三磷酸胞苷在Duolite A-30树脂上的交换过程研究

根据CTP在离子交换树脂上的吸附容量和分离因数的大小,确定Duolite A-30树脂适合CTP与CDP,CMP之间的分离.对CTP在Duolite A-30树脂上的吸附动力学和热力学研究表明,在283.15K~303.15K之间,CTP的质量浓度在7.5g/L以上时,Duolite A-30树脂对CTP的吸附主要受颗粒扩散的控制,其有效扩散系数为D=3.47×10-7cm2/s,溶液的质量浓度≤1.0g/L时,CTP与Duolite A-30树脂之间的交换速率主要受液膜控制,其液膜扩散系数为Kf =4.112×10-4/s.同时测定了不同条件下三磷酸胞苷溶液在Duolite A-30树脂固定床离子交换柱中的穿透曲线,研究了进口浓度、进口流速、原料液温度、原料液的pH值及柱高对穿透曲线的影响.用二阶动力学推动力模型描述固定床动态过程,考察了轴向返混对穿透曲线的影响,并从穿透曲线回归得到总传质系数,模型计算值与实验数据符合良好.     

Solid-state synthesis and properties of SmCoO3

In this paper, perovskite oxide SmCoO₃ was prepared by the solid-state reaction method using Co₂O₃ and Sm₂O₃ as raw materials. The structure and properties of the samples were investigated by XRD, Raman spectral techniques, and DC measurements and so on. The results of XRD and Raman spectra showed that the mixtures of Co₂O₃ and Sm₂O₃ can react to produce a single phase perovskite oxide SmCoO₃ around 1353 K. The single-phase SmCoO₃ changes from an insulator to a semi-conductor and transition occurs around 470 K. The thermal expansion coefficient (2.17 × 10⁻⁵ K⁻¹) of the single-phase SmCoO₃ is approximately equal to that of doped LaGaO₃, but much bigger than that of SDC(Ce_0.85Sm_0.15O₂) above 873 K.     

Single electron emission from the closed-tips of single-walled carbon nanotubes

The single electron emission behaviors and characteristics from the well-defined quantized energy levels, corresponding to localized electronic states at the dome-structure tips, in single-walled carbon nanotubes (SWNTs) are investigated and illuminated by use of the energy level emission model in combination with the first-principles calculations on the electronic structures. Under the external electric field, the confined electrons are emitted simultaneously from each quantized energy level by virtue of the resonant tunneling effects. With increasing applied voltage, the emission current increases monotonically and exponentially up to the first peak value, and then steps into the increasing and decreasing "sawtoothlike" variations in sequence. The negative differential resistance or conductivity and the maximum current for SWNTs are simulated. The influences of localized electronic states and curvatures of the different closed tips on the single electron emission behaviors of SWNTs are evaluated and discussed. Also a few issues and applications relevant to electron emission of carbon nanotubes are addressed.     

Contact-Piezoelectric Bi-Catalysis of an Electrospun ZnO@PVDF Composite Membrane for Dye Decomposition

The treatment of organic pollutants in wastewater is becoming a great challenge for social development. Herein, a novel contact-piezoelectric bi-catalysis of a ZnO@ PVDF composite membrane was prepared by electrospinning technology. The obtained ZnO@PVDF composite membranes is superior to the pure PVDF membrane in decomposing methyl orange (MO) under ultrasonication at room temperature, which is mainly attributed to the synergy effect of the contact-electro-catalysis of dielectric PVDF, as well as the piezoelectric catalysis of tetrapodal ZnO and the β-phase of PVDF. The heterostructure of the piezoelectric-ZnO@dielectric-PVDF composite is beneficial in reducing the electron/hole pair recombination. As compared to the pure PVDF membrane, the catalytic degradation efficiency of the ZnO@PVDF composite membrane was improved by 444.23% under ultrasonication. Moreover, the reusability and stability of the composite membrane are comparable to those of the traditional powdered catalyst. This work offers a promising strategy for improving the pollutant degradation by combining contact-electro-catalysis with piezoelectric catalysis.     

Coherent Control of High Harmonic Generation Driven by Metal Nanotip Photoemission

Steering ultrafast electron dynamics with well-controlled laser fields is very important for generation of intense supercontinuum radiation. It can be achieved through coherent control of the symmetry of the interaction between strong-field laser fields and a metal nanotip. We employ a scheme of two-color laser pulses combined with a weak static field to realize the control of a single quantum path to generate high harmonic generation from a single solid-state nanoemitter. Moreover, a smooth and ultrabroad supercontinuum in the extreme ultraviolet region is obtained, which can produce a single attosecond pulse. Our findings are beneficial for efficient generation of isolated sub-100 as XUV pulses from solid-state sources.     

Antioxidant product analysis of Folium Hibisci Mutabilis

Folium Hibisci Mutabilis, a new member of Chinese Pharmacopoeia, can treat some diseases induced by reactive oxygen species. The study prepared a lyophilized aqueous extract of Folium Hibisci Mutabilis (LAFHM). LAFHM was found to enrich eight flavonoids (i.e., quercetin, luteolin, hyperoside, isoquercitrin, rutin, kaempferol, tiliroside, and vitexin) by HPLC analysis. These flavonoids were further compared using antioxidant assays, where triliroside and vitexin always exhibited higher IC₅₀ values than the others. In ultra-performance liquid chromatography coupled with electrospray ionization quadrupole time-of-flight tandem mass spectrometry analysis, these flavonoids could basically give two characteristic m/z values (226 and 196) and their corresponding double m/z values (i.e., 602, 570, 926, 926, 570, 1186, and 862), when treated by 1,1-diphenyl-2-picryl-hydrazl radical (DPPH^?). Finally, the coupling products of DPPH^?-treated triliroside were investigated using computational chemistry. It was found that the –OH in para-coumaroyl moiety to have the lowest bond disassociation energy among all phenolic -OHs in the triliroside. In conclusion, Folium Hibisci Mutabilis contains the above eight antioxidant flavonoids. Despite of the different antioxidant levels, they can generally produce flavonoid-radical coupling product and flavonoid-flavonoid homodimer during antioxidant process. Especially, tiliroside uses para-coumaroyl as linker to construct a tiliroside-radical coupling product at the meta-carbon atom.     

Development and validation of an ELISA kit for the detection of ricin toxins from biological specimens and environmental samples

Ricin is a toxin that can be easily extracted from seeds of Ricinus communis plants. Ricin is considered to be a major bio-threat as it can be freely and easily acquired in large quantities. A deliberate release of such toxin in civilian populations would very likely overwhelm existing public health systems, resulting in public fear and social unrest. There is currently no commercially available or FDA-approved prophylaxis such as vaccines, or therapeutic antitoxins or antidotes, available for ricin intoxication. Patient treatment is typically supportive care based on symptoms, often designed to reinforce the body’s natural response. This paper describes the development and validation of a robust ELISA test kit, which can be used to screen for ricin in biological specimens such as whole blood and faeces. Faecal specimens are shown in this study to have better diagnostic sensitivity and a wider diagnostic window compared to whole blood. From these results, it is concluded that faeces is the most suitable clinical specimen for diagnosis of ricin poisoning via the oral route. The ELISA test kit can also detect ricin in environmental samples. An advantage of this ELISA kit over other commercial off-the-shelf (COTS) detection kits currently on the market that are developed to screen environmental samples only is its ability to diagnose ricin poisoning from clinical specimens as well as detect ricin from environmental samples.     

酯型十八烷基键合硅胶整体柱的制备、表征及性能评价

将硅烷偶联剂γ-(2,3-环氧丙氧)丙基三甲氧基硅烷与十八酸反应,再键合到硅胶整体柱上,得到了酯型十八烷基键合固定相,并用红外光谱、元素分析对其进行了表征。在以甲醇-水为流动相的反相色谱条件下分离了苯、联苯和蒽的混合样品,评价了该整体柱的色谱性能,考察了该整体柱适用的pH范围,以及柱压降、柱效与流速的关系。结果表明,该硅胶整体柱键合效果良好,具有较好的反相色谱性能,且在pH=2～8时稳定性好,柱压降、柱效受流速影响较小,可有效地用于化合物的快速分离分析。     

熔盐堆空气换热器结构完整性分析

熔盐堆作为第四代核反应堆备选堆型之一,运行温度高,对材料高温性能要求严格;熔盐堆空气换热器作为实验堆关键设备,工作温度高,启停机次数多,长期运行后,材料许用应力松弛下降,应力、应变可能超出允许限值,或发生蠕变疲劳失效。使用Workbench软件,对熔盐堆空气换热器进行力学分析,并对A级使用载荷要求进行结构完整性评定,结果表明:熔盐堆空气换热器满足力学性能要求,其中疲劳损伤占比重较大,高温蠕变损伤也较为显著。     

某些稀土氧化物的高温高压合成及其结构稳定性研究

 首次用高压高温方法，在3.2~4.0 GPa，1 000~1 300 ℃下，对CeO₂-R₂O₃（R=Eu，Gd），CeO₂-Tb₄O₁₁，Pr₆O₁₁-Tb₄O₇稀土氧化物进行合成实验，得到具有F型结构的CeEuO_3.5，CeGdO_3.5，CeTbO_3.5；B型结构的CeEuO₃，CeGdO₃，CeTbO₃，PrTbO₃和P型结构的PrTbO₃。PrTbO₃是迄今自然界尚未发现，文献未见报导过的新物质。对上面的产物和NdYbO₃、PrTmO₃，利用高、低温X射线衍射实验，检测了其结构的稳定性，结果指出：从300 ℃直到1 000 ℃，发生由B型CeRO_x向F型CeRO_x（R=Eu，Gd，Tb）、B型PrTbO₃向C型PrTbO₃的结构转变。F型CeRO_x属于氧缺位萤石型结构。