Resonance Raman scattering with a forbidden but vibronically allowed electronic transition: Excitation profiles of combinations and overtones of copper tetraphenylporphyrin in the Q-band resonance

Resonance Raman scattering with the Q band of CuTPP shows a peculiar intensity pattern; bands due to combinations and overtones are strong, whereas the corresponding fundamentals are very weak. By a quantitative analysis of excitation profiles, this phenomenon has been fully accounted for on the basis of the vibronic theory of Raman intensities. Vibronic coupling parameters between the Q and B states of CuTPP have been obtained.     

Stability of a novel hexapeptide, (Me)Arg-Lys-Pro-Trp-tert-Leu-Leu-OEt, with neurotensin activity, in aqueous solution and in the solid state

The stability and some physicochemical properties of a novel hexapeptide, (Me)Arg-Lys-Pro-Trp-tert-Leu-Leu-OEt (I), with neurotensin activity, were investigated. The degradation of I in aqueous solution was observed as a pseudo-first order reaction. By determining the degradation rate of I at various pH values, it was found that I was most stable at around pH 4. The activation energies of the degradation in aqueous solutions at pH 2.2, 6.1, 7.0 and 8.0 were 16.3, 22.2, 23.9 and 24.2 kcal/mol, respectively. The enzymatic hydrolysis of I was studied in vitro with a porcine liver esterase at 37 degrees C. The degradation of I in this system was observed as a pseudo-first order reaction. The degradation rate of I in the presence of the esterase was about 10000 times larger than the rate in a buffer solution. I in the solid state was stable under 65 degrees C and labilized by strong light and/or high humidity. The pKa1, pKa2 and pKa3 of I were 7.1, 10.0 and 11.3, respectively. The partition coefficients between n-octanol and the buffer solution at pH values ranging from 2 to 11 were measured. The partition coefficient increased with the increase of the pH value. But the value at pH 7.0 was 2.10 x 10(-2), which was very low. The solubility of I in aqueous solution was more than 10 mg/ml. From the results of the powder X-ray diffraction pattern, I in the solid state was found to be amorphous. The dissolution rates in the 1st and 2nd fluid of JPXI at 37 degrees C and 100 rpm were 19.4 and 9.0 mg/cm2.min, respectively.     

A useful procedure for diiodination of carbazoles and subsequent efficient transformation to novel 3,6-bis(triethoxysilyl)carbazoles giving mesoporous materials

Bis(pyridine)iodonium tetrafluoroborate (IPy₂BF₄) was successfully used as a diiodination reagent for carbazole and its derivatives to give 3,6-diiodocarbazoles in excellent yield. Subsequent rhodium-catalyzed disilylation of 3,6-diiodocarbazoles with triethoxysilane gave the corresponding 3,6-bis(triethoxysilyl)carbazoles, which are precursors for sol-gel polymerization, in good yield.     

Grinding-induced equimolar complex formation between thiourea and ethenzamide

We prepared and characterized a grinding-induced equimolar complex of thiourea with ethenzamide. When thiourea and ethenzamide were co-ground at a molar ratio of 3 : 1, new powder X-ray diffraction (PXRD) peaks were observed in addition to PXRD peaks of thiourea crystals. The optimum stoichiometry of the new structure was confirmed as 1 : 1 mol/mol. Effect of grinding time on the thiourea-ethenzamide equimolar complex formation was investigated by using PXRD, differential scanning calorimetry and Fourier transform infrared spectroscopy. The equimolar crystal structure was confirmed by X-ray diffraction measurements of the single crystal which was recrystallized from ethanol. It was found that the intermolecular hydrogen bond formations between thiourea and ethenzamide molecules contributed to the equimolar complex formation. The complex formation was not observed in the cases where benzamide, salicylamide or 3-ethoxybenzamide was co-ground with thiourea. 2-Alcoxyl benzamide structures should be required for the grinding-induced equimolar complex formation with thiourea.     

Visual observation of contact-induced intercrystalline migration of aromatic species adsorbed in zeolites by fluorescence microscopy.

Intercrystalline migration and a migration-assisted chemical reaction of adsorbed aromatic species between zeolite particles in physical contact were visualized by fluorescence microscopy coupled with a particle manipulation technique. The luminescence color characteristics of particular zeolite particles originating from the specific photochemistry of adsorbed species was exploited to follow the migration of the molecules. Two examples are shown that are relevant to the visualization of the time-dependent migration process: A one guest-two sets of zeolite crystals system: chrysene (Chry)-loaded zeolite Na+ -X (the sodium form of zeolite X) crystals were placed in contact with unloaded Tl+ -X (thallium-exchanged X) crystals and allowed to stand at room temperature. Initially, the blue fluorescence of Chry was detected only from the Na+ -X particles, but later, the development of green phosphorescence emission was discernible from the Tl+ -X which suggests that Chry migrated from the Na+ -X to the Tl+ -X crystals. A two guest-species systems: Electron-donating Chry-loaded Na+ -X crystals were placed in contact with electron-accepting 1,2,4,5-tetracyanobenzene (TCNB)-loaded Na+ -X or Na+ -Y crystals. With time, the former system (Chry/Na+ -X and TCNB/Na+ -X) gave rise to the emission of Chry-TCNB charge-transfer complexes resulting mainly from the migration of Chry while the latter system (Chry/Na+ -X and TCNB/Na+ -Y) afforded the same emission resulting largely from the migration of TCNB. The present investigation reveals that there is a certain direction for guest migration depending on the zeolite host and the nature of host-guest or guest-guest interaction.     

Reversed-phase liquid chromatographic retention and membrane activity relationships of local anesthetics

The chromatographic retention and membrane activity relationships of local anesthetics were studied to address the possible mechanisms for structure specificity and inflammation-associated decrease of their effects. Five representative drugs (3 mM for each) were reacted with 1,2-dipalmitoyl-sn-glycero-3-phosphocholine liposomes in 25 mM potassium phosphate buffer (pH 5.9-7.9, containing 100 mM NaCl and 0.1 mM EDTA) for 10 min at 37 degrees C and the membrane fluidity changes were analyzed by measuring fluorescence polarization with 1,6-diphenyl-1,3,5-hexatriene. Their capacity factors were determined on octadecyl-, octyl- and phenyl-bonded silica columns with a mobile phase consisting of 25 mM potassium phosphate buffer (pH 5.9-7.9, containing 100 mM NaCl and 0.1 mM EDTA)-methanol (30:70, v/v) at a flow rate of 1.0 ml/min and at a column temperature of 37 degrees C and diode-array detection. Mepivacaine, prilocaine, lidocaine, ropivacaine and bupivacaine fluidized membranes in increasing order of intensity, which agreed with their clinical potency. The relative degree of membrane fluidization correlated with that of retention on an octadecyl stationary phase more significantly than the other phases. Both membrane-fluidizing effects and capacity factors decreased by lowering the reaction and mobile phase pH, being consistent with the hypothesis that anesthetic potency is reduced in inflammation because of tissue acidity. Reversed-phase liquid chromatography appears to be useful for estimating the structure-specific and pH-dependent membrane-fluidizing effects of local anesthetics.     

Phenolic constituents of licorice. VIII. Structures of glicophenone and glicoisoflavanone, and effects of licorice phenolics on methicillin-resistant Staphylococcus aureus

Two new phenolic compounds, glicophenone (1) and glicoisoflavanone (2), were isolated from commercial licorice, and their structures were elucidated on the basis of spectroscopic data. Antibacterial assays of licorice phenolics for Staphylococcus aureus, including four strains of methicillin-resistant S. aureus (MRSA), and also for Escherichia coli K12 and Pseudomonas aeruginosa PAO1, were then examined. Two compounds among them, 8-(gamma,gamma-dimethylallyl)-wighteone (21) and 3'-(gamma,gamma-dimethylallyl)-kievitone (28), showed remarkable antibacterial effects [minimum inhibitory concentrations (MICs), 8 microg/ml on the MRSA strains and methicillin-sensitive S. aureus. Licochalcone A (14), gancaonin G (20), isoangustone A (24), glyasperins C (30) and D (31), glabridin, (32), licoricidin (33), glycycoumarin (34) and licocoumarone (40) showed antibacterial effects on the MRSA strains with MIC values of 16 microg/ml. Effects on the beta-lactam resistance of the MRSA strains were also examined, and licoricidin (33) noticeably decreased the resistance of the MRSA strains against oxacillin, as shown by the reduction in the MICs of oxacillin (lower than 1/128-1/1000 in the presence of 8 microg/ml of 33, and 1/8-1/32 in the presence of 4 microg/ml of 33). Mechanistic study suggested that 33 does not inhibit the formation of penicillin-binding protein 2' (PBP2'), but affects the enzymatic function of PBP2'.     

On-line purification for the determination of catecholamines by liquid chromatography

An on-line purification method for catecholamines was studied using a flow system equipped with an alumina microcolumn. The procedure involves catecholamine adsorption, column washing and catecholamine elution steps. The system is designed not to decompose catecholamines under alkaline conditions in the adsorption step. Flow-rates and times for different solutions delivered in each step (alkaline buffer for adsorption, water for washing and an acidic solution for elution), column length and sample volume to be loaded were systematically investigated by liquid chromatography. Under optimum conditions, norepinephrine, epinephrine, dopamine and 3,4- dihydroxybenzylamine (internal standard) can be purified with recoveries of ? 90% within 11 min with manual operation. This method was efficiently applied to urine samples and the results indicate the possibility that catecholamines in biological samples are automatically purified.     

Thickness and hole-shape dependence of flux penetration into square superconducting networks

We have observed flux penetrations into square superconducting networks of Nb with various thicknesses and hole-shapes by using magneto-optical imaging method. The penetrated pattern does not depend on the thickness and extends along diagonal direction when the samples have smaller area in the intersection of networks. We have also observed similar superconducting networks with and without small holes at the intersection. The small holes at the intersection do not work as a promoter for the diagonal flux penetration though the parallel flux penetration becomes weak. We discuss possible origins of these anomalous anisotropic flux penetrations.     

Possible one-dimensional 3He quantum fluid formed in nanopores

Heat capacity measurements have been made down to 5 mK for 3He fluid films adsorbed in one-dimensional (1D) nanometer-scale pores, 28 A in diameter, preplated with 4He of 1.47 atomic layers. At low 3He density, the heat capacity shows a density-dependent, Schottky-like peak near 150 mK asymptoting to the value corresponding to a 2D Boltzmann gas at high temperatures. The peak behavior is attributed to the crossover from a 2D gas to a 1D state at low temperatures. The degenerate state of the 1D 3He fluid is indicated by a predominantly linear temperature dependence below about 30 mK.