Synthesis,structure and DNA-binding studies on the 2-(3-chlorophenyl)imidazo[4,5-f]1,10-phenanthroline-bis(2,2′-bipy ridine)-ruthenium(II) complex

A new polypyridyl ligand, MCP {MCP = 2-(3-chlorophenyl)imidazo[4,5-f]1,10-phenanthroline} and its ruthenium(II) complex, [Ru(bpy)2(MCP)](ClO4)2· 0.5MeCN (bpy = 2,2-bipyridine), have been synthesized and characterized. The structure of the complex was determined by single crystal X-ray diffraction techniques. The MCP ligand is essentially planar and the stacking interactions between the ligands were observed in the crystal. [Ru(bpy)2(MCP)]2+ can strongly bind to Calf thymus DNA through intercalation of MCP ligand. The Cl substitute group has no significant effect on the spectral properties and DNA-binding behaviour of the complex.     

A novel and efficient ionic liquid supported synthesis of oligosaccharides

A novel and efficient ionic liquid supported synthesis of oligosaccharides with a general protocol of coupling and purification is described. The method represents an attractive alternative to the classical solid- and fluorous-phase synthesis strategies and combines the advantage of performing homogeneous chemistry on a relatively large scale while avoiding large excesses of reagents.     

回收灯用钨丝在H2O2催化氧化环己酮合成己二酸中的应用

以回收灯用钨丝为催化剂前驱物,30％H2O2为氧源,催化氧化环己酮合成了己二酸,反应体系中无须使用有机溶剂、酸性助剂和相转移剂。 IR和TG分析表明,钨丝与H2O2反应生成的新生态过氧钨酸是催化活性成分,合成己二酸后转化为钨酸。 钨丝为催化剂前驱物合成己二酸适宜反应条件为：100 mmol环己酮,50 mL 30%H2O2,钨丝的摩尔用量为环己酮摩尔数的1.5%,回流反应6 h,己二酸收率63.7%。 比相同反应条件下用钨酸和WO3为催化剂的收率高10%~18%。     

并联铁电体冲击去极化输出电流实验和计算

 为分析不同数量铁电体的输出电流特征,进行了多片并联PZT95/5铁电体冲击去极化实验,测量了电阻负载下铁电体的输出电流;建立了并联铁电体输出电流的计算模型,计算了并联铁电体的输出电流。通过比较计算和实验结果,分析了铁电体数量和冲击波状态对铁电体输出电流的影响。结果表明：若进入铁电体的冲击波为平面波,铁电体输出电流的波形接近方波,电流峰值随铁电体并联数量的增加成比例增加,冲击波波形和侧向稀疏波对铁电体输出电流波形和去极化率有很大的影响。     

聚对苯乙炔的能带结构和关联能计算

在考虑电子-电子相互作用情况下,对基态非简并聚合物聚对苯乙炔(PPV)的长程关联能进行了理论计算,并用长程关联能对带隙进行修正,最后讨论了长程关联能对带隙的影响.在对PPV链的计算中发现,长程关联能先会随着链长N的增加而减小,但当链长大于10个PPV单元后,长程关联能会达到饱和.与由Hartree-Fock(HF)方法所得的能隙宽度比.长程关联能的修正会使得能隙降低,这种修正后的能隙宽度与实验结果一致.     

CaCu3Ti4O12 陶瓷介电模量响应特性的研究

由于CaCu₃Ti₄O₁₂巨介电常数陶瓷的低频区直流电导较大, 本文采用模量 M"-f频谱表征与分析了低频和高频的两个松弛极化过程. 研究认为, 这两个特征峰属于晶界区Schottky 势垒耗尽层边缘深陷阱的电子松弛过程, 其中高频松弛峰起源于晶粒本征缺陷的电子松弛过程, 而低频松弛峰则为与氧空位有关的松弛极化过程. 对于CaCu₃Ti₄O₁₂这类低频下具有高直流电导的陶瓷材料, 采用模量频谱能更有效地分析研究其损耗极化机理. 关键词： 3Ti₄O₁₂陶瓷')" href="#">CaCu₃Ti₄O₁₂陶瓷 模量 松弛过程 电导     

聚集态和陷阱对交联聚乙烯真空沿面闪络特性的影响

研究了半结晶聚合物交联聚乙烯的聚集态和陷阱等对真空沿面闪络特性的影响.交联聚乙烯(XLPE)在135℃下恒温10min后,分别经过-56℃,-25℃淬火处理,自然降温,或1℃/min,0.5℃/min慢速降温等热处理过程,测量了热处理后试样的电气性能、显微结构、陷阱分布和真空中的沿面闪络特性.实验结果表明,与未热处理试样相比,热处理试样的直流闪络电压最高提高了76%,脉冲闪络电压最高提高了19%.认为热处理改变了XLPE试样的聚集态和陷阱,从而提高了XLPE试样的真空沿面闪络性能,提出了可以通过控制半结晶聚合物的聚集态和缺陷结构提高其真空沿面闪络性能.     

Best linear unbiased prediction for linear combinations in general mixed linear models

The general mixed linear model can be written as . In this paper, we mainly deal with two problems. Firstly, the problem of predicting a general linear combination of fixed effects and realized values of random effects in a general mixed linear model is considered and an explicit representation of the best linear unbiased predictor (BLUP) is derived. In addition, we apply the resulting conclusion to several special models and offer an alternative to characterization of BLUP. Secondly, we recall the notion of linear sufficiency and consider it as regards the BLUP problem and characterize it in several different ways. Further, we study the concepts of linear sufficiency, linear minimal sufficiency and linear completeness, and give relations among them. Finally, four concluding remarks are given.     

中空纳米二氧化硅复合微球的制备及其对蛋白的亲和分离

利用水热法合成了中空巯基纳米二氧化硅微球(SiO₂-SH), 然后在其表面修饰亚氨基二乙酸基团(-IDA), 形成了中空SiO₂-SH/IDA双功能化纳米微球。利用该纳米微球表面的-SH和-IDA双功能团, 可以更多的吸附溶液中的Ni²⁺, 形成SiO₂-SH/IDA-Ni²⁺复合微球从而可以更好的分离以六聚组氨酸为标签的(His-tagged)蛋白。结果显示制备的样品对分离His-tagged蛋白具有广谱性, 并且具有较好的再生能力。     

硅胶催化的选择性去除N-Boc保护基

发现了在回流的甲苯中, 以硅胶为催化剂, 多种N-Boc保护的伯胺、仲胺、氨基酸的氨基都可以迅速脱除Boc. 该方法具有条件温和、操作简便、反应时间短和产率高等优点. 同时, 其它常用的保护基Cbz和Fmoc等在同样的条件下不受影响.