Debye screening of dislocations

Debye-like screening by edge dislocations of some externally given stress is studied by means of a variational approach to coarse grained field theory. Explicitly given are the force field and the induced geometrically necessary dislocation (GND) distribution, in the special case of a single glide axis in 2D, for (i) a single edge dislocation and (ii) a dislocation wall. Numerical simulation demonstrates that the correlation in relaxed dislocation configurations is in good agreement with the induced GND in case (i). Furthermore, the result (ii) well predicts the experimentally observed decay length for the GND developing close to grain boundaries.     

Brightening of an accretion disk due to viscous dissipation of gravitational waves during the coalescence of supermassive black holes

Mergers of supermassive black hole binaries release peak power of up to approximately 10(57) erg s(-1) in gravitational waves (GWs). As the GWs propagate through ambient gas, they induce shear and a small fraction of their power is dissipated through viscosity. The dissipated heat appears as electromagnetic (EM) radiation, providing a prompt EM counterpart to the GW signal. For thin accretion disks, the GW heating rate exceeds the accretion power at distances farther than approximately 10(3) Schwarzschild radii, independently of the accretion rate and viscosity coefficient.     

Studies on the track formation mechanism of the heavy ions in CR-39

The bulk etch rate for two types of CR-39 detector was measured as a function of temperature and the activation energies of bulk etching was determined. Experimental values of track etch rate were derived directly from the function of the succesive measured track length vrs. etching time for ²⁰⁹Bi, ¹²⁹Xe and ²⁰Ne ions.

The maximum etchable length of 13 MeV/u ²⁰⁹Bi and 13.04 MeV/u ¹²⁹Xe ions have been measured at and below these energies. A comparison of the measured and calculated track length data is presented.     

Conservative spatial chaos of buckled elastic linkages

Buckling of an elastic linkage under general loading is investigated. We show that buckling is related to an initial value problem, which is always a conservative, area-preserving mapping, even if the original static problem is nonconservative. In some special cases, we construct the global bifurcation diagrams, and argue that their complicated structure is a consequence of spatial chaos. We characterize spatial chaos by the associated initial value problem's topological entropy, which turns out to be related to the number of buckled configurations.     

Doppler shift of femtosecond laser pulses from solid density plasmas

Doppler-shift of short UV pulses (248 nm, 700 fs) reflected from aluminum, polystyrene and gold targets were measured at focused intensities up to 5×10¹⁵ W/cm². In spite of the fact that the Doppler-shifts are expected to be dependent on the atomic weight of the target material, experimentally similar shifts are found for all targets. A possible explanation is provided by the well known dependence of the Doppler shift on the plasma temperature, if different absorption coefficients are assumed for the different targets. This coefficient shows good agreement with that one deduced from a theory based on collisional absorption in the case of aluminum, but in the case of the other targets, however, the experimentally observed Doppler-shift suggests smaller absorption for lighter and larger absorption for heavier target materials. PACS 52.25.Mq; 52.25.Qt; 52.40.Nk; 52.50.Jm     

Cellular automata for the spreading of technologies in socio-economic systems

We introduce an agent-based model for the spreading of technological developments in socio-economic systems where the technology is mainly used for the collaboration/interaction of agents. Agents use products of different technologies to collaborate with each other which induce costs proportional to the difference of technological levels. Additional costs arise when technologies of different providers are used. Agents can adopt technologies and providers of their interacting partners in order to reduce their costs leading to microscopic rearrangements of the system. Analytical calculations and computer simulations revealed that starting from a random configuration of different technological levels a complex time evolution emerges where the spreading of advanced technologies and the overall technological progress of the system are determined by the amount of advantages more advanced technologies provide, and by the structure of the social environment of agents. We show that agents tend to form clusters of identical technological level with a power law size distribution. When technological progress arises, the spreading of technologies in the system can be described by extreme order statistics.     

Non-bilayer formation in the DPPE-DPPG vesicle system induced by deep rough mutant of Salmonella minnesota R595 lipopolysaccharide

The vesicle system consisting of 80 mol% dipalmitoylphosphatidylethanolamine (DPPE) and 20 mol% dipalmitoylphosphatidylglycerol (DPPG) undergoes to structural changes caused by various concentrations of Salmonella minnesota R595 lipopolysaccharide (LPS). The phenomenon was investigated by methods applying small- and wide-angle X-ray scattering (SAXS and WAXS), calorimetry (DSC) and freeze-fracture. In the low LPS concentration regime (investigated at 0.02 LPS/DPPE–DPPG molar ratio) a phase separation was observed. Two kind of domains are formed which are rich and poor in DPPE and in these domains cubic and lamellar structures are present, respectively. Increasing the LPS concentration up to 0.1 LPS/DPPE–DPPG molar ratio the phase separation is more expressed and the temperature domains of the phase transitions are more different. Increasing the temperature chain melting of the lamellar phase occurs first and destruction of the cubic phase is observed later. At high LPS concentration (equimolar ratio of LPS/DPPE–DPPG), where this amphiphilic molecule cannot be considered any more a guest molecule, the cubic structure dominates the phase behaviour of the LPS molecules.     

Characterization and TLC-Bioautographic Detection of Essential Oils from Some Thymus Taxa. Determination of the Activity of the Oils and their Components Against Plant Pathogenic Bacteria

JPC – Journal of Planar Chromatography – Modern TLC - The chemical composition of the oils of four thyme (Lamiaceae) chemotypes (Thymus vulgaris L., Thymus serpyllum L., Thymus x...     

Structural variability of endotoxins from R-type isogenic mutants of Shigella sonnei

The structural variations in the rough-type endotoxins [lipopolysaccharides (LPSs)] of Shigella sonnei mutant strains (S. sonnei phase II-4303, R41, 562H and 4350) were investigated by Matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF-MS) and tandem MS. A series of S. sonnei mutants had previously been the subject of analytical studies on the biosynthesis of heptose components in the core oligosaccharide region of LPSs. This study gives a complete overview on the structures of the full core and lipid A of S. sonnei mutant strains by MS. We found that the LPSs of the isogenic rough mutants were formed in a step-like manner containing 0:1:2:3 heptose in the deep core region of 4350, 562H, R41 and 4303, respectively, and the longest LPS from the mutant S. sonnei 4303 contained also five hexoses. The structural variations in the lipid A moiety and in the oligosaccharide part of the intact LPS were followed by MALDI-TOF-MS/MS. For the dissolution and the ionization of the samples, 2,5-dihydroxybenzoic acid in citric acid solution was applied as matrix. The detailed evaluation of the mass spectra indicates heterogeneity in the lipid part due to the differences in the phosphate and fatty acid composition.     

Controlling the Deintercalation in Hydrogenated Nitrile Rubber (HNBR)/Organo‐Montmorillonite Nanocomposites by Curing with Peroxide

Summary: The effect of peroxide vulcanization on organoclay dispersion in hydrogenated nitrile rubber (HNBR)/organo‐montmorillonite (organo‐MMT) nanocomposites was investigated. Three types of organoclays were tested, one containing a primary amine and two bearing quaternary intercalants. In contrast to sulfur vulcanization, which in combination with primary amine intercalants produced a confined/deintercalated clay structure, the peroxide curing yielded well‐ordered intercalated nanocomposites. The tensile mechanical performance and oxygen permeability of the HNBR nanocomposites were determined.

Oxygen permeability coefficient ratio for the different HNBR films tested at 0 and 60% relative humidity (i.e., dry and wet conditions, respectively).