Mechanism of BPh3-Catalyzed N-Methylation of Amines with CO2 and Phenylsilane: Cooperative Activation of Hydrosilane

BPh₃ catalyzes the N-methylation of secondary amines and the C-methylenation (methylene-bridge formation between aromatic rings) of N,N-dimethylanilines or 1-methylindoles in the presence of CO₂ and PhSiH₃; these reactions proceed at 30–40 °C under solvent-free conditions. In contrast, B(C₆F₅)₃ shows little or no activity. ¹¹B NMR spectra suggested the generation of [HBPh₃]⁻. The detailed mechanism of the BPh₃-catalyzed N-methylation of N-methylaniline ( 1 ) with CO₂ and PhSiH₃ was studied by using DFT calculations. BPh₃ promotes the conversion of two substrates (N-methylaniline and CO₂) into a zwitterionic carbamate to give three-component species [Ph(Me)(H)N⁺CO₂⁻⋅⋅⋅BPh₃]. The carbamate and BPh₃ act as the nucleophile and Lewis acid, respectively, for the activation of PhSiH₃ to generate [HBPh₃]⁻, which is used to produce key CO₂-derived species, such as silyl formate and bis(silyl)acetal, essential for the N-methylation of 1 . DFT calculations also suggested other mechanisms involving water for the generation of [HBPh₃]⁻ species.     

Dominant modes of submerged thin cylindrical shells

The relationship between the dominant mode of the submerged thin cylindrical shell and the flexural wave velocity is investigated. The natural frequency corresponding to the vibration mode is obtained as the solution of characteristic equation of thin cylindrical shell. However, it is difficult to estimate the dominant mode, especially if two or more vibration modes are involved. To estimate the dominant mode of a thin shell in vacuo, the concept of “modified bending stiffness” has been introduced. In this paper, the concept of modified bending stiffness is extended to estimate the dominant mode of a submerged thin cylindrical shell. The dominant mode of a submerged thin cylindrical shell is theoretically discriminated from the other mode based on the smallness of the modified bending stiffness of the submerged shell. The validity of our theory is confirmed by a good agreement between theoretical and experimental results on flexural wave velocity.     

Nonrelativistic limit in the energy space for nonlinear Klein-Gordon equations

We study the nonrelativistic limit of the Cauchy problem for the nonlinear Klein-Gordon equation and prove that any finite energy solution converges to the corresponding solution of the nonlinear Schr?dinger equation in the energy space, after the infinite oscillation in time is removed. We also derive the optimal rate of convergence in . Received: 13 July 2000 / Published online: 1 February 2002     

Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

DNA-conjugated polymers for self-assembled DNA chip fabrication.

We developed two DNA-conjugated polymers, one based on polyallylamine and the other on polyacrylic acid, for use in DNA chips. A 30-mer single-stranded DNA probe and thioctic acid were covalently attached to polyallylamine as sidechains. The same single-stranded DNA and 3-(pyridyldithio)propionyl hydrazide were covalently attached to polyacrylic acid as sidechains. Both DNA-conjugated polymers could be specifically immobilized onto a gold sensor substrate by a self-assembly technique. The interactions between fully matched DNA and each DNA-conjugated polymer were investigated by surface plasmon resonance. A gold surface modified with either DNA-conjugated polymer recognized fully matched DNA much better than unmatched DNA. The hybridization selectivity and efficiency of DNA-conjugated polyallylamine was optimized by adjusting the pH so as to reduce the effects of cationic polymer sidechains. The hybridization selectivity and efficiency of DNA-conjugated polymers were higher than those of a conventional immobilized thiol-based DNA. The coating of DNA-conjugated polymers reduced nonspecific adsorption of DNA by the gold substrate. DNA-conjugated polyacrylic acid was more selective toward fully matched DNA than was DNA-conjugated polyallylamine. Therefore, DNA-conjugated polymers show promise for application in novel DNA chips.     

Design and synthesis of labeling reagents (MS probes) for highly sensitive electrospray ionization mass spectrometry and their application to the detection of carbonyl, alcohol, carboxylic acid and primary amine samples.

Novel labeling reagents, called MS probes, which possess a positively charged quaternary amine moiety and can transform a neutral analyte into a charged compound by simply mixing with the analyte and allowing the mixture to stand from several minutes to 30 min at room temperature or while heating to 50 degrees C, were designed and synthesized for the highly sensitive detection of carbonyl, alcohol, carboxylic acid and primary amine samples by electrospray ionization mass spectrometry (ESI-MS). The positively charged products can be detected with high sensitivity in an ESI-MS system, which is the most popular liquid MS instrument. All of the labeled products showed a remarkably large increase in the molecular-ion peak abundance detection sensitivity of over 500-fold at picomolar concentration levels compared to that of unlabeled analytes in an ESI-MS system. These MS probes, used together with liquid MS detection, are widely applicable as a convenient method for the highly sensitive detection of less than picomolar levels of analytes, and therefore greatly enhance the power of ESI-MS analysis.     

Simultaneous determination of serotonin and 5-hydroxyindole-3-acetic acid in human urine by automated precolumn derivatization and semi-microbore column liquid chromatography with fluorescence detection.

An improved high-performance liquid-chromatographic (HPLC) assay for the simultaneous determination of serotonin (5-HT) and 5-hydroxyindole-3-acetic acid (5-HIAA) in human urine is reported. Following the automated precolumn derivatization of urinary 5-HT and 5-HIAA with benzylamine, the derivatives are separated by isocratic elution on a reversed-phase C18 semi-microbore column, and are fluorometrically detected at an excitation wavelength of 345 nm and an emission wavelength of 480 nm. The detection limits of 5-HT and 5-HIAA are 7 and 5 nmol/l in urine (0.7 and 0.5 fmol/20-microl injection). The proposed automatic method permits a highly selective and sensitive determination of 5-HT and 5-HIAA in human urine without any sample purification.     

Classification for dimethylarsenate-decomposing bacteria using a restrict fragment length polymorphism analysis of 16S rRNA genes.

A new monitoring system for bacterial communities involving dimethylarsinic acid (DMAA) decomposition was provided by combining the MPN (Most Probable Number) method and RFLP (restriction-fragment-length polymorphism analysis). The abundance of DMAA decomposing bacteria was estimated by the MPN method using a bacterial culture medium, which included DMAA as the sole carbon source, indicating bacterial cell densities of 1700 cells/ml in Lake Kahokugata and 330 cells/ml in Lake Kibagata. After isolating the dominant bacteria using agar plates, the isolates were classified into some genotype groups by RFLP analysis using 16S rDNA sequences. Classification of the RFLP analysis indicated that 14 isolates of Lake Kahokugata were classified into 6 types, which included 2 dominant types related to genus Pseudomonas, while 8 isolates of Lake Kibagata displayed 6 types including one or two isolates. Moreover, the RFLP types were unique for each lake, suggesting that DMAA decomposing bacteria were specific for the aquatic environment related to the arsenic cycle. The activities of DMAA decomposition mostly matched with the RFLP type category of the isolates. Accordingly, combining the MPN method with the RFLP analysis will play an important role in elucidating the distributions and dynamics of the DMAA-decomposing bacterial community.