Status of heavy element research using a gas-filled recoil separator at RIKEN

A gas-filled type of recoil separator for heavy element research was installed at an experimental hall of RIKEN Linear Accelerator facility to realize getting higher intensity of primary beam and long beam time. Performance of the separator was studied using target recoils and various nuclear reactions. The results show the high performance of the separator for heave element research. As an application of the GARIS, production and identification of an isotope of the 110th element ²⁷¹[110] have been performed using the ²⁰⁸Pb(⁶⁴Ni,1n)²⁷¹[110] reaction. Three decay chains coincide well both in decay times and energies with the ones reported by the group of SHIP experiment at GSI, Germany. Our results provide a confirmation of the synthesis of an isotope ²⁷¹[110] of element 110.     

Structural characterization of polypyrrole in the solid state by high resolution 15N NMR spectroscopy [II]

The solid-state ¹⁵N CP/MAS NMR spectra and ¹⁵N spin-lattice relaxation times (T₁) of doped and dedoped ¹⁵N-labeled polypyrroles prepared by electrochemical polymerization, have been measured by means of high-resolution solid-state ¹⁵N NMR. The ¹⁵N signal of polypyrrole consists of four peaks decomposed by line shape analysis. The four peaks obtained have been assigned to the various structures of polypyrrole. Further, the half-width of the ¹⁵N NMR spectra of polypyrroles is discussed as related to the electrical conductivity. © 1995 John Wiley & Sons, Inc.     

Development and features of hydro-membrane gas chromatography.

Hydro-membrane gas chromatography (HMGC) is achieved by the annular condensation of water in a capillary column at less than 70 degrees C. The annular membrane of water is formed as a result of the wettability of the stationary phase, which is induced at a water contact angle ranging from 75 degrees to 79 degrees, as derived from a solubility parameter (delta) range of 15.7 +/- 0.3 MPa(1/2) of the coated resin. The range of the liquid to gas volume ratio (beta) required to support the annular membrane should be kept between 0.00005 and 0.0003. In the case of a 0.25-mm i.d. column, the ratio can be set by the combination of a 0.1 to 0.2 microl min(-1) water supply rate and helium gas flow rate. Separation by HMGC develops not only a gas-solid partition but also a focusing effect on the water membrane. One feature of HMGC is that it gives a non-adsorption chromatogram based on the blocking effect of pre-adsorbed water; furthermore, despite the presence of a relatively large quantity of water, the electron impact ionization efficiency is kept the same as in the usual GC/MS condition. The detection limit with the injection of 1 microl of aquatic solution was estimated to be less than 0.1 ppb of low-molecular-weight fatty acids with s/n = 5 on a mass chromatogram at m/z 45. The HMGC/EI-MS system can be applied to the trace analysis of C1 to C3 volatile acids, volatile inorganic acids, and halogenated organic acids in water.     

Durch Bromierung ausgelöste Umlagerung tertiärer Allylalkohole: Der Einfluss eines Fluor-Substituenten auf Reaktionsgeschwindigkeit und Reaktionsverlauf

Rearrangement of Tertiary Allyl Alcohols Induced by Bromination: The Effect of a Fluorine Substituent on the Rate and the Outcome of the Reaction The allyl alcohol bearing a methyl and a t-butyl group at the hydroxylated position was found to undergo a rearrangement when treated with bromine (or N-bromosuccinimide) in an aqueous medium and to afford a product mixture containing two regioisomeric ketones and one oxirane. Introduction of an additional methyl group or a fluorine atom at the non-terminal olefinic center led to a more selective discrimination between potential migratory groups. As the result of an exclusive t-butyl shift only one product, a ketone, was formed in both cases. Whereas the reaction rate was only slightly affected by the additional methyl group, it was substantially decreased by the fluorine atom.     

A theoretical study of the dielectric solvent effect on vicinal spin coupling constants

The dielectric solvent effect on HCCH, HCNH and HCNC spin coupling constants in ethane, tetrachloroethane and trans N-methylformamide has been calculated by finite perturbation theory based on the INDO and CNDO/2 approximations incorporating solvaton theory. The available experimental data are interpreted using the calculated variations of spin coupling constants. The effect of dielectric constant on the general form of the Karplus relation is included in the finite perturbation calculations.     

A potentiometric microbial sensor based on immobilized escherichia coli for glutamic acid

The sensor consists of immobilized E. coli (which contains glutamate decarboxylase) and a carbon dioxide gas-sensor. Continuous introduction of sample solution into a flow system incorporating the sensor gives a potential which increases until a steady state is reached after 5 min. Measurements can also be made with only a 1- or 3-min introduction period with little loss of sensitivity. Calibration plots of mV measurements vs. logarithmic glutamic acid concentration are linear in the range 100–800 mg l^-1. The sensor is highly selective, stable and reproducible. It has been applied to the determination of glutamic acid in fermentation broths.     

Observation of magnetic order of Cu-moment aroundx=0.12 in La2−x Ba x CuO4 and La2−x sr x CuO4 by μ+SR

Zero field positive muon spin rotation method ( ⁺SR) is applied on La_2–x Sr _x CuO₄ around forx=0.12 at which the high-T _c superconductivity (SC) is suppressed. The magnetically ordered state of Cu-moments, which is not a spin glass state but an antiferromagnetic like state, appears below 15 K for 0.105x0.120. The magnetic phase boundary is very similar to the one of the La_2–x Ba _x CuO₄ in which the structural transition from the low temperature orthorhombic (LTO) phase to the low temperature tetragonal (LTT) phase is observed aroundx=0.12. The present study suggests that there is no big difference of the electronic state of the CuO₂ plane between the La-Ba system and the La-Sr system and that the magnetic ordering of Cu-moments plays an important role for the suppression of the high-T _c SC aroundx=0.12 in both of the systems, although the LTO-LTT structural transition has not been observed yet in the La-Sr system.     

Thermoswitching property in TCNQ salts of ionenes containing poly(ethylene oxide) segments

Ionene polymers characterized by the alternating structure of ionene and crystalline poly(ethylene oxide) (PEO) segments were prepared as a function of PEO segment size. A microstructure of these ionenes and their 7,7,8,8-tetracyanoquinodimethane (TCNQ) salts were investigated with x-ray diffraction patterns, thermal scanning behavior, and polarizing micrographs. On the basis of this microstructure, the change in resistivity with temperature was studied. In Arrhenius' plots of the resistivity the simple salts in which the spherulites consisting of the PEO segments were observed showed a sharp decrease in resistivity with a rise in temperature [critical temperature resistor (CTR)] at about the melting point of the PEO segments, whereas the other simple salts in which the spherulites were not observed showed linear temperature dependence. The switching properties were confirmed similarly in repetitive heating/cooling cycles. This CTR characteristic was attributed to an increase in continuity in the conduction paths by melting spherulites. The apparent switching properties were not observed in the complex salts.     

Computer simulation for the cooligomerization system

In order to clarify the kinetic features of the styrene (A)–methyl methacrylate (B)–CCl₄(S) cooligomerization system, a computer simulation was carried out. The experimental data on the degree of polymerization and the deviation of the cooligomer composition from the statistical steady-state composition were comparatively well explained by calculations based on the kinetic equations derived from the assumed reaction scheme and the values of the velocity coefficients, although the values of the four velocity coefficients in the initiation step and the velocity coefficient of the termination by the coupling of two solvent radicals were estimated. The results of the calculation of the rate of each component reaction show that the following two reactions are the most important in the initiation and in the transfer and termination steps when the [S]/([A] + [B]) ratio is large: where, A, A*, and P are styrene, polystyryl radical, and the cooligomer, respectively. Moreover, it was concluded that the deviation of the cooligomer composition from the statistical steady-state composition was caused by these two reactions.     

On the use of methyl substituted poly(vinylnaphthalene) as a reversible singlet oxygen carrier

Poly(1,4-dimethyl-6-vinylnaphthalene) and poly(1,2,4-trimethyl-6-vinylnaphthalene) react with singlet oxygen to give corresponding endoperoxide polymers which on warming generate singlet oxygen efficiently. Singlet oxygenations by the use of these polymers have been described.