乌桕类可可脂结晶过程中表现体积变化

为了解乌桕类可可脂(CTCBE)缓冷结晶横向胀罐爆裂原因，研究CTCBE结晶过程中的膨胀特性，采用流体静力法测试了不同等温结晶条件下CTCBE结晶形成的表观密度和表观体积及其横纵向膨胀状况。结果表明，CTCBE缓冷结晶后形成外部和中部两个晶区。在5-25℃的各等温结晶范围内，当结晶温度增加时，外部结晶区域减小、表观密度变化不大；中部结晶区域增大、表观密度明显减小，CTCBE的表观体积、横向、纵向膨胀率均增大，膨胀横向大于纵向。进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。为有效防止横向胀罐，自然缓冷固化温度应低于10℃。     

单光子态的产生与测量

报道了通过自发参量下转换产生单光子态的实验研究,使用中心波长425 nm的飞秒脉冲泵浦Ⅰ类非共线相位匹配的BBO晶体,在实验上得到单光子计数率为2.978×10-4,并分析了实验中的相关问题.     

Dispersion and distribution of organically modified montmorillonite in nylon‐66 matrix

Nylon‐66 nanocomposites were prepared by melt‐compounding nylon‐66 with an alkyl ammonium surfactant pretreated montmorillonite (MMT). The thermal stability of the organic MMT powders was measured by thermogravimetric analysis. The decomposition of the surfactant on the MMT occurred from 200 to 500 °C. The low onset decomposition temperature of the organic MMT is one shortcoming when it is used to prepare polymer nanocomposites at high melt‐compounding temperatures. To provide greater property enhancement and better thermal stability of the polymer/MMT nanocomposites, it is necessary to develop MMT modified with more thermally stable surfactants. The dispersion and spatial distribution of the organic MMT layers in the nylon‐66 matrix were characterized by X‐ray diffraction. The organic MMT layers were exfoliated but not randomly dispersed in the nylon‐66 matrix. A model was proposed to describe the spatial distribution of the organic MMT layers in an injection‐molded rectangular bar of nylon‐66/organic MMT nanocomposites. Most organic MMT layers were oriented in the injection‐molding direction. Layers near the four surfaces of the bar were parallel to their corresponding surfaces; whereas those in the bulk differed from the near‐surface layers and rotated themselves about the injection‐molding direction. The influence of the spatial distribution of the organic MMT on crystallization of nylon‐66 was also investigated. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1234–1243, 2003     

Crystallographic report: Bis(norfloxacin)dilead(II) tetranitrate, [Pb2(H‐Norf)2(ONO2)4]

The centrosymmetric binuclear structure of [Pb₂(H‐Norf)₂(ONO₂)₄]shows the geometry around each lead(II) atom to be distorted trigonal bipyramidal with Pb–O distances ranging from 2.357(3) to 2.769(4) Å. Copyright © 2003 John Wiley & Sons, Ltd.     

Magnetic resonance imaging and pulsed Doppler sonography of poststenotic jets: Correlation between signal void and flow velocity distribution

To correlate the appearance of poststenotic jets on gradient echo images with features of localized Doppler spectra of the jets, we studied an in vitro model of steady flow-through stenoses of 86, 96, and 99% area reduction. As fluids, water and a 40% glycerol solution in water were used. MRI was performed with a 1.5 T whole body imager and gradient echo images were obtained in planes parallel to the direction of flow. Doppler spectra were acquired separately from the MR measurements at 1 cm intervals for a distance of 10 cm downstream from the stenosis. Poststenotic signal void was observed for water and for the 40% glycerol solution only if the mean velocity within the stenosis exceeded a limit of 50–60 cm/sec. On the MR images, the jets could be divided into two segments: A proximal jet segment of uniform width equal to the diameter of the stenosis, followed by a distal jet segment which was characterized by broadening and then dissipating signal void. Except for the 99% stenosis, a high signal intensity core was present within the proximal jet segment. In the proximal jet segment, the Doppler measurements showed a low temporal fluctuation of the maximal flow velocity and only little flow opposite to the main flow direction. In the distal jet segment, the velocity fluctuation and the intensity of reverse flow increased sharply. The high signal intensity core of the jet was associated with a poststenotic zone of constant maximal flow velocity. The results demonstrate a close relationship between characteristic features of poststenotic jets in MRI and pulsed Doppler sonography.     

等厚双层涂层材料受集中力作用的平面问题理论解

界面应力的正确评价是分析薄膜涂层材料力学特性的难题之一。利用镜像点法和Dirichlet等值性原理，本文推导了等厚双层薄膜涂层材料受表面集中力作用的平面问题理论解。该显式理论解是以固定在各镜像点上的局部坐标系下的Goursat应力函数的形式给出的。对应于高阶镜像点的应力函数，可通过递推的方法，从对应于低阶镜像点的应力函数求得，而且也易于计算机编程。随着镜像点阶数的增大，它与界面的距离也越来越大，因而相对应的应力函数对界面应力的影响越来越小。最后的算例表明，只需考虑前面有限个镜像点，便可获得足够精度的解。该理论解可作为格林函数，以求解复杂问题的理论解，也可用作边界元法的基本解，提高数值计算的精度和效率。     

人工神经网络X射线荧光光谱法测定钢中酸溶铝

建立了一种人工神经网络-X射线荧光光谱法测定钢中酸溶铝的方法，用X射线荧光光谱法测定低合金钢中总铝值，应用所建立的ANN-BP网络模型，输入总铝含量直接预测出酸溶铝含量。同时使用改进的BP算法，避免了神经网络学习中可能产生的麻痹现象。该方法用于钢中酸溶铝的测定，结果满意。     

氮杂冠醚研究Ⅶ、双仲胺型氮杂冠醚对过渡金属离子的选择性萃取作用

合成了五种新型双仲胺型氦杂冠醚，研究了它们对过渡金属离子进行液—液萃取，并用原子吸收法测定其浓度。实验结果表明：这类冠醚对Ａｇ￣＋、Ｐｄ￣（２＋）、和Ｐｔ￣（４＋）等贵金属离子有较强的选择配位性能，对选择性分离这些金属离子有重要的意义。     

First Total Synthesis of A New 5-Deoxyflavone

A novel 5-deoxyflavone compound, 7, 8-dimethoxy-3′, 4′-methylene-dioxyflavone (1), was in 2002 isolated from the root bark of Albizia Odoratissima. [1] The compound 1 was preparaed from pyrogallic acid (2) and piperonal(5) in four steps (Scheme 1). [2] The spectroscopic data (1H NMR, 13C NMR, MS and IR) of 1 were in good agreement with those of natural product. [ 1]     

THE STRUCTURAL BASIS OF THE POOR FIBRIN SPECIFICITY OF UROKINASE(Ⅰ)——KNOWLEDGE-BASED PREDICTION OF KRINGLE STRUCTURES OF UROKINASE AND ITS RELATED PROTEINS

The Kringle-1 structure of plasminogen (PGK-1), the Kringle-2 structure of tissue plasminogen activator (PAK-2) and the Kringle structure of prourokinase (UKK) has been modeled on the basis of the three-dimensional structure of Kringle-1 of prothrombin (PTK-1) at 2.8 resolution. The predicted three-dimensional structure of these Kringles shows that the binding site of PGK-1 is characterized by an apparent dipolar site, the polar parts of which are separated by a hydrophobic region. PAK-2 possesses the anionic center but has not a cationic binding center which might be provided by a guanidinium group from Arg-69 located adjacent to the Arg-71 position. UKK possesses neither the anionic binding center nor the cationic center which are probably the main reason for the poor fibrin specificity of urokinase.