Monitoring degradation processes of explosives by HPLC analysis with UV- and amperometric detection

 The impact of spilled explosives, their by-products and degradation products on human beings and the environment has been recognised as a serious problem at areas of existing and former ammunition plants. In nature, aerobic and anaerobic degradation processes of explosives and their accompanying compounds yield polar contaminants with relatively high water solubilities. Most are potentially carcinogenic and mutagenic. An HPLC method applying UV-detection for nitroaromatic compounds and amperometric detection for aminoaromatic and phenolic compounds was used for monitoring the degradation of explosives in a polluted groundwater sample under natural conditions. Analysis was performed by direct injection of aliquots of the sample after exposition to daylight for different periods of time. Received: 6 January 1996/Revised: 7 March 1996/Accepted: 13 March 1996     

Influence of Test Specimen Geometry and Water Soaking on the In Vitro Cytotoxicity of Orthocryl®, Orthocryl® LC,Loctite® EA 9483 and Polypropylene

Depending on their composition, plastics have a cytotoxic potential that needs to be evaluated before they are used in dentistry, e.g., as orthodontic removable appliances. Relevant guidelines set out requirements that a potential new resin in the medical field must meet, with a wide scope for experimental design. In the present study, test specimens of different geometries consisting of varying polymers (Orthocryl^®, Orthocryl^® LC, Loctite^® EA 9483, Polypropylene) were soaked for different periods of time, then transferred to cell culture medium for 24 h, which was subsequently used for 24-h cultivation of A549 cells, followed by cytotoxicity assays (WST-1, Annexin V-FITC-propidium iodide (PI) flow cytometry). In this context, a reduction in the cytotoxic effect of the eluates of test specimens prepared from Orthocryl^® LC and Loctite^® EA 9483 was particularly evident in the Annexin V-FITC-PI assay when the soaking time was extended to 48 h and 168 h, respectively. Consistent with this, a reduced release of potentially toxic monomers into the cell culture medium, as measured by gas chromatography-mass spectrometry, was observed when the prior soaking time of test specimens of all geometries was extended. Remarkably, a significant increase in cytotoxic effect was observed in the WST-1 assay, which was accompanied by a higher release of monomers when the thickness of the test sample was increased from 0.5 to 1.0 mm, although an elution volume adapted to the surface area was used. However, further increasing the thickness to 3.0 mm did not lead to an increase in the observed cytotoxicity or monomer release. Test specimens made of polypropylene showed no toxicity under all test specimen sizes and soaking time conditions. Overall, it is recommended to perform toxicity studies of test specimens using different geometries and soaking times. Thereby, the influence of the different specimen thicknesses should also be considered. Finally, an extension of the test protocols proposed in ISO 10993-5:2009 should be considered, e.g., by flow cytometry or monomer analysis as well as fixed soaking times.     

IR and SFM study of PTCDA thin films on different substrates

FT-IR spectroscopy and SFM were used to investigate the growth of thin films of the organic semiconductor 3,4,9,10-perylenetetracarboxylicdianhydride (PTCDA) deposited by vacuum sublimation onto various substrates, i.e. Ag(111) layers on mica, KBr(100), mica, oxidized Si, and TiO₂ nanoparticles on Si. Layer thicknesses of PTCDA varied from 10 to 1500 nm.The anhydride vibrations of PTCDA differ for the used substrates, which can be connected to the orientation of the molecules relative to the substrate surface and the film morphology as detected in the SFM pictures.     

Über das Verhalten von markiertem Coniferin in der verholzenden Pflanze

Zusammenfassung Eine wäßrige. Lösung von Coniferin (3-¹⁴C) wurde durch Infusion an zweijährige Fichtenäste verabreicht. Die Verteilung der Radioaktivität in Holz, Rinde, Seitentrieben und den Extrakten wurde gemessen. Die aus diesen Ergebnissen erstellte Bilanz ließ 90% der eingesetzten Radioaktivität erfassen.Rinde und Holz wurden getrennt derHibbertschen Äthanolyse unterworfen. Aus den dabei anfallenden Ligninfraktionen wurden aktive Reinsubstanzen (Vanillin und Vanilloylacetyl) gewonnen. Die molaren Aktivitäten dieser Verbindungen ergaben durch Vergleich mit der molaren Aktivität des Coniferins die Verdünnungsgrade; diese lassen Rückschlüsse über den Einbau des Coniferins in das Lignin zu. Die Ergebnisse zeigen, daß die Infusionsmethode den biologischen Verhältnissen eher gerecht wird als die Implantationsmethode.Mit 1 Abbildung     

Transparent conducting Sn:ZnO films deposited from nanoparticles

Homogeneous transparent conducting Sn:ZnO films on fused silica substrates were prepared by dip-coating from nanoparticle dispersions, while the nanocrystalline Sn:ZnO particles with different dopant concentrations were synthesized by microwave-assisted non-aqueous sol–gel process using Sn(IV) tert-butoxide and Zn(II) acetate as precursors and benzyl alcohol as solvent. The dopant concentration had a great impact on the electrical properties of the films. A minimum resistivity of 20.3 Ω cm was obtained for a porous Sn:ZnO film with initial Sn concentration of 7.5 mol% after annealing in air and post-annealing in N₂ at 600 °C. The resistivity of this porous film could further be reduced to 2.6 and 0.6 Ω cm after densified in Sn:ZnO and Al:ZnO reaction solution, respectively. The average optical transmittance of a 400-nm-thick Sn:ZnO film densified with Sn:ZnO after the two annealing steps was 91%.     

GC-MS Studies on Derivatization of Creatinine and Creatine by BSTFA and Their Measurement in Human Urine

In consideration of its relatively constant urinary excretion rate, creatinine (2-amino-1-methyl-5H-imidazol-4-one, MW 113.1) in urine is a useful endogenous biochemical parameter to correct the urinary excretion rate of numerous endogenous and exogenous substances. Reliable measurement of creatinine by gas chromatography (GC)-based methods requires derivatization of its amine and keto groups. Creatinine exists in equilibrium with its open form creatine (methylguanidoacetic acid, MW 131.1), which has a guanidine and a carboxylic group. Trimethylsilylation and trifluoroacetylation of creatinine and creatine are the oldest reported derivatization methods for their GC-mass spectrometry (MS) analysis in human serum using flame- or electron-ionization. We performed GC-MS studies on the derivatization of creatinine (d₀-creatinine), [methylo-²H₃]creatinine (d₃-creatinine, internal standard) and creatine (d₀-creatine) with N,O-bis(trimethylsilyl)trifluoroacetamide (BSTFA) using standard derivatization conditions (60 min, 60 °C), yet in the absence of any base. Reaction products were characterized both in the negative-ion chemical ionization (NICI) and in the positive-ion chemical ionization (PICI) mode. Creatinine and creatine reacted with BSTFA to form several derivatives. Their early eluting N,N,O-tris(trimethylsilyl) derivatives (8.9 min) were found to be useful for the precise and accurate measurement of the sum of creatinine and creatine in human urine (10 µL, up to 20 mM) by selected-ion monitoring (SIM) of m/z 271 (d₀-creatinine/d₀-creatine) and m/z 274 (d₃-creatinine) in the NICI mode. In the PICI mode, SIM of m/z 256, m/z 259, m/z 272 and m/z 275 was performed. BSTFA derivatization of d₀-creatine from a freshly prepared solution in distilled water resulted in formation of two lMate-eluting derivatives (14.08 min, 14.72 min), presumably creatinyl-creatinine, with the creatininyl residue existing in its enol form (14.08 min) and keto form (14.72 min). Our results suggest that BSTFA derivatization does not allow specific analysis of creatine and creatinine by GC-MS. Preliminary analyses suggest that pentafluoropropionic anhydride (PFPA) is also not useful for the measurement of creatinine in the presence of creatine. Both BSTFA and PFPA facilitate the conversion of creatine to creatinine. Specific measurement of creatinine in urine is possible by using pentafluorobenzyl bromide in aqueous acetone.