High-performance liquid chromatographic determination of naltrexone in plasma of hemodialysis patients

A simple, sensitive, selective and reliable reversed-phase high-performance liquid chromatographic (HPLC) method with UV detection is described for the determination of naltrexone in plasma samples. Naltrexone and the internal standard, naloxone, were isolated from plasma either with a liquid-liquid extraction method using ethyl acetate or with a solid-phase extraction method using Sep-Pack C18 cartridge before chromatography. The extracts were dried under a stream of nitrogen and the samples were reconstituted in the mobile phase, then 20 microL were injected on a Waters Symmetry C18 column (5 microm particle size, 4.6 x 150 mm). The mobile phase consisted of 0.06% triethylamine (pH 2.8)-acetonitrile (92:8, v/v) pumped at 1 mL/min. The peak-area ratio versus plasma concentration was linear over the range of 10-500 ng/mL and the detection limit was less than 8 ng/mL. Quantification was by ultra-violet detection at 204 nm. The present method was applied to the determination of the plasma concentration of naltrexone in dialyzed patients. Patients (n = 8) with severe generalized pruritus received 50 mg of naltrexone orally per day for 2 weeks. The variability in the therapeutic response in treated patients required plasma concentration investigations of this opioid antagonist.     

Levels of cesium radionuclides in mosses in the eastern Black Sea area of Turkey

Moss samples collected from the eastern Black Sea about 6.5 years after the Chernobyl accident have been analyzed for radiocesium activity.¹³⁴Cs activity was also detected in all the samples beside¹³⁷Cs radionuclide. The levels of total cesium activity in the mosses proved that the coastal zone in the eastern Black Sea region was highly contaminated.     

Structures,g-tensors,and hyperfine coupling constants of L-α-alanine radicals in radiation dosimetry: An ab initio molecular dynamics simulation study

Alanine is used as a transfer standard dosimeter for gamma ray and electron beam calibration. An important factor affecting its dosimetric response is humidity which can lead to errors in absorbed dose calculations. Ab initio molecular dynamics calculations were performed to determine the environmental effects on the electron paramagnetic resonance (EPR) parameters of L-α-alanine radicals in acidic and alkaline solutions. A new result, not dissimilar to the closed-shell amino acid molecule alanine, is that the non-zwitterionic form of the alanine radical is the stable form in the gas phase while the zwitterionic neutral alanine radical is not a stable structure in the gas phase. Geometric and EPR parameters of radicals in both gas and solution phases are found to be dependent on hydrogen bonding of water molecules with the polar groups and on dynamic solvation. Calculations on the optimized free radicals in the gas phase revealed that for the neutral radical, hydrogen bonding to water molecules drives a decrease in the magnitudes of g-tensor components g _xx and g _yy without affecting neither g _zz component nor the hyperfine coupling constants (HFCCs). The transfer from the gas to solution phase of the alanine radical anion is accompanied with an increase in the spin density on the carboxylic group's oxygen atoms. However, for the neutral radical, this transfer from gas to solution phase is accompanied with the decrease in the spin density on oxygen atoms. Calculated isotropic HFCCs and g-tensor of all radicals are in good agreement with experiment in both acidic and alkaline solutions.     

Olefin epoxidation with H2O2 in the presence of Mn(II) dicarboxylate coordination polymer catalysts

Abstract  

The Mn(II) dicarboxylate coordination polymers [Mn(μ-terephthalate)(H₂O)₂] _n , [Mn(μ-oxalate)(H₂O)₂] _n , and [Mn(μ-d-(−)-tartrate)] _n were prepared in water and characterized by FT-IR spectroscopy and CHN analysis. Particles of the terephthalate catalyst were also synthesized, by reaction of terephthalic acid and MnCl₂·4H₂O by a sonochemical method. The catalytic potential of these coordination polymers as slow-release sources of catalytically active Mn species was tested in the oxidation of cyclooctene to its epoxide in acetonitrile, using hydrogen peroxide as oxygen source. For the terephthalate species the catalytic activity was found to increase with increasing dielectric constant and dipole moment of the solvent (being highest in acetonitrile), with reaction temperature to a maximum at 60 °C, and with an imidazole co-catalyst (highest activity found for a imidazole-to-catalyst molar ratio of 20:1). Good activity with more than 64% conversion in 24 h was obtained for epoxidation of cyclooctene and cyclohexene, whereas low yields only were obtained from aryl-substituted olefins. Some exo versus endo regioselectivity was found for norbornene.     

Biocompatible hydrogels based on chitosan,cellulose/starch,PVA and PEDOT:PSS with high flexibility and high mechanical strength

Fabricating mechanically strong hydrogels that can withstand the conditions in internal tissues is a challenging task. We have designed hydrogels based on multicomponent systems by combining chitosan, starch/cellulose, PVA, and PEDOT:PSS via one-pot synthesis. The starch-based hydrogels were homogeneous, while the cellulose-based hydrogels showed the presence of cellulose micro- and nanofibers. The cellulose-based hydrogels demonstrated a swelling ratio between 121 and 156%, while the starch-based hydrogels showed higher values, from 234 to 280%. Tensile tests indicated that the presence of starch in the hydrogels provided high flexibility (strain at break?>?300%), while combination with cellulose led to the formation of stiffer hydrogels (elastic moduli 3.9–6.6 MPa). The ultimate tensile strength for both types of hydrogels was similar (2.8–3.9 MPa). The adhesion and growth of human osteoblast-like SAOS-2 cells was higher on hydrogels with cellulose than on hydrogels with starch, and was higher on hydrogels with PEDOT:PSS than on hydrogels without this polymer. The metabolic activity of cells cultivated for 3 days in the hydrogel infusions indicated that no acutely toxic compounds were released. This is promising for further possible applications of these hydrogels in tissue engineering or in wound dressings.

Graphical abstract

     

High-throughput biophysical measurement of human red blood cells

This paper reports a microfluidic system for biophysical characterization of red blood cells (RBCs) at a speed of 100-150 cells s(-1). Electrical impedance measurement is made when single RBCs flow through a constriction channel that is marginally smaller than RBCs' diameters. The multiple parameters quantified as mechanical and electrical signatures of each RBC include transit time, impedance amplitude ratio, and impedance phase increase. Histograms, compiled from 84,073 adult RBCs (from 5 adult blood samples) and 82,253 neonatal RBCs (from 5 newborn blood samples), reveal different biophysical properties across samples and between the adult and neonatal RBC populations. In comparison with previously reported microfluidic devices for single RBC biophysical measurement, this system has a higher throughput, higher signal to noise ratio, and the capability of performing multi-parameter measurements.     

Modification of the Scaled Particle Theory for Solubility of Non-Polar Gases in Water

In this work based on the modified scaled particle theory (SPT), the solubility of non-polar gases (He, Ar, N₂, H₂, O₂, CO₂ and CH₄) in water has been studied over a wide range of temperatures. Calculations of Henry’s law constant by the SPT are related to the inherent physical properties and parameters of solvent and solute, all of which are considered temperature dependent. The temperature dependence of molar volume and hard sphere diameter of solvent and polarizability of solute have the most significant effects on the solubilities of gases in water. The average relative deviation is less than 3 %. Also, the effect of different mixing rules in the application of SPT to prediction of gas solubility has been studied.