FEM study of palladium and molybdenum clusters on an alumina covered field emitter

Palladium and molybdenum polycrystalline layers (clusters) have been deposited in a stainless steel UHV system onto a layer of alumina (Al₂O₃). This layer has been prepared by high temperature oxidation of an aluminium layer. The interaction of this system with nitrogen has been investigated at room temperature by an FEM technique. Under these conditions nitrogen spillover from molybdenum to palladium has been observed.     

Alloying by high dose ion implantation of iron into magnesium and aluminium

Alloys of the systems Fe–Al (mixable over the whole concentration range) and Fe–Mg (insoluble with each other) were produced by implantation of Fe ions into Al and Mg, respectively. The implantation energy was 200 keV and the ion doses ranged from 1 × 10₁₄ to 9 × 10₁₇cm^-2The obtained implantation profiles were determined by Auger electron spectroscopy depth profiling. Maximum iron concentrations reached were up to 60 at.% for implantation into Al and 94 at.% for implantation into Mg. Phase analysis of the implanted layers was performed by conversion electron Mössbauer spectroscopy and X‐ray diffraction. For implantation into Mg, two different kinds of Mössbauer spectra were obtained: at low doses paramagnetic doublets indicating at least two different iron sites and at high doses a dominant ferromagnetic six‐line‐pattern with a small paramagnetic fraction. The X‐ray diffraction pattern concluded that in the latter case a dilated αiron lattice is formed. For implantation into Al, the Mössbauer spectra were doublet structures very similar to those obtained at amorphous Fe–Al alloys produced by rapid quenching methods. They also indicated at least two different main iron environments. For the highest implanted sample a ferromagnetic six‐line‐pattern with magnetic field values close to those of Fe₃Al appeared.     

Comparison of stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry in application to supersonic jet spectrometry

Summary A supersonic jet spectrum of 9,10-dichloroanthracene is measured by stimulated-emission-pumping fluorescence dip spectrometry and conventional fluorescence spectrometry. The performance obtained is compared for these spectrometric methods, providing same information concerned with the energy level of the ground state. The former is more preferential for measurement of a high-resolution spectrum, since the spectral resolution is determined by the linewidth of the dumping laser. On the other hand, the latter is more preferential for measurement with better sensitivity at the expense of the spectral resolution, since the fluorescence throughput can be improved by increasing the slit width of the monochromator.Dedicated to Professor Dr. Wilhelm Fresenius on the occasion of his 80th birthday     

Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

Recursive partition and amalgamation with the exponential family: Theory and applications

The theory of tree-growing (RECPAM approach) is developed for outcome variables which are distributed as the canonical exponential family. The general RECPAM approach (consisting of three steps: recursive partition, pruning and amalgamation), is reviewed. This is seen as constructing a partition with maximal information content about a parameter to be predicted, followed by simplification by the elimination of ‘negligible’ information. The measure of information is defined for an exponential family outcome as a deviance difference, and appropriate modifications of pruning and amalgamation rules are discussed. It is further shown how the proposed approach makes it possible to develop tree-growing for situations usually treated by generalized linear models (GLIM). In particular, Poisson and logistic regression can be tree-structured. Moreover, censored survival data can be treated, as in GLIM, by observing a formal equivalence of the likelihood under random censoring and an appropriate Poisson model. Three examples are given of application to Poisson, binary and censored survival data.     

关于(?)-拟微分核的连续性

Supposa that f(x) is a quasidifferentiable function, defined on S(?)R~n where S is an open set, with a -equivalent bounded quasidifferential subfam ily. Lenma I     

A STUDY OF VARIOUS BARRIERS IN ENCLOSED SOUND FIELD BY USING THE COMPUTER PROGRAM—SOFIS

In the study of the behaviors of barriers in an enclosed field, one should take into account such phenomena as sound energy reflection, absorption, scattering and diffraction. Therefore, the study is much more difficult than that in free field. In this paper, sound barriers are classified into four kinds according to their size, number and shape. Each kind of barriers is modelled by a corresponding method based on a computer program—SOFIS. The program combines the ray-tracing technique and statistical method. The impulse response and some acoustical parameters such as sound pressure level at different positions can be calculated by the program, no matter there are a certain kind of barriers in the field or the field is empty. The ray-tracing program and the algorithms for various barriers are validated by the comparison between measurement and prediction of the reverberation room and the anechoic room of the Northwestern Polytechnic University.     

激光等离子体2660紫外探针及干涉系统

成功地在六路高功率Nd玻璃激光装置上建立了2660紫外激光探针和适合紫外波段的Normaski干涉仪,首次将可见波长的连续激光应用于紫外干涉仪中靶成像调整和光路准直。利用该紫外光干涉仪,在铜柱状靶(φ500μm)上测量了厚等离子体中高达0.6n。的电子密度。