Separation of metal ions by capillary electrophoresis

A number of experimental parameters have been optimized for the separation of 26 metal ions, including alkali, alkaline earth, transition and lanthanide metal ions. Experimental parameters that were evaluated included nature of indirect-detection reagent, pH of electrolyte, concentration of complexing agent and nature of the surface of the capillary; unbonded and C₁ and C₁₈ bonded phases were studied. In addition the effect of internal diameter on linearity and signal-to-noise ratio was examined, and separation efficiency was determined for a variety of experimental conditions. Detection limits (signal-to-noise RATIO = 3) were ca. 1 μg/ml for the lanthanides, ca. 0.6 μg/ml for transition and alkaline earth ions and ca. 0.1–0.8 μg/ml for alkali metal ions. The average relative standard deviations of were 3.7, 5.1 and 2.5% on unbonded, C₁ and C₁₈ capillaries, respectively. Whereas conventional regression analysis suggested that the calibration curves were linear over the range of 1·10⁻⁵ to 4·10⁻⁴ mol/l, sensitivity plots showed that the results were actually linear to within 6% only over the range of 2.5·10⁻⁵ to 4·10⁻⁴ mol/l.     

Enhanced Environmental Degradation of Plastics

Intensive research in the last two decades on the degradation of commercial plastics has led to the development of new methods of degradation and innumerable experimental techniques to characterize the degraded products. During the period 1970–1980, there have been substantial advances in most of the important aspects of polymer degradation including that induced by heat, light, oxygen, high energy radiation, photooxidation, and biological factors; and accounts have been given at various times of the current position in most of these [1–30].     

Electron-transfer polymers. XXIX. Copolymerizability of vinylhydroquinone derivatives

Ten vinylhydroquinone and one vinyl resorcinol derivatives are compared, particularly with respect to NMR spectra and copolymerizability with styrene. They are vinylhydroquinone dimethyl ether (I), vinyl-O,O′-bis(1-ethoxyethyl)hydroquinone (II), vinylhydroquinone di(2-pentyl)ether (III), 4-vinyl resorcinol bismethoxymethyl ether (IV), 2-vinyl-5-methylhydroquinone dimethyl ether (V), 2-vinyl-5-methyl-O,O′-bis(1-ethoxyethyl)hydroquinone (VI), 2-vinyl-6-methylhydroquinone dimethyl ether (VII), 2-vinyl-5-tert-butylhydroquinone dimethyl ether (VIII), 2-vinyl-5-chlorohydroquinone dimethyl ether (IX), 2-vinyl-3,6-dimethylhydroquinone dimethyl ether (X), and 2-vinyl-3,5,6-trimethylhydroquinone dimethyl ether (XI). All the vinyl protons have almost the same coupling constants. Though subtle distinctions are found among all the spectra, they can in general be put into two groups on the basis of the chemical shifts. Let the hydrogen on carbon-1 of the vinyl group be A, the hydrogen cis to A be B the hydrogen trans to A be C, then in the first group, (I) through (IX), the chemical shifts (τ) are (A) 3.02 ± 0.08, (C) 4.41 ± 0.05, and (B) 4.87 ± 0.07, and in the second group, (X) and (XI), they are (A) 3.30 ± 0.03, (C) 4.49 ± 0.01, and (B) 4.59 ± 0.03. It is supposed that in (X) and (XI) the vinyl group is out of the plane of the ring, because of the two ortho substituents, and this conformation is reflected in the NMR data. Ultraviolet spectra are consonant with this interpretation, since the λ_max of (X) and (XI) correspond closely with those of nonvinyl reference compounds, while those of (II), (V), and (VIII) are shifted to longer wavelengths. When these compounds are copolymerized separately with styrene, the behaviors are classifiable into the following three groups, where r₁ and r₂ are monomer reactivity ratios with styrene as the first monomer: (i) r₁ < 1 and r₂ < 1 for compounds (II) and (III) and the reference compound O,O′-dibenzoylvinylhydroquinone, (ii) r₁ < 1 and r₂ > 1 for compounds (I), (V), (VII), (VIII), (IX), and (iii) r₁ > 1 and r₂ = 0 for compounds (X) and (XI). These behaviors are correlated with the effect of electronegativity of groups on the stability of the radical at the growing end of the chain and with the simultaneous effects of steric hindrance.     

A time-dependent wave packet quantum scattering study of the reaction HD+ (v = 0 - 3;j0 = 1) + He --> HeH+(HeD+) + D(H)

Time-dependent wave packet quantum scattering (TWQS) calculations are presented for HD(+) (v = 0 - 3;j(0)=1) + He collisions in the center-of-mass collision energy (E(T)) range of 0.0-2.0 eV. The present TWQS approach accounts for Coriolis coupling and uses the ab initio potential energy surface of Palmieri et al. [Mol. Phys. 98, 1839 (2000)]. For a fixed total angular momentum J, the energy dependence of reaction probabilities exhibits quantum resonance structure. The resonances are more pronounced for low J values and for the HeH(+) + D channel than for the HeD(+) + H channel and are particularly prominent near threshold. The quantum effects are no longer discernable in the integral cross sections, which compare closely to quasiclassical trajectory calculations conducted on the same potential energy surface. The integral cross sections also compare well to recent state-selected experimental values over the same reactant and translational energy range. Classical impulsive dynamics and steric arguments can account for the significant isotope effect in favor of the deuteron transfer channel observed for HD(+)(v<3) and low translational energies. At higher reactant energies, angular momentum constraints favor the proton-transfer channel, and isotopic differences in the integral cross sections are no longer significant. The integral cross sections as well as the J dependence of partial cross sections exhibit a significant alignment effect in favor of collisions with the HD(+) rotational angular momentum vector perpendicular to the Jacobi R coordinate. This effect is most pronounced for the proton-transfer channel at low vibrational and translational energies.     

Capillary electrophoresis with end-capillary potentiometric detection using a copper electrode.

Potentiometric end-capillary detection in capillary electrophoresis has the advantage of relatively easy miniaturisation without having to compromise the concentration sensitivity. Potentiometric end-capillary detection using a copper electrode is also attractive because of the sensitive detection of many inorganic and organic UV-transparent ions and the ability to work in both direct and indirect mode. In this work, detection of a number of common anions in a tartrate electrolyte at pH 3 was studied. The influence of the end-capillary detection geometry on the detection performance was investigated. An end-capillary detection cell allowing the separation capillary to be changed without the need to realign the detection electrode was constructed and fitted into a commercial CE apparatus. Under the optimal configuration, which was a 25 microm diameter copper electrode aligned coaxially with a 25 microm capillary and positioned at a distance of about 25 microm from the capillary end, excellent peak shapes were achieved and comparison with simultaneous on-capillary photometric detection showed no additional peak broadening. Good sensitivity was obtained, resulting in concentration limits of detection (LODs) in the low microM range and mass LODs in the low amol range. Examples of separations of inorganic and organic anions are presented and the analytical potential of the detection method is assessed.     

Synthesis of novel polyxanthenes from poly(arylene ether)s containing benzoyl groups

Poly(arylene ether)s ( 3 ), ( 4 ) containing pendant benzoyl groups as precursors for novel polyxanthenes ( 7 ), ( 8 ) were prepared by nucleophilic substitution reaction of 2,5-difluoro-4-benzoylbenzophenone ( 1 ) or 2,5-difluoro-4-(4-dodecylbenzoyl)-4′-dodecylbenzophenone ( 2 ) with hydroquinone derivatives in the presence of potassium carbonate in N,N-dimethylacetamide. The polycondensation proceeded smoothly at 165°C and produced poly(arylene ether)s with inherent viscosities up to 0.80 dL/g. The novel polyxanthenes were synthesized via the reduction of poly(arylene ether)s followed by the Friedel-Crafts cyclization of diol polymers. The structure of the polyxanthenes was characterized by ¹H-NMR and IR spectroscopies. Polyxanthene 8 was quite soluble in chloroform and THF. The 10% weight loss temperature of polyxanthene 7 was 510°C in nitrogen and it was 90°C higher than the corresponding poly(arylene ether) 3 . © 1997 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 35 : 2267–2272, 1997