection cases. Energy threshold with rear injection usually is much lower than that with front injection. For example, around for Neon isotope energy threshold with rear injection is about 100 MeV which is only half of the threshold with front injection, also equivalent to thickness of about 60 μm silicon detector threshold in ΔE-E method. At the end the impact of silicon detector's resistivity nonuniformity and channel effect on the identification capacity of PSD method has been discussed in detail. 相似文献
10.
芯片表面标记自动识别技术是芯片制造技术不断高速发展的要求,其中芯片表面标识主要包括厂商图标、序列号(包括英文字母及数字)等。由于自动识别技术具有极其重要的意义,一直以来,人们都对该技术的研究投入了大量的人力和物力。系统使用NI的视觉系统开发工具构建,具有开发周期短、成本低等特点。系统综合运用了锐化、滤波、细化、特征识别等多种图像处理技术,成功地实现了从芯片自动跟踪定位、图像采集到图像预处理、骨架提取以及识别等一系列功能。 相似文献