Temperature Controlled Filamentation in Argon Gas

Temperature controlled filamentation is experimentally demonstrated in a temperature gradient gas-filled tube. The proper position of the tube is heated by a furnace and two ends of the tube are cooled by air. The experimental results show that multiple filaments are shrunken into a single filament or no filament only by increasing the temperature at the beginning of the filament. This technique offers another degree of freedom of controlling the filamentation and opens a new way for intense monocycle pulse generation through gradient temperature in a noble gas.     

Femtosecond laser pulse filamentation versus optical breakdown in H<Subscript>2</Subscript>O

The competition between femtosecond laser pulse induced optical breakdown and femtosecond laser pulse filamentation in condensed matter is studied both experimentally and numerically using water as an example. The coexistence of filamentation and breakdown is observed under tight focusing conditions. The development of the filamentation process from the creation of a single filament to the formation of many filaments at higher pulse energy is characterized systematically. In addition, strong deflection and modulation of the supercontinuum is observed. They manifest themselves at the beginning of the filamentation process, near the highly disordered plasma created by optical breakdown at the geometrical focus. Received: 9 July 2002 / Revised version: 15 November 2002 / Published online: 19 March 2003 RID="*" ID="*"Corresponding author. Fax: +1-418/6562-623, E-mail: wliu@phy.ulaval.ca     

Long-range spectrally and spatially resolved radiation from filaments in air

The distance-resolved spectral intensity distribution of the backscattered light from long filaments generated in air using ultra-short and intense laser pulses is presented. A clean fluorescence spectrum from N₂ molecules and ions, which is produced by the high peak intensity inside the plasma filament of the fundamental pulse, was clearly resolved from the backscattered supercontinuum. The supercontinuum generated by both the fundamental and the third-harmonic pulses developed progressively and became fully developed only at the end of the filamentation.     

Propagation of fs TW laser filaments in adverse atmospheric conditions

The propagation of femtosecond terawatt laser pulses at reduced pressure (0.7 atm) is investigated experimentally. In such conditions, the non-linear refractive index n ₂ is reduced by 30%, resulting in a slightly farther filamentation onset and a reduction of the filament number. However, the filamentation process, especially the filament length, is not qualitatively affected. We also show that drizzle does not prevent the filaments from forming and propagating.     

Background reservoir: its crucial role for long-distance propagation of femtosecond laser pulses in air

We report an experiment to demonstrate the crucial effect of the so-called background reservoir during the propagation of femtosecond laser pulses in air. The background reservoir was blocked by allowing only the filament to pass through a pinhole generated by the filament itself in an aluminum foil. We observed that the filamentation process is terminated immediately after the pinhole. Consequently, to achieve long-range filamentation, it is necessary to maintain the dynamic energy exchange between the reservoir and the self-foci.     

Filamentation control in the temperature gradient argon gas

A novel technique of controlling the evolution of the filamentation was experimentally demonstrated in an argon gas-filled tube. The entrance of the filament was heated by a furnace and the other end was cooled with air, which resulted in the temperature gradient distribution along the tube. The experimental results show that multiple filaments are merged into a single filament and then no filament by only increasing the temperature at the entrance of the filament. Also, the filament can appear and disappear after increasing the local temperature and input pulse energy in turn. This technique offers another degree of freedom to control the filamentation and opens a new way for multi-mJ level monocycle pulse generation through filamentation in the noble gas.     

A LIDAR technique to measure the filament length generated by a high-peak power femtosecond laser pulse in air

We demonstrate a new method for measuring the length of a femtosecond laser pulse induced filament in air using a LIDAR (LIght Detection And Ranging) technique. The LIDAR involves a detector with a fast response time. The back-scattered multiphoton induced fluorescence from nitrogen molecules excited inside the filament is measured, from which the length of the filament can be determined. We find good agreement between the measured filament length and the length estimated from burn patterns on paper. In addition, good qualitative agreement between the experimental measurement and numerical simulations is obtained for the signal features of the filament. We propose that this new method can be used to quantitatively determine filamentation at longer distances. Received: 11 June 2002 / Revised version: 21 October 2002 / Published online: 5 February 2003 RID="*" ID="*"Corresponding author. Fax: +1-418/656-2623, E-mail: aiwasaki@phy.ulaval.ca     

Filamentation of ultrashort light pulses in a liquid scattering medium

We have studied filamentation of 1-ps laser pulses in a scattering medium (aqueous suspension of 2-μm polystyrene microspheres) and compared filamentation dynamics to that in pure water. Our results indicate that light scattering does not alter filamentation dynamics in general, but rather results in farther position of the nonlinear focus, shorter filament length, and the development of speckle structure in the peripheral part of the beam. The experimental observations are qualitatively reproduced by the numerical model which accounts for diffraction, self-focusing, multiphoton absorption, and light scattering introduced through a stochastic diffusion and diffraction term.     

Femtosecond filamentation in air at low pressures. Part II: Laboratory experiments

We present experimental studies of filamentation of a femtosecond laser pulse in air at low pressures. The evolution of the filament has been studied by measuring along the propagation axis the conductivity and the sub-THz emission from the plasma channel. We show experimentally that the filamentation process occurs at pressures as low as 0.2 atm in agreement with numerical simulations. Experimental and numerical results [A. Couairon, M. Franco, G. Méchain, T. Olivier, B. Prade, A. Mysyrowicz, Opt. Commun., submitted for publication] are compared and the possible sources of discrepancy are discussed.     

Influence of Initial Pulse Chirp on Rainbow-Like Supercontinuum Generation from Filamentation in Air

Supereontinuum （SC） generation from laser filamentation in air is found to depend strongly on the pulse duration. Rainbow-like SC generation is observed only for a pulse of appropriate negative chirp that agrees with the predictions put forward by Golubtsov et al. [Quantum Electron. 33 （2003） 525]. The conversion efficiency of an 800-nm laser light to rainbow-like SC is found to be the highest for 257fs pulses with an initial negative chirp. A larger chirp will lead to filamentation surviving at longer distance.     

Measurement of filament length generated by an intense femtosecond laser pulse using electromagnetic radiation detection

We present a new method to measure the length of a filament induced by the propagation of intense femtosecond laser pulses in air. We used an antenna to detect electromagnetic pulses radiated from multipole moments inside the filament oscillating at the plasma frequency. The results are compared with the values detected from the backscattered fluorescence induced by multiphoton ionization of nitrogen molecules excited inside the filament. The values are found to be in good agreement. Received: 6 November 2002 / Revised version: 27 January 2003 / Published online: 24 April 2003 RID="*" ID="*"Corresponding author. Fax: +1-418/656-2623, E-mail: shosseini@phy.ulaval.ca     

Femtosecond filamentation in air at low pressures: Part I: Theory and numerical simulations

We investigate numerically the influence of the pressure on femtosecond filamentation in air. We show that femtosecond filamentation occurs at low pressure and compute the features of the plasma channel generated in the wake of the pulse. We discuss the influence of the pulse duration, chirp and input beam shape on the length of the plasma channels. These calculations constitute a prerequisite for laboratory experiments over short distances as well as for vertical femtosecond filamentation at high altitude on which light detection and ranging techniques or lightning protection rely.     

Filamentation of femtosecond laser pulses in turbulent air

Formation and wandering of filaments in air are studied both experimentally and numerically. Filament-center deflections are collected from 1100 shots of 190-fs and 800-nm pulses in the plane perpendicular to the propagation direction. To calculate the filament wandering in air we have developed a model of powerful femtosecond laser pulse filamentation in the Kolmogorov atmospheric turbulence and employed the Monte Carlo method to model the propagation of several hundred laser pulses. Statistical processing of experimental and numerical data shows that filament-center displacements in the transverse plane obey the Rayleigh-distribution law. Parameters of the Rayleigh distribution obtained for numerical and experimental data are close to each other. Received: 23 May 2001 / Revised version: 26 September 2001 / Published online: 29 November 2001     

Optical vortices in self-focusing Kerr nonlinear media

In this work we numerically compare the interaction of optical vortices (OVs) in self-defocusing and self-focusing Kerr nonlinear media. We find that the basic scenarios (attraction/repulsion, translation/rotation vs. background) in the interaction of two and three vortices with equal and alternative topological charges (TCs) are the same in both media. However, the vortex dynamics under self-focusing conditions is influenced by the reshaping of the surrounding part of the background. Square structure of OVs with alternating TCs is found to be stable with respect to the vortex positions in self-focusing media. This elementary cell is successfully generalized in a large square array of OVs with alternative TCs which brings ordering in the multiple filamentation of the background beam in self-focusing conditions.     

White-Light Nonlinear Photonic Lattices in Self-Defocusing Media

Using fully incoherent white light emitted from an incandescent lamp and amplitude mask, we experimentally investigate the influence of several factors on the fabrication of the lattice in photovoltaic self-defocusing LiNbO3：Fe crystal, the factors include the orientation of the crystalline c axis relative to the principal axis of the photonic lattice and the filament, the diameter of input dark spot and the separation of the adjacent input dark spots. Experimental results reveal that the best fabricating condition of photonic lattices is that the principal axis of lattice is tilted for 45^o relative to the crystalline c axis which is parallel to the filament of the lamp. In addition, it is necessary that the diameter of the input dark spot is larger than the half of their separation.     

Random deflection of the white light beam during self-focusing and filamentation of a femtosecond laser pulse in water

Ti:sapphire femtosecond laser pulse filamentation in competition with optical breakdown in condensed matter is studied both experimentally and numerically using water as an example. Strong random deflection and modulation of the supercontinuum under tight focusing conditions were observed. They manifest the beginning of the filamentation process near the highly disordered plasma created by optical breakdown at the geometrical focus. Received: 13 June 2002 / Revised version: 16 August 2002 / Published online: 25 October 2002 RID="*" ID="*"Corresponding author. Fax: +1-418/656-2623, E-mail: wliu@phy.ulaval.ca     

Transverse evolution of a plasma channel in air induced by a femtosecond laser

We investigate the evolution of filamentation in air by using a longitudinal diffraction method and a plasma fluorescence imaging technique. The diameter of a single filament in which the intensity is clamped increases as the energy of the pump light pulse increases, until multiple filaments appear.     

Elliptically polarized Terahertz emission through four-wave mixing in a two-color filament in air

We diagnosed the polarization characteristics of Terahertz emission from a two-color femtosecond laser filament when the polarizations of ω and 2ω beams are orthogonal. We discovered that the THz pulse is elliptically polarized. The generation mechanism could be through four-wave optical rectification inside the filament zone where the inversion symmetry of air is broken.     

利用空心光纤探测飞秒脉冲在氩气中成丝过程中的光谱演变

采用420μm纤芯直径、18cm长的空心光纤作为探测器，在强飞秒激光在氩气中成丝的条件下，研究了成丝不同部位的光谱变化.实验结果表明由于成丝范围内不同部位的脉冲宽度不一样，导致空心光纤位于成丝的不同位置时所获得的光谱展宽也不尽相同.在成丝长度范围内的特定位置可以将50fs入射脉冲最窄压缩至24.8fs.