Bioelectrochemical determination of lactic and malic acids in wine

Electroanalytical methods based on biosensor technology and differential pH measurement for the determination of l-lactic and l-malic acids in wine were developed. Lactic acid was determined according to two procedures consisting of the use of two lactate electrochemical biosensors, one based on a Clark O(2) probe and the other based on the H(2)O(2) probe. The two probes were assembled employing a polymeric membrane where the enzyme lactate oxidase was previously immobilized. Both sensors exhibited high storage and operational stabilities, and good reproducibility when used in wine matrix. Measurement of lactate was carried out using two different flow-through cells assembled with the lactate probes. The low detection limit of these probes and the relatively high concentration of lactate in wine samples required a serial dilution in the range 1:100 to 1:200, thus eliminating all potential electrochemical or enzyme interferences present in the sample. Malic acid was determined using a differential commercially available pH-meter and an enzymatic procedure. For this analysis, we employed the malic enzyme (EC 1.1.1.40) and the NADP(+) cofactor. The pH variation due to the action of this enzyme on malic acid was found to be proportional to the malic acid present in the sample. Experimental parameters such as pH, temperature, and co-factor concentration were optimized, resulting in malate determination in less than 1 min with good reproducibility. Various samples of wine and wine musts were assayed for lactate with the two biosensor procedures, and for malate with differential pH-metry. The results when compared with those obtained with the commonly used spectrophotometric procedure correlated well.     

Simulation model for shapiro time delay and light deflection experiments

The time delay experiment proposed by I.I. Shapiro in 1964 and conducted in the seventies was the most precise experiment of general relativity until that time. Further experimentation has improved the accuracy level of both the time delay and the light deflection experiments. A simulation model is proposed that involves only a simple mass and time transformation factor involving velocity of light. The light deflection and the time delay experiments are numerically simulated using this model that does not use the general relativistic equations. The computed values presented in this paper compare well with recent levels of accuracy of their respective experimental results.     

Molecularly Imprinted Polymers Combined with Electrochemical Sensors for Food Contaminants Analysis

Detection of relevant contaminants using screening approaches is a key issue to ensure food safety and respect for the regulatory limits established. Electrochemical sensors present several advantages such as rapidity; ease of use; possibility of on-site analysis and low cost. The lack of selectivity for electrochemical sensors working in complex samples as food may be overcome by coupling them with molecularly imprinted polymers (MIPs). MIPs are synthetic materials that mimic biological receptors and are produced by the polymerization of functional monomers in presence of a target analyte. This paper critically reviews and discusses the recent progress in MIP-based electrochemical sensors for food safety. A brief introduction on MIPs and electrochemical sensors is given; followed by a discussion of the recent achievements for various MIPs-based electrochemical sensors for food contaminants analysis. Both electropolymerization and chemical synthesis of MIP-based electrochemical sensing are discussed as well as the relevant applications of MIPs used in sample preparation and then coupled to electrochemical analysis. Future perspectives and challenges have been eventually given.     

Determination of the two major endocannabinoids in human plasma by μ-SPE followed by HPLC-MS/MS

Endocannabinoids (ECs) are endogenous compounds that interact with type-1 and type-2 cannabinoid receptors (CB₁ and CB₂), as well as non-cannabinoid receptors. The multitude of roles attributed to ECs makes them an emerging target of pharmacotherapy for a number of disparate diseases. Here a high-throughput bioanalytical method based on micro SPE (μ-SPE) followed by LC-MS/MS analysis for the simultaneous determination of the two major endocannabinoids 2-arachidonoylglycerol (2-AG) and N-arachidonoylethanolamine (anandamide, AEA) in human plasma is presented. The chromatographic conditions obtained with the fused-core column allowed a good separation in 10 min also of the AG isomers. A very simple and reliable extraction has been optimised by means of C18-modified tips: it requires only 100 μL of plasma and allows the use of minimal volumes of organic solvent. The present method allows a rapid and effective clean-up, which also minimises the isomerisation of 2-AG. The whole procedure has been validated following the FDA guidelines for bioanalytical methods validation: the satisfactory recovery values, the negligible matrix effect and the good values of accuracy and reproducibility make it a simple and high-throughput analytical tool for clinical and biochemical studies on endocannabinoid signaling in humans.

Multiplexed Determination of Amino‐Terminal Pro‐B‐Type Natriuretic Peptide and C‐Reactive Protein Cardiac Biomarkers in Human Serum at a Disposable Electrochemical Magnetoimmunosensor

A rapid magnetoimmunosensor for the simultaneous determination of two cardiac biomarkers, amino‐terminal pro‐B‐type natriuretic peptide (NT‐proBNP) and C‐reactive protein (CRP), in human serum is described. Specific capture antibodies were covalently immobilized onto carboxylic acid‐modified magnetic beads. The quantification of NT‐proBNP and CRP was performed by using indirect competitive and sandwich configurations, respectively, and horseradish peroxidase‐labeled tracers. The use of dual screen‐printed carbon electrodes allowed the achievement of simultaneous independent amperometric readout for each cardiac biomarker. The developed methodology showed very low limits of detection (0.47 ng mL^?1). An international standard for CRP serum spiked with NT‐proBNP was analyzed to evaluate the usefulness of the magnetoimmunosensor.     

Monoclonal antibody based electrochemical immunosensor for the determination of ochratoxin A in wheat

Competitive electrochemical enzyme-linked immunosorbent assays based on disposable screen-printed electrodes have been developed for quantitative determination of ochratoxin A (OTA). The assays were carried out using monoclonal antibodies in the direct and indirect format. OTA working range, I₅₀ and detection limits were 0.05-2.5 and 0.1-7.5 μg L⁻¹, 0.35 (±0.04) μg L⁻¹ and 0.9 (±0.1) μg L⁻¹, 60 and 100 μg L⁻¹ in the direct and indirect assay format, respectively. The immunosensor in the direct format was selected for the determination of OTA in wheat. Samples were extracted with aqueous acetonitrile and the extract analyzed directly by the assay without clean-up. The I₅₀ in real samples was 0.2 μg L⁻¹ corresponding to 1.6 μg/kg in the wheat sample with a detection limit of 0.4 μg/kg (calculated as blank signal −3σ). Within- and between-assay variability were less than 5 and 10%, respectively. A good correlation (r = 0.9992) was found by comparative analysis of naturally contaminated wheat samples using this assay and an HPLC/immunoaffinity clean-up method based on the AOAC Official Method 2000.03 for the determination of OTA in barley.     

NADH screen-printed electrodes modified with zirconium phosphate,Meldola blue,and Reinecke salt. Application to the detection of glycerol by FIA

Bulk screen-printed electrodes (bSPEs) modified with zirconium phosphate (ZrP) and Meldola blue (MB) and by electrochemical deposition of a Reineckate film (bMBZrPRs-SPEs) have been constructed and used as NADH sensors. Cyclic voltammetric investigation of these bulk electrochemically modified screen-printed electrodes revealed stable catalytic activity in oxidation of the reduced form of the coenzyme nicotinamide adenine dinucleotide (NADH). Flow-injection analysis (FIA) coupled with amperometric detection confirmed the improved stability of the bMBZrPRs-SPEs (10⁻⁴ mol L⁻¹ NADH, %RSD = 4.2, n = 90, pH 7.0). Other conditions, for example applied working potential (+50 mV relative to Ag|AgCl), flow rate (0.30 mL min⁻¹) and pH-dependence (range 4.0–10.0) were evaluated and optimized. A glycerol biosensor, prepared by immobilizing glycerol dehydrogenase (GDH) on the working electrode area of a bMBZrPRs-SPE, was also assembled. The biosensor was most stable at pH 8.5 (%RSD = 5.6, n = 70, 0.25 mmol L⁻¹ glycerol). The detection and quantification limits were 2.8 × 10⁻⁶ and 9.4 × 10⁻⁶ mol L⁻¹, respectively, and the linear working range was between 1.0 × 10⁻⁵ and 1.0 × 10⁻⁴ mol L⁻¹. To assess the effect of interferences, and recovery by the probe we analyzed samples taken during fermentation of chemically defined grape juice medium and compared the results with those obtained by HPLC.     

Electrochemical oxidation of ochratoxin A at a glassy carbon electrode and in situ evaluation of the interaction with deoxyribonucleic acid using an electrochemical deoxyribonucleic acid-biosensor

Ochratoxin A (OTA) is a fungal metabolite that occurs in foods, beverages, animal tissues, human blood and presents carcinogenic, teratogenic and nephrotoxic properties. This study concerns the redox properties of OTA using electrochemical techniques which have the potential for providing insights into the biological redox reactions of this molecule. The in situ evaluation of the OTA interaction with DNA using a DNA-electrochemical biosensor is also reported.The oxidation of OTA is an irreversible process proceeds with the transfer of one electron and one proton in a diffusion-controlled mechanism. The diffusion coefficient of OTA was calculated in pH 7 phosphate buffer to be D_O = 3.65 × 10⁻⁶ cm² s⁻¹. The oxidation of OTA is also pH dependent for electrolytes with pH < 7 and involves the formation of a main oxidation product which adsorbs strongly at the GCE surface undergoing reversible oxidation. In alkaline electrolytes OTA undergoes chemical deprotonation, the oxidation involving only the transfer of one electron.The electrochemical dsDNA-biosensor was also used to evaluate the possible interaction between OTA and DNA. The experiments have clearly proven that OTA interacts and binds to dsDNA strands immobilized onto a GCE surface, but no evidence of DNA-damage caused by OTA was obtained.     

Electrochemical genosensors for the detection of Bonamia parasite. Selection of single strand-DNA (ssDNA) probes by simulation of the secondary structure folding

A post-PCR nucleic acid work by comparing experimental data, from electrochemical genosensors, and bioinformatics data, derived from the simulation of the secondary structure folding and prediction of hybridisation reaction, was carried out in order to rationalize the selection of ssDNA probes for the detection of two Bonamia species, B. exitiosa and B. ostreae, parasites of Ostrea edulis.Six ssDNA probes (from 11 to 25 bases in length, 2 thiolated and 4 biotinylated) were selected within different regions of B. ostreae and B. exitiosa PCR amplicons (300 and 304 bases, respectively) with the aim to discriminate between these parasite species. ssDNA amplicons and probes were analyzed separately using the “Mfold Web Server” simulating the secondary structure folding behaviour. The hybridisation of amplicon-probe was predicted by means of “Dinamelt Web Server”. The results were evaluated considering the number of hydrogen bonds broken and formed in the simulated folding and hybridisation process, variance in gaps for each sequence and number of available bases. In the experimental part, thermally denatured PCR products were captured at the sensor interface via sandwich hybridisation with surface-tethered probes (thiolated probes) and biotinylated signalling probes. A convergence between analytical signals and simulated results was observed, indicating the possibility to use bioinformatic data for ssDNA probes selection to be incorporated in genosensors.     

Screening of rationally designed oligopeptides for Listeria monocytogenes detection by means of a high density colorimetric microarray

The aim of this work was to optimize, by means of molecular modeling software, biomimetic-based traps for pathogen detection suitable for analytical applications like screening or pre-analytical methods. The pathogen prototype system chosen was Listeria monocytogenes because of the large number of X ray and NMR structures available. 298 oligopeptides were computationally designed mimicking the binding pocket of the mammalian protein E-cadherin, the target of Listeria monocytogenes adhesion, internalin A. The contribution of individual peptides to bind was investigated using FRED, a protein-ligand docking program. Ten peptides were selected for experimental analysis taking as selection parameters the length, the position in the docking pocket and the score of simulated binding energy. A series of competition assays were carried out using high density colorimetric microarray using various bacteria species (Listeria monocytogenes, Listeria monocytogenes genetically modified without internalin A, Listeria innocua and Lactococcus lactis) in solution with computationally selected peptides. The data demonstrated that peptides could be able to distinguish Listeria monocytogenes with an EC₅₀ up to 10⁷cfu × mL^?1. In particular the peptide with the best calculated binding score gave the highest statistically unambiguous response toward Listeria monocytogenes compared to other bacteria, demonstrating that rationally simulated approach can be useful as preliminary screening in the choice of biomimetic ligands.