Vinyl copolymers containing pendant 1,4‐distyrylbenzene and 1,3,4‐oxadiazole chromophores: Preparation and optoelectronic properties

We prepared two vinyl copolymers P1 and P2 containing pendant distyrylbenzene and aromatic 1,3,4‐oxadiazole derivatives, respectively, from their precursor poly(styrene‐ran‐4‐vinylbenzyl chloride) (M_w = 11,400, PDI = 1.18), which had been prepared by the controlled radical polymerization (RAFT). Two main chain polymers containing similar isolated distyrylbenzene ( P3) and aromatic 1,3,4‐oxadiazole ( P4 ) chromophores were also synthesized for comparative study. The resulted copolymers ( P1 – P4 ) are soluble in common organic solvents and are basically amorphous materials with 5% weight‐loss temperature higher than 360 °C. The PL spectral results reveal that the architecture of P1 prevents the formation of inter‐ or intramolecular interaction. The HOMO and LUMO levels of P2 , estimated from cyclic voltammetric data, are ?5.96 and ?3.81 eV, respectively, which are much lower than those of P1 (?5.12 and ?3.11 eV). The emission of blend from P1 and P2 are contributed mainly from distyrylbenzene fluorophore (～450 nm) owing to efficient energy transfer. Moreover, the blend exhibits three kinds of redox behavior depending on their weight ratios. The luminance and current efficiency of the EL device lpar;ITO/PEDOT/ MEH ‐ PPV + P2 /Al) are 503 cd/m² and 0.11 cd/A, which can be improved to 1285 cd/m² and 0.44 cd/A, respectively, as the weight ratio of P2 increases from 0 to 20%. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5362–5377, 2006     

Radiation Effects on Concentrated Potassium Hexacyanoferrate(III) Solutions

The neutron irradiated potassium hexacyanoferrate(III) solutions were analyzed for Fe(CN)₆^4?, Fe(CN)₆^3?, and Prussian blue. The retention values (1.1%) were constant throughout the pH and concentration ranges studied, and did not change with the length of irradiation. The complex behavior of the radiochemical yield of the Fe(CN)₆^4? and Prussian blue was attributed to the competition of the various reactions involved in the irradiation.     

Speciation of V, Cr and Fe by capillary electrophoresis-bandpass reaction cell inductively coupled plasma mass spectrometry

Capillary electrophoresis-dynamic reaction cell inductively coupled plasma mass spectrometry (CE-DRC-ICP-MS) for the speciation of iron(III/II), vanadium(V/IV) and chromium(VI/III) is described. Two different CE migration modes were employed for separating the six metal ions using pre-capillary complexation. One is counter-electroosmotic mode in which iron(III/II) and vanadium(V/IV) ions were well separated using a 60 cm x 75 microm i.d. fused silica capillary. The voltage was set at +22 kV and a 15 mmol l(-1) tris(hydroxymethyl)aminomethane (Tris) buffer (pH 8.75) containing 0.5 mmol l(-1) ethylenediaminetetraacetic acid (EDTA) and 0.5 mmol l(-1) ortho-phenanthroline (phen) was used as the electrophoretic buffer. The other is co-electroosmotic mode in which chromium(VI/III) ions were well separated while the applied voltage was set at -22 kV and a 10 mmol l(-1) ammonium citrate buffer (pH 7.7) containing 0.5 mmol l(-1) diethylenetriaminepentaacetic acid (DTPA) and 0.01% polybrene was used as the electrophoretic buffer. The mass spectra were measured at m/z 51, 52 and 56 for V. Cr and Fe, respectively. The interfering polyatomic ions of 35Cl16O+, 40Ar12C+ and 40Ar16O+ on 51V+, 52Cr+ and 56Fe+ determination were reduced in intensity significantly by using NH3 as the reaction cell gas in the DRC. The detection limits were in the range of 0.1-0.5, 0.4-1.3 and 1.2-1.7 ng ml(-1) for V, Cr and Fe, respectively. Applications of the method for the speciation of V, Cr and Fe in wastewater were demonstrated. The recoveries were in the range of 92-120% for various species.     

Determination of mercury in human urine by neutron activation analysis,with lead diethyldithiocarbamate as a preconcentration agent

Lead diethyldithiocarbamate is an effective reagent for preconcentration of mercury in urine for neutron activation analysis. Sodium and bromine are removed from the sample by this procedure. As lead diethyldithiocarbamate is insensitive to neutron activation, radiochemical separation is not needed after neutron irradiation. Results from the analysis of urine collected from workers in caustic soda manufacturing plants are discussed.     

Electron Paramagnetic Resonance Study of Radical Pairs and Isolated Radicals Trapped in Irradiated Long-Chain Hydrocarbons at Low Temperatures

The intrinsic characteristics of radical pairs produced in squalane and in cetane receiving high gamma-dose are extensively studied with the EPR technique at temperatures from 77°K up to 150°K. The spectra of the paired radicals occur at g=4 with a very low transition probability in contrast to that of isolated radicals which appear at g=2 A well-resolved hyperfine spectrum corresponding to the species (CH₃CH₂.CH₂CH₃) is observed in cetane. The isothermal decay rates of radical pairs in cetane below 100°K are significantly slow; however, the decay kinetics at 150°K is first order with rate constant=1.86 min^?1. A relatively slower decay rate is obtained for isolated radicals suggesting that the decay mechanism of paired radicals is through geminate recombination. The relative inter-radical distance in radical pairs is known from a decay curve as a function of temperature. The yields of radical pairs are low in both matrices, only few percents of those of isolated radicals. The formation mechanisms of paired radicals with direct radiolytic bond scission process are discussed in connection with the experimental observations.     

Effects of Different Extraction Methods on Vanilla Aroma

To establish the analytic conditions for examining the aroma quality of vanilla pods, we compared different extraction methods and identified a suitable option. We utilized headspace solid-phase microextraction (HS-SPME), steam distillation (SD), simultaneous steam distillation (SDE) and alcoholic extraction combined with gas chromatography (GC) and gas chromatography–mass spectrometry (GC-MS) to identify volatile components of vanilla pods. A total of 84 volatile compounds were identified in this experiment, of which SDE could identify the most volatile compounds, with a total of 51 species, followed by HS-SPME, with a total of 28 species. Ten volatile compounds were identified by extraction with a minimum of 35% alcohol. HS-SPME extraction provided the highest total aroma peak areas, and the peak areas of aldehydes, furans, alcohols, monoterpenes and phenols compounds were several times higher than those of the other extraction methods. The results showed that the two technologies, SDE and HS-SPME, could be used together to facilitate analysis of vanilla pod aroma.     

Photochemical Reactions of Carbohydrate Triflates

Abstract

The photochemical reactions of eight carbohydrate trifluoromethanesulfonates (triflates) have been investigated in methanol in the presence of potassium iodide. For those compounds which do not contain an aromatic chromophore, photolysis results in two types of reaction. One type produces deoxy sugars by replacement of the trifluoromethylsulfonyloxy (triflyloxy) group with a hydrogen atom. The second type of reaction generates partially protected sugars by replacement of the trifluoromethylsulfonyl (triflyl) group with a hydrogen atom. When the triflate being irradiated also has a protecting group containing an aromatic ring (i.e., benzyl, benzoyl, or p-tolylsulfonyl group), removal of the protecting group is the exclusive reaction pathway.