Aromatic polyether, -ketone, -sulfones as laminating resins. XII. Derivatives of 2,2′-diphenylethynyldiphenyl which cure by an intramolecular cyclization

Polymers made from 2,2′-diiododiphenyl-4,4′-dicarbonyl dichloride, diphenyl ether, and isophthaloyl chloride have been made and converted to the 2,2′-diphenylethynyl derivatives. Introduction of units of isophthaloyl chloride reduced the melting point of these polymers to about 200°C, and they could then be cured by heating. A good glass laminate was prepared and cured from one of the polymers.     

Effect of Erosive Agents on Surface Characteristics of Nano-Fluorapatite Ceramic: An In-Vitro Study

Erosive beverages cause dissolution of natural teeth and intra-oral restorations, resulting in surface characteristic changes, particularly roughness and degradation. The purpose of this study was to evaluate the surface roughness and topography of a dental ceramic following immersion in locally available erosive solutions. A total of 160 disc specimens of a nano-fluorapatite type ceramic (12 mm diameter and 2 mm thickness) were fabricated and equally distributed into two groups (n = 80) and then evenly distributed among the following five testing groups (n = 16): lemon juice, citrate buffer solution, 4% acetic acid, soft cola drink, and distilled water which served as a control. The surface roughness (Ra) and topography were evaluated using a profilometer and scanning electron microscope at baseline, 24 h, 96 h, and 168 h respectively. Data were analyzed using ANOVA and Tukey’s multiple comparisons (p ≤ 0.05). Surface changes were observed upon exposure to all acidic beverages except distilled water. Amongst all immersion media, 4% acetic acid produced the most severe surface roughness across all time periods (i.e., baseline, 24 h, 96 h, and 168 h). A statistically significant difference in the surface roughness values between all immersion media and across all four time intervals was observed. Erosive agents had a negative effect on the surface roughness and topography of the tested ceramic. The surface roughness increased with increased storage time intervals.     

Preparation and characterization of polyphosphotungstate/ZrO2 nanocomposite and their sonocatalytic and photocatalytic activity under UV light illumination

Polyoxometalates (POM) supported on zirconia, H₃PW₁₂O₄₀/ZrO_2, were prepared by incorporating polyphosphotungstate into a zirconia matrix via sol-gel technique that involving the hydrolysis of zirconium (IV) n-butoxide, Zr (n-OBu)₄, as the ZrO₂ source. This insoluble and readily separable catalyst was characterized by using XRD, FT-IR, SEM, and UV diffuse reflectance spectroscopy (UV-DRS), indicating that the polyphosphotungstate was chemically attached to the zirconia supports, and primary Keggin structure remained intact. The photocatalytic and sonocatalytic activity of the supported polyphosphotungstate was tested via degradation of different dyes in aqueous solutions. The POM-ZrO₂ nanocomposite showed higher photocatalytic and sonocatalytic activity than pure polyoxometalate or pure ZrO₂.     

Synthesis,characterization and crystal structure analysis of a novel oxo-centered mixed-metal complex containing unsaturated bridging carboxylates

A novel oxo-centered trinuclear mixed-metal carboxylate complex with unsaturated bridging ligands [Fe₂Cr(μ₃-O)(C₃H₃O₂)₆(H₂O)₃]·NO₃·4H₂O has been synthesized and characterized by means of Elemental analyses, Infrared spectroscopy and Crystal structure analysis. The compound crystallizes isotypically in the monoclinic space group type P2₁/c. In the compound, each M^(III) cation is coordinated by six O atoms from four unsaturated carboxylate groups as bridging ligands, one water molecule as the terminal ligand, and a μ₃-oxygen atom in the center of an equilateral triangle. The infrared spectra show resolved bands arising from ν_asym(COO) and ν_sym(COO) vibration of bridging carboxylate ligands along with those of ν_asym(M₂M′O) vibration in the complex. The difference between symmetrical and asymmetrical (COO) ligands indicate that the acrylate bridge is present in the structure of complex.      

Simultaneous voltammetric sensing of acetaminophen,epinephrine and melatonin using a carbon paste electrode modified with zinc ferrite nanoparticles

A highly selective electrochemical sensor was fabricated based on a modified carbon paste electrode with zinc ferrite nanoparticles (ZnFe₂O₄ NPs). The nanocomposite has attractive properties such as high surface-to-volume ratio and good electrocatalytic activity towards the drugs acetaminophen (AC), epinephrine (EP), and melatonin (MT), best at working voltages of 0.35, 0.09 and 0.55 V (vs. Ag/AgCl), respectively. The linear ranges (and detection limits) are 6.5–135 (0.4) μmol L^?1 for AC, 5–100 (0.7) μmol L^?1 for EP, and 6.5–145 (3) μmol L^?1 for MT.

Open image in new window

Graphical abstract A novel electrochemical sensor based on a modified carbon paste electrode with zinc ferrite nanoparticles (ZnFe₂O₄) for the simultaneous detection of the acetaminophen, epinephrine and melatonin was fabricated

     

Evaluation of polypyrrole/silver/polyethylene glycol nanocomposite sorbent for electroenhanced direct-immersion solid-phase microextraction of carvacrol and thymol from medicinal plants

The unique features of nanostructured polypyrrole, conductivity enhancement effect of silver nanoparticles and high polar adsorptivity of polyethylene glycol were merged into polypyrrole/silver/polyethylene glycol (PPy/Ag/PEG) nanocomposite. It was synthesized and simultaneously coated on the surface of a stainless-steel fiber using an amended electropolymerization procedure. Before coating, the fiber substrate was made porous and sticky by allocating platinum dots on the surface of the stainless-steel fiber using the electrophoretic method. The prepared fiber was applied for the extraction of carvacrol and thymol (the most important antioxidants in medicinal plants) through an electroenhanced direct-immersion solid-phase microextraction (EE-DI-SPME) sampling strategy, followed by GC-FID quantification. To achieve the best efficiency, the effectual experimental variables including pH of sample solution, applied voltage, extraction temperature and time, stirring rate, and ionic strength were investigated. Under the optimal experimental conditions, the calibration curves were linear over the range of 0.5–30 µg mL^?1 for thymol and 0.01–30 µg mL^?1 for carvacrol. The detection limits (3S_b) and relative standard deviation (RSD%, n?=?6) were obtained to be 0.15, 0.003 µg mL^?1 and 10.2, 8.7% for thymol and carvacrol, respectively. The results demonstrated the priority of the proposed fiber compared with polypyrrole and polyacrylate fibers, in terms of extraction efficiency, durability and stability. The developed method was successfully employed for the analysis of thymol and carvacrol in medicinal plants.     

Electrochemical determination of naproxen in the presence of acetaminophen using a carbon paste electrode modified with activated carbon nanoparticles

In this study, cyclic voltammetry and differential pulse voltammetry were used to determine the electrochemical properties and concentration of naproxen in pharmaceutical formulation and human serum samples by using a carbon paste electrode modified with activated carbon nanoparticles. Optimum conditions were obtained at an electrode with 0.005 g activated carbon nanoparticles in a phosphate buffer solution of pH 6 as a supporting electrolyte. Linear calibration curves were obtained in the range of 0.1–120 μM, and the detection limit of naproxen determined was 0.0234 μM. The modified electrode shows good selectivity for naproxen in the presence of some organic and inorganic interferences and very good precision in real samples. Finally, naproxen was measured in the presence of acetaminophen.     

Magnetic Field-Assisted Direct Immersion SPME of Endogenous Aldehydes in Human Urine

Direct immersion solid-phase microextraction (DI-SPME) is an effective microsampling strategy for polar and ionic species in aqueous media. Nevertheless, the fiber coating is in direct contact with sample solution and affected by its conditions. To compensate this limitation and to improve the extraction efficiency, a magnetic fiber coating was prepared and employed for DI-SPME sampling under the enhancing effect of a magnetic field. Magnetic iron oxide core–shell silica nanoparticles were synthesized and embedded in polypyrrole using an in situ electropolymerization method along with simultaneous coating on the surface of a platinized stainless-steel fiber. It was then applied for magnetic-assisted DI-SPME (MA-DI-SPME) sampling of endogenous aldehydes in human urine. Sample solution pH, the magnetic field intensity, ionic strength and extraction time were evaluated as the important affecting variables. Limits of detection were obtained 0.01–0.1 ng mL^?1; the calibration graphs were linear over the range of 0.1–10000 ng mL^?1. The inter-fiber (fiber-to-fiber) reproducibility was found to be 10.7–12.5%. Matrix effect from urine samples was not observed at concentration levels of 0.2, 2, and 8 µg mL^?1. The results showed that magnetic field increased the efficiency of DI-SPME method about two to four times. The developed strategy was successfully applied for the extraction and quantification of hexanal and heptanal (as the most important aldehyde biomarkers) in urine samples.

Graphical Abstract

Open image in new window

     

Synthesis of a new Pt(II) complex containing valganciclovir drug and calf-thymus DNA interaction study using multispectroscopic methods

A new complex, [Pt(valcyte)(DMSO)Cl]Cl, in which valcyte (trade name) served as valganciclovir hydrochloride drug ([2-[(2-amino-6-oxo-3H-purin-9-yl)methoxy]-3-hydroxypropyl](2S)-2-amino-3-methylbutanoate), was synthesized and characterized by different physicochemical methods. Binding interaction of this complex with calf-thymus DNA (ct-DNA) has been investigated by multispectroscopic techniques. The complex displays significant binding properties with ct-DNA. The results of fluorescence and UV–vis absorption spectroscopy indicated that this complex interacted with ct-DNA in a groove-binding mode, and the binding constant was 3.8 × 10⁴ M^?1. Furthermore, the complex induced detectable changes in the CD spectrum of ct-DNA and slightly changed its viscosity which verified the groove-binding mode. Finally, all results indicated that Pt(II) complex interact with DNA via groove-binding mode.     

Identification of PET radiometabolites by cytochrome P450, UHPLC/Q-ToF-MS and fast radio-LC: applied to the PET radioligands [11C]flumazenil, [18F]FE-PE2I, and [11C]PBR28

A general method is presented for the identification of radiometabolites in plasma of human and monkey subjects after administration of positron emission tomography (PET) radioligands. The radiometabolites are first produced in vitro, using liver microsomes, subsequently separated using fast radio-liquid chromatography (radio-LC), and individually collected and identified by ultra high-performance liquid chromatography/quadrupole-time of flight-mass spectrometry in MS and MS^E mode. Fast radio-LC provided superior resolution compared to conventional radio-LC, resulting in separation of a greater number of metabolites. The radiometabolites produced in vivo are then compared to and identified based on the in vitro results. This approach was applied to three PET radioligands, [¹¹C]flumazenil, [¹⁸F]FE-PE2I, and [¹¹C]PBR28, resulting in the identification of five, two, and one radiometabolites, respectively. This procedure can easily be adopted to identify the radiometabolites produced in vivo from a variety of PET radioligands.