Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

Proof of a conjecture on irredundance perfect graphs

Let ir(G) and γ(G) be the irredundance number and the domination number of a graph G, respectively. A graph G is called irredundance perfect if ir(H)=γ(H), for every induced subgraph H of G. In this article we present a result which immediately implies three known conjectures on irredundance perfect graphs. © 2002 Wiley Periodicals, Inc. J Graph Theory 41: 292–306, 2002     

Gluon jets from quarkonia

A detailed analysis is made within perturbative QCD of the decays into gluon jets of P-wave and S-wave quarkonia (J^PC = 0⁺⁺, 1⁺⁺, 2⁺⁺, 1^+? and 0^?+, 1^??). For all those states we compute to leading non-trivial order in α_s the conventional fraction f(?, δ) of the jet-like hadronic final states, characterized by the back-to-back cone of half angle δ, in which all but a small fraction ? of the total energy is emitted. To the same order we give also the average values of thrust momenta and spherocity distributions.     

实验研究二维圆柱后尾流中涡脱落的有序和混沌现象

本文给出了在Re=50—400范围内二维圆柱后涡脱落的有序和混沌现象的一些初步实验结果。涡脱落由有序到混沌的转捩发生在Re=184.6—193.5之间,但是它不是通过准周期途径。在涡脱落频率与Re数的关系曲线上有两个间断。在Re=70处的间断可能对应于倾斜涡脱落模式的变化,在Re≈193.5处的第二间断对应于由有序到混沌状态的转捩。     

Black-hole horizon and metric singularity at the brane separating two sliding superfluids

An analogue of a black hole can be realized in the low-temperature laboratory. The horizon can be constructed for “relativistic” ripplons (surface waves) living on the brane. The brane is represented by the interface between two superfluid liquids, ³He-A and ³He-B, sliding along each other without friction. A similar experimental arrangement was recently used for the observation and investigation of the Kelvin-Helmholtz type of instability in superfluids [1]. The shear-flow instability in superfluids is characterized by two critical velocities. The lowest threshold measured in recent experiments [1] corresponds to the appearance of the ergoregion for ripplons. In the modified geometry, this will give rise to the black-hole event horizon in the effective metric experienced by ripplons. In the region behind the horizon, the brane vacuum is unstable due to interaction with the higher-dimensional world of bulk superfluids. The time of the development of instability can be made very long at low temperature. This will allow us to reach and investigate the second critical velocity—the proper Kelvin-Helmholtz instability threshold. The latter corresponds to the singularity inside the black hole, where the determinant of the effective metric becomes infinite.     

Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Navier-Stokes approximation and problems of the Chapman-Enskog projection for kinetic equations

The purpose of this paper is to investigate problems of the Navier-Stokes approximation to kinetic equations in terms of the so-called Chapman-Enskog projection. One considers properties of the Chapman-Enskog projection for the Cauchy problem for moment approximations of the kinetic equation and primarily the Chapman-Enskog projection for the Boltzmann-Peierls kinetic equation. The existence of the Chapman-Enskog projection for the Cauchy problem is proved for the phase space of conservative variables (phenomena of nonlinear diffusion) and for the phase space of physical variables (the second sound projection). __________ Translated from Trudy Seminara imeni I. G. Petrovskogo, No. 25, pp. 184–225, 2005.     

Conformational analysis of dipeptide‐derived polyisocyanides

The conformational properties of polymers derived from isocyanodipeptides have been investigated with a combination of model calculations, X‐ray diffraction, and circular dichroism spectroscopy. Depending on the configuration of the side chains, defined arrays of hydrogen bonds along the polymeric backbone are formed. This leads to a well‐defined conformation as, for example, expressed in the formation of lyotropic liquid‐crystalline phases and increased helical stability. Upon the disruption of the hydrogen bonds by a strong acid, a less well‐defined macromolecular conformation is observed. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 1725–1736, 2003