Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

实验研究二维圆柱后尾流中涡脱落的有序和混沌现象

本文给出了在Re=50—400范围内二维圆柱后涡脱落的有序和混沌现象的一些初步实验结果。涡脱落由有序到混沌的转捩发生在Re=184.6—193.5之间,但是它不是通过准周期途径。在涡脱落频率与Re数的关系曲线上有两个间断。在Re=70处的间断可能对应于倾斜涡脱落模式的变化,在Re≈193.5处的第二间断对应于由有序到混沌状态的转捩。     

Wechselnde Bindungen in einem Zweikörpersystem mit trockener Reibung

Übersicht Betrachtet wird ein zwangserregtes Zweikörpersystem mit wechselnden Bindungen infolge trockener Reibung. Stationäre Bewegungen werden als Grenzfall instationärer Einschwingvorgänge berechnet. Abhängig von den Systemparametern ergeben sich drei typische Bewegungsformen. Ihnen entsprechen dauernde Haftzustände, wechselnde Haft-Gleitzustände oder dauernde Gleitzustände an der Berührfläche beider Körper.

---

Intermittant constraints in a two-body-system with dry friction

Summary An externally excited two-body-system with intermittant constraints due to dry friction is considered. Stationary motions are calculated as limit cases of instationary transients. Depending on the parameters of the system, three typical modes are of interest. These correspond to permanent sticking, slipstick behaviour, or to permanent slipping in the contact surface of the bodies, respectively.

     

Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.     

Conformational analysis of dipeptide‐derived polyisocyanides

The conformational properties of polymers derived from isocyanodipeptides have been investigated with a combination of model calculations, X‐ray diffraction, and circular dichroism spectroscopy. Depending on the configuration of the side chains, defined arrays of hydrogen bonds along the polymeric backbone are formed. This leads to a well‐defined conformation as, for example, expressed in the formation of lyotropic liquid‐crystalline phases and increased helical stability. Upon the disruption of the hydrogen bonds by a strong acid, a less well‐defined macromolecular conformation is observed. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 1725–1736, 2003     

Ein Verfahren zur Trennung des Zinks von allen Metallen seiner Gruppe

Ohne Zusammenfassung     

Naphthyl azomesogens with lateral chloro groups

A homologous series of azomesogens, 2″-[4-(4′-n-alkoxybenzoyloxy)-2-chlorophenylazo] naphthalenes, with lateral chloro groups was synthesised. All the homologues synthesized exhibit enantiotropic nematic mesophase. The mesomorphic properties of the present series are compared with other structurally related series to evaluate the effect of lateral chloro group and its position on mesomorphism This paper was presented at the 10th National Conference on Liquid Crystals held at Bangalore, India during 9–11 October 2003.     

Cochran's statistical theorem for outer inverses of matrices and matrix quadratic forms

We extend the matrix version of Cochran's statistical theorem to outer inverses of a matrix. As applications, we investigate the Wishartness and independence of matrix quadratic forms for Kronecker product covariance structures.