Determination of molecular weight and its distribution of rigid‐rod polymers determined by phase‐modulated flow birefringence technique

The phase‐modulated flow birefringence (PMFB) method is widely accepted as one of the most sensitive and accurate techniques suitable for experimental tests on the molecular theory of polymer solutions. The objective of this study is to develop a systematic method to determine molecular weight and distribution of rigid‐rod polymers by the PMFB technique. Using molecular theory for rigid polymers, birefringence Δn and orientation angle χ have been expressed as a function of molecular weight and distribution. Δn has been shown to be proportional to Σc_iM, and cot 2χ turned out to have a linear relationship with Σc_iM/Σc_iM. From the experimental results for PBLG solutions, birefringence and orientation angle data were in some degree matched with the theory presented. © 2000 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 38: 509–515, 2000     

The development of charge detection-quadrupole ion trap mass spectrometry driven by rectangular and triangular waves

In this article, the charge detection quadrupole mass spectrometry (CD-ITMS) driven by rectangular and triangular waveforms (rect-CD-ITMS and tri-CD-ITMS) was developed for the characterization of microparticles. Since the frequency scan of rectangular and triangular waveform could be realized easier than that of sinusoidal waveform, this research intends to provide simpler operation modes for CD-ITMS. In order to demonstrate the feasibility of rect-CD-ITMS and tri-CD-ITMS, the discharge onset voltage, ejection point of analyzed particles, and the achieved mass resolution were analyzed and compared with the case in conventional sinusoidal CD-ITMS (sin-CD-ITMS). The results indicated that the rect-CD-ITMS and tri-CD-ITMS can work well for the mass measurement of microparticles by using frequency scan. Identical mass resolutions were achieved under the same root mean square (RMS) voltage of different waveforms. The mass resolution was further improved by increasing the applied voltage and signal-to-noise ratio (S/N) of charge detector. Moreover, the rect-CD-ITMS and tri-CD-ITMS were applied to characterize red blood cells (RBCs). According to the obtained mean masses and mass distributions, normal and anemic RBCs were distinguished successfully.     

Travelling‐wave ion mobility and negative ion fragmentation of high‐mannose N‐glycans

The isomeric structure of high‐mannose N‐glycans can significantly impact biological recognition events. Here, the utility of travelling‐wave ion mobility mass spectrometry for isomer separation of high‐mannose N‐glycans is investigated. Negative ion fragmentation using collision‐induced dissociation gave more informative spectra than positive ion spectra with mass‐different fragment ions characterizing many of the isomers. Isomer separation by ion mobility in both ionization modes was generally limited, with the arrival time distributions (ATD) often showing little sign of isomers. However, isomers could be partially resolved by plotting extracted fragment ATDs of the diagnostic fragment ions from the negative ion spectra, and the fragmentation spectra of the isomers could be extracted by using ions from limited areas of the ATD peak. In some cases, asymmetric ATDs were observed, but no isomers could be detected by fragmentation. In these cases, it was assumed that conformers or anomers were being separated. Collision cross sections of the isomers in positive and negative fragmentation mode were estimated from travelling‐wave ion mobility mass spectrometry data using dextran glycans as calibrant. More complete collision cross section data were achieved in negative ion mode by utilizing the diagnostic fragment ions. Examples of isomer separations are shown for N‐glycans released from the well‐characterized glycoproteins chicken ovalbumin, porcine thyroglobulin and gp120 from the human immunodeficiency virus. In addition to the cross‐sectional data, details of the negative ion collision‐induced dissociation spectra of all resolved isomers are discussed. Copyright © 2016 John Wiley & Sons, Ltd.     

Closed‐form rectangular atomic wave functions of an N‐dimensional atom

A closed‐form expression has been derived to obtain the N‐dimensional rectangular atomic wave functions. The wave functions can be obtained straightforwardly with the knowledge of the angular momentum quantum numbers and the dimension and there is no need to employ recursive methods as in previous works. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem 88: 263–274, 2002     

Temperature‐dependent phase‐segregation behavior and antifouling performance of UV‐curable methacrylated PDMS/PEG coatings

Controllable phase segregation adjustment for immiscible polymer blends has always been tough, which hinders the development of amphiphilic antifouling coatings from more accessible blends. Herein, methacrylated poly(dimethylsiloxane) (PDMS‐MA) was synthesized and mixed with poly(ethylene glycol)methylether methacrylate (PEG‐MA). It was interestingly discovered that these PDMS‐MA/PEG‐MA blends displayed upper critical solution temperatures (UCST) due to thermo‐induced conformational change of PEG‐MA and the UCST changed with PDMS‐MA/PEG‐MA mass ratios. Micro‐/nano‐phase segregation, nanophase segregation, or homogenous morphology were therefore achieved. These PDMS‐MA/PEG‐MA blends with different mass ratios were UV‐cured under varying temperatures to fabricate coatings. Their surface morphology and wettability are readily adjusted by phase segregation. For the first time, highly hydrophilic surface was achieved for coatings with microphase segregation because of the exposure of PEG‐rich domains, which exhibited an enhanced protein resistance against bovine serum albumin (BSA). Anti‐bacterial performance (Shewanella loihica) was also observed for these PDMS/PEG coatings. © 2016 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2016 , 54, 1612–1623     

Travelling‐wave ion mobility mass spectrometry and negative ion fragmentation of hybrid and complex N‐glycans

Nitrogen collisional cross sections (CCSs) of hybrid and complex glycans released from the glycoproteins IgG, gp120 (from human immunodeficiency virus), ovalbumin, α1‐acid glycoprotein and thyroglobulin were measured with a travelling‐wave ion mobility mass spectrometer using dextran as the calibrant. The utility of this instrument for isomer separation was also investigated. Some isomers, such as Man₃GlcNAc₃ from chicken ovalbumin and Man₃GlcNAc₃Fuc₁ from thyroglobulin could be partially resolved and identified by their negative ion fragmentation spectra obtained by collision‐induced decomposition (CID). Several other larger glycans, however, although existing as isomers, produced only asymmetric rather than separated arrival time distributions (ATDs). Nevertheless, in these cases, isomers could often be detected by plotting extracted fragment ATDs of diagnostic fragment ions from the negative ion CID spectra obtained in the transfer cell of the Waters Synapt mass spectrometer. Coincidence in the drift times of all fragment ions with an asymmetric ATD profile in this work, and in the related earlier paper on high‐mannose glycans, usually suggested that separations were because of conformers or anomers, whereas symmetrical ATDs of fragments showing differences in drift times indicated isomer separation. Although some significant differences in CCSs were found for the smaller isomeric glycans, the differences found for the larger compounds were usually too small to be analytically useful. Possible correlations between CCSs and structural types were also investigated, and it was found that complex glycans tended to have slightly smaller CCSs than high‐mannose glycans of comparable molecular weight. In addition, biantennary glycans containing a core fucose and/or a bisecting GlcNAc residue fell on different mobility‐m/z trend lines to those glycans not so substituted with both of these substituents contributing to larger CCSs. Copyright © 2016 John Wiley & Sons, Ltd.     

Design and performance of a novel electrospray interface

In this work a new electrospray system has been developed which employs heat as a means of desolvation and requires no counterflow of heated gas. This article describes the operation and performance of this device, with particular emphasis on the differences between it and those described earlier. Results are presented that illustrate the dependence of signal intensity on ion source and spray chamber temperatures and on the composition and flow rate of mobile phase into the electrospray. Results on proteins electrosprayed from aqueous solutions are presented including a bacterial protease which has a tight tertiary structure. The ability to obtain fragmentation data by collisionally induced dissociation in the interface is also discussed.     

Theoretical and experimental evaluation of the low m/z transmission of an electrodynamic ion funnel

The transmission of ions at low m/z can often be either necessary for an application or problematic (e.g., when large numbers of low m/z ions consume a large fraction of an ion trap's capacity). The low m/z ion transmission limit of an electrodynamic ion funnel has been characterized using both experimental and theoretical approaches. A theoretical model is developed based on a series of infinite wire conductors that represent the ring electrodes of the ion funnel. Mathematical relationships for both low and high m/z cutoffs of the idealized two-dimensional system are derived. The low m/z cutoff is also evaluated through a series of experiments that show it is influenced by both the RF frequency and the DC electric field gradient. However, unlike multipole ion guides, there is no marked dependence of the low m/z cutoff on the RF amplitude, in agreement with theoretical results. With this new understanding, ion funnels can be designed and configured to better match the m/z range requirements for various applications.     

Efficient evaluation of Coulomb integrals in a mixed Gaussian and plane‐wave basis

An efficient way of calculation is presented for matrix elements between two plane waves interacting with a molecular Coulombic field. In concurrence with the absolute value of the momentum transfer vector, K = k₁ ? k ₂ , the most effective method of calculation is selected. The case of K = 0 requires special treatment. For 0 < |K| ≤ 0.3, it is profitable to evaluate the integrals by means of the multipole expansion, and for |K| > 0.3 the density fitting can be applied. For the large |K| the electronic part of the integral is much smaller than the nuclear part and the integral may be approximated by the nuclear contribution only. Some examples for testing the accuracy and time saved are presented. The primary purpose of this paper is to accelerate electron scattering calculations, but it also may be profitable for the electronic structure theory in attempts to use mixed Gaussian and plane‐wave basis sets. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

Ion motion in the rectangular wave quadrupole field and digital operation mode of a quadrupole ion trap mass spectrometer

A quadrupolar electric field driven by a rectangular wave voltage can be used for mass-selective storage and analysis. The ion motion in such an electric field is derived, and the stability of ions is presented in the a-q diagram that is commonly used for sinusoidal wave quadrupole mass spectrometry in association with the solution of the Mathieu equation. The pseudo-potential well is discussed in an approximation that leads to the relation of secular frequency to operating parameters. A scheme for a digital ion trap mass spectrometer is described, based on this theory. An ion optics simulation was performed to check the theory of resonant ejection, and to prove the feasibility of the mass scan method for a practical ion trap of such geometry.     

Design and synthesis of a magnetic hierarchical porous organic polymer: A new platform in heterogeneous phase‐transfer catalysis

Recyclable phase transfer catalysts containing magnetic nanoparticles (MNPs) have been known as a major trend towards sustainable catalysts. In this study, a novel class of magnetic porous polymer on the basis of calix[4]resorcinarene was synthesized starting from silica‐coated Fe₃O₄ core‐shell nanoparticles. This compound was found as an efficient phase transfer catalyst to the conversion of benzyl halides into benzyl azides and cyanides in good yields. The catalyst could be used at least for five consecutive cycles without appreciable loss in the catalytic activity.     

Electro‐driven extraction of inorganic anions from water samples and water miscible organic solvents and analysis by ion chromatography

A simple electromembrane extraction (EME) procedure combined with ion chromatography (IC) was developed to quantify inorganic anions in different pure water samples and water miscible organic solvents. The parameters affecting extraction performance, such as supported liquid membrane (SLM) solvent, extraction time, pH of donor and acceptor solutions, and extraction voltage were optimized. The optimized EME conditions were as follows: 1‐heptanol was used as the SLM solvent, the extraction time was 10 min, pHs of the acceptor and donor solutions were 10 and 7, respectively, and the extraction voltage was 15 V. The mobile phase used for IC was a combination of 1.8 mM sodium carbonate and 1.7 mM sodium bicarbonate. Under these optimized conditions, all anions had enrichment factors ranging from 67 to 117 with RSDs between 7.3 and 13.5% (n = 5). Good linearity values ranging from 2 to 1200 ng/mL with coefficients of determination (R²) between 0.987 and 0.999 were obtained. The LODs of the EME‐IC method ranged from 0.6 to 7.5 ng/mL. The developed method was applied to different samples to evaluate the feasibility of the method for real applications.     

Preparation and performance of novel temperature‐resistant thickening agent

In this article, a novel kind of temperature‐resistant thickening agent (LK) was copolymerized with acrylamide, acrylic acid, sodium p‐styrenesulfonate, and dimethyl diallyl ammonium chloride via free radical copolymerization. The polymerization conditions were optimized by the single‐variable method. Subsequently, the structure of the copolymer was characterized through Fourier transform infrared spectroscopy and proton nuclear magnetic resonance. Thermal gravimetric analysis demonstrates that the thickening agent LK has an excellent ability of temperature‐resistance and the degradation temperature of the copolymer is higher than 300°C. The 3‐dimensional network structure formed in the fracturing fluid was observed via experimental results of scanning electron microscopy. Several aspects of the properties of fracturing gel system, such as temperature and shear tolerance, salt resistance and viscoelasticity, and gel breaking and filter loss were evaluated. Results indicates that the fracturing gel system presents good comprehensive performances under high‐temperature condition.