MEASUREMENT OF CONTACT ANGLE IN A CLEARANCE-FIT PIN-LOADED HOLE

A simple experimental technique using an instrumented pin was developed for the measurement of the load-contact variation in a clearance-fit, pin-loaded hole. The method is applicable to both conducting and nonconducting materials.     

Use of organophosphorus extractants impregnated on silica gel for the extraction chromatographic separation of minor actinides from high level waste solutions

Silica-gel has been used as an inert support for the extraction chromatographic separation of actinides and lanthanides from HNO₃ and synthetic high level waste (HLW) solutions. Silica-gel was impregnated with tri-butyl phosphate (TBP), to yield STBP; 2-ethylhexyl phosphonic acid, mono 2-ethylhexyl ester (KSM-17, equivalent to PC-88A), SKSM; octyl(phenyl)-N,N-diisobutyl carbamoylmethylphosphine oxide (CMPO), SCMPO; and trialkylphosphine oxide (Cyanex-923), SCYN and sorption of Pu(IV), Am(III) and Eu(III) from HNO₃ solutions was studied batchwise. Several parameters, like time of equilibration, HNO₃ and Pu(IV) concentrations were varied. The uptake of Pu(IV) from 3.0M HNO₃ followed the order SCMPO>SCYN>SKSM>STBP. With increasing HNO₃ concentration, D _Pu increased up to 3.0M of HNO₃ for STBP, SKSM and SCMPO and then decreased. In the case of Am and Eu with SCMPO, the D values initially increased between 0.5 to 1.0M of HNO₃, remained constant up to 5.0M and then slightly decreased at 7.5M. Also, the effects of NaNO₃, Nd(III) and U(VI) concentrations on the uptake of Am(III) from HNO₃ solutions were evaluated. With increasing NaNO₃ concentration up to 3.0M, D _Am remained almost constant while it was observed that it decreases drastically by adding Nd(III) or U(VI). The uptake of Pu and Am from synthetic pressurized heavy water reactor high level waste (PHWR-HLW) in presence of high concentrations of uranium and after depleting the uranium content, and finally extraction chromatographic column separation of Pu and Am from U-depleted synthetic PHWR-HLW have been carried out. Using SCMPO, high sorption of Pu, Am and U was obtained from the U-depleted HLW solution. These metal ions were subsequently eluted using various reagents. The sorption results of the metal ions on silica-gel impregnated with several phosphorus based extractants have been compared. The uptake of Am, Pu and rare earths by SCMPO has been compared with those where CMPO was sorbed on Chromosorb-102, Amberchrom CG-71 and styrene divinylbenzene copolymer immobilized in porous silica particles.     

Polarographic determination of Pb, Tl, Bi and Sb in ethylenediamine in presence of mannitol

Summary Pb, Tl, Bi and Sb yield well defined polarograms in 1 M ethylenediamine in presence of 3% mannitol, with half-wave potentials at – 0.71 V, – 0.51 V, – 0.60 V and – 1.10 V, respectively. Only Pb and Tl develop maxima which can be suppressed by 0.02% gelatin. Presence of mannitol prevents the precipitation of Pb, Bi, and Sb in the alkaline solution. Simultaneous determinations of Pb/Tl, Bi/Sb, and Pb/Sb can be carried out.

---

Polarographische Bestimmung von Pb, Tl, Bi und Sb in Äthylendiamin in Gegenwart von Mannit

Zusammenfassung Gut ausgebildete Polarogramme kann man von diesen Elementen in 1 M Äthylendiamin in Gegenwart von 3% Mannit erhalten. Die Halbstufenpotentiale liegen bei – 0,71 V (Pb), – 0,51 V (Tl), – 0,60 V (Bi) und – 1,10 V (Sb). Maxima, die im Falle von Pb und Tl gebildet werden, können durch 0,02% Gelatine unterdrückt werden. Durch Mannit wird die Fällung von Pb, Bi, und Sb in der alkalischen Lösung verhindert. Simultanbestimmungen von Pb/Tl, Bi/Sb und Pb/Sb sind möglich.

Our sincere thanks are due to Dr. G. B. Singh, Professor and Head, Department of Chemistry, B.H.U. for providing the necessary facilities.     

A constitutional diagram of the system TiC−HfC−WC

The system TiC?HfC?WC was investigated by means of melting point, differential thermoanalytical, X-ray diffraction and metallographic techniques on hot pressed and heat treated as well as melted alloy specimens and a complete constitutional diagram from 1500°C through the melting range established. According to the peritectic melting of hexagonal WC both isopleths, TiC?WC as well as HfC?WC show a class II reaction at 2760°C in Ti?W?C and at 2730°C in Hf?W?C. The phase behaviour within the TiC?HfC?WC system is characterized by the presence of a (binary) miscibility gap within TiC?HfC [T _c=1780°C, (TiC)_0.55(HfC)_0.45] which extends into the ternary forming a closed ternary miscibility gap at higher temperatures with an isolated ternary critical point:T _c=1800°C, (TiC)_0.55(HfC)_0.45(WC)_0.05. Interaction of the solvus (boundary of the cubic-B 1 monocarbide solid solution) and the ternary miscibility gap was established at 1540°C and (TiC)_0.27(HfC)_0.41(WC)_0.32: Alloys of this composition enter a decomposition reaction on cooling into two isotypic cubic B 1 phases and hexagonal WC. Isothermal sections were calculated assuming regular solutions.     

Thermoanalytical properties of monobasic nitrilotriacetate salts of alkaline earth metals and zinc

Monobasic metal nitrilotriacetate hydrated salts, MH[N(CH₂COO)₃].xH₂O, have been prepared by the reaction of nitrilotriacetic acid with metal carbonate. DTA studies of these salts both in N₂ and air reveal that these salts initially undergo dehydration and then, through acetate intermediates, decompose to oxycarbonates or oxides.     

Ligational behavior of new mononucleating NOO ethyl pyruvate Schiff base towards 3d metal(II) ions: an emphasis on antiproliferative and photocleavage property

A series of Co(II), Ni(II), Cu(II), and Zn(II) complexes of a tridentate hydrazone were prepared and characterized by various spectro‐analytical techniques and magnetic moment studies. The complexes were found to be monomeric and non‐electrolytes. The copper complex is electrochemically active in the applied potential range. The compounds synthesized in the present study have shown promising antiproliferative activity when screened using the in vitro method against two human cancer cell lines: HeLa and HepG2. The Escherichia coli DNA‐binding properties of all the compounds were investigated with UV–visible absorption spectrophotometric titrations, viscosity measurements, DNA melting experiments and gel electrophoreses measurements. The compounds were demonstrated to act as DNA intercalators with appreciable DNA‐binding constant values. Copyright © 2012 John Wiley & Sons, Ltd.     

Removal of Brilliant Green from wastewater using conventional and ultrasonically prepared poly(acrylic acid) hydrogel loaded with kaolin clay: A comparative study

The present work deals with the removal of Brilliant Green dye from wastewater using a poly(acrylic acid) hydrogel composite (PAA-K hydrogel) prepared by incorporation of kaoline clay. The composite has been synthesized using ultrasound assisted polymerization process as well as the conventional process, with an objective of showing the better effectiveness of ultrasound assisted synthesis. It has been observed that the hydrogel prepared by ultrasound assisted polymerization process showed better results. The optimum conditions for the removal of dye are pH of 7, temperature of 35 °C, initial dye concentration of 30 mg/L and hydrogel loading of 1 g. The extent of removal of dye increased with an increase in the contact time and initial dye concentration. A pseudo-second-order kinetic model has been developed to explain the adsorption kinetics of dye on the PAA-K hydrogel. Thermodynamic and kinetic parameters indicate that the adsorption process is spontaneous in nature and the PAA-K hydrogel prepared by ultrasound process is a promising adsorbent compared to conventional process. The obtained adsorption data has also been fitted into commonly used adsorption isotherms and it has been found that Freundlich as well as Langmuir adsorption isotherm models fits well to the experimental results.     

Correlations of fission fragment angular momentum with collective and intrinsic degrees of freedom

In the present work angular momenta of the fragments corresponding to¹³²I^m,g have been deduced from the radiochemically determined independent isomeric yield ratios and statistical model based analysis in neutron induced fission of²³⁵U,²³⁹Pu and²⁴⁵Cm and spontaneous fission of²⁵²Cf. These data along with similar data on¹³⁴I, reported earlier from this laboratory, bring out the effects of deformed 66n and spherical 82n shells on fragment angular momentum showing also an inverse correlation of the latter with elemental yields. Quantitative estimates of fragment scission point deformation and the coefficient of change of fragment angular momentum with kinetic/excitation energy have been deduced and are seen to be in good agreement with the expected theoretical estimates.     

Dielectron widths of the Gamma(1S,2S,3S) resonances

We determine the dielectron widths of the Gamma(1S), Gamma(2S), and Gamma(3S) resonances with better than 2% precision by integrating the cross section of e+e- -->Gamma over the e+e- center-of-mass energy. Using e+e- energy scans of the Gamma resonances at the Cornell Electron Storage Ring and measuring Gamma production with the CLEO detector, we find dielectron widths of 1.252+/-0.004(sigma(stat))+/-0.019(sigma(syst)) keV, 0.581+/-0.004+/-0.009 keV, and 0.413+/-0.004+/-0.006 keV for the Gamma(1S), Gamma(2S), and Gamma(3S), respectively.