Hopping conduction in “pure” polypropylene

A recently developed theory of steady-state conduction in high-density polyethylene is applied to “pure” polypropylene (PP) in the temperature range 50–93°C. Morphological changes occur in PP, including a disordered-amorphous to monoclinic-amorphous transition between 50 and 80°C, where, with increasing temperature T, free volume increases, and decreases with decreasing amorphous fraction. The latter competing processes lead to large increases in hopping site separation, λ, in the transition region, followed either by saturation or a maximum in λ vs. T. We speculate that segmental and/or main chain molecular motions lower apparent activation energies, are “pinned“ by applied field, and impeded by dangling bonds in regions surrounding the surfaces of crystallites. Our analysis is semi-quantitative only, because the latter mechanisms have not been adequately quantified, and the relative contributions of each are unknown. Measurements were carried out on heated and cooled disordered-amorphous, and 106°C, 17-h annealed, 43% crystalline samples. Hopping distances, obtained from measured current vs. applied field characteristics, ranged from 1.2 to 5.2 nm. Apparent activation energies up to 1.80 eV were obtained from In (I/T) vs. (1/T) plots. Remarkable plateaus in the temperature range of the transition were observed in these plots, implying some carrier conduction with near zero activation energy. Possible explanations for the latter, and the electronic nature of the carriers are given. X-ray and density flotation measurements enabled crystallinity determinations. © 1994 John Wiley & Sons, Inc.     

Generation of “Sumanenylidene”: A Ground‐State Triplet Carbene on a Curved π‐Conjugated Periphery

We have observed the generation of sumanenylidene ( 2 ), a divalent, neutral‐carbon species at the benzylic position of sumanene ( 1 ). We also clarified both experimentally and theoretically that the ground state of compound 2 was a triplet state and that its singlet–triplet energy gap (ΔE_ST) was similar to that in fluorenylidene. The curved structure of compound 2 led to slightly better spin delocalization over the two adjacent aromatic rings than in planar systems, because of the unpaired spins on the σ and π orbitals. Synthetic application of the carbene precursor, diazosumanene ( 5 ), with a variety of thiocarbonyl compounds revealed its utility for the preparation of tetrasubstituted alkene compounds (e.g., that contain a strongly electron‐donating unit) that are directly conjugated to the sumanene ( 1 ) moiety.     

Drug Design of “Undruggable” Targets

Drug innovation is not only reflected in the discovery of new chemotypes of active compounds against existing targets but also more dependent on the innovation of drug targets. Currently, a number of attractive and validated targets could not be targeted pharmacologically. Some have been described as “undruggable”. In this review, we summarized the current situation of “undruggable” targets, and the design strategies for “undruggable” targets, hoping to provide references for the development of innovative drugs.     

On the applicability of the “abt” concept

Kaiser's “abt” concept rests on the experimental establishment of a linear relation between band width at half height, b_0.5, and capacity ratio, k, according to His column specification quantity, h_real, is dependent on the square of the slope a, obtained from a linear regression analysis based on this relation. It is shown in the present paper that an improvement of the experimental conditions leading to a lower extra-column contribution to band broadening, b, introduces a tendency towards a negative curvature in the plot at low k values. The mean slope increases, and an uncritical linear regression would yield an h_real-value which is higher than before and which would be in the opposite direction to the requirements of a reliable column specification. Generally the linear regression analysis has to be moved to higher k regions in cases of curvature, especially as it is also shown that h_real is an estimation of the traditional HETP value, H∞, that would be obtained when k approaches infinity. This theoretically expected relation is a strong motivation for the use of h_real as a column specification, since the b_0.5-value associated with H∞ is expected to be practically independent of b.     

On the “Wolfsberg–Helmholz Conjecture” of “Extended‐Hückel Theory”

After having reviewed some pioneer integral approximations closely related to Rüdenberg's expansions of one‐ and two‐electron orbital products, we apply the previously described “Implicit Multi‐Center Integration” techniques on Roothaan's “restricted” Fock‐matrix components over standard atomic orbital bases. The resulting compact forms are very similar to the well‐known “Wolfsberg–Helmholz Conjecture” of “Extended‐Hückel Theory,” which relates the various off‐diagonal matrix elements of “restricted” Fock‐type to their corresponding diagonal counterparts. In this way, a “nonempirical Extended‐Hückel Theory” can be created. © 2012 Wiley Periodicals, Inc.     

Synthesis and characterization of star graft copolymers with asymmetric mixed “V‐shaped” side chains via “click” chemistry on a hyperbranched polyglycerol core

The star graft copolymers composed of hyperbranched polyglycerol (HPG) as core and well defined asymmetric mixed “V‐shaped” identical polystyrene (PS) and poly(tert‐butyl acrylate) as side chains were synthesized via the “click” chemistry. The V‐shaped side chain bearing a “clickable” alkyne group at the conjunction point of two blocks was first prepared through the combination of anionic polymerization of styrene (St) and atom transfer radical polymerization of tert‐butyl acrylate (tBA) monomer, and then “click” chemistry was conducted between the alkyne groups on the side chains and azide groups on HPG core. The obtained star graft copolymers and intermediates were characterized by gel permeation chromatography (GPC), GPC equipped with a multiangle laser‐light scattering detector (GPC‐MALLS), nuclear magnetic resonance spectroscopy and fourier transform infrared. © 2009 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 47: 1308–1316, 2009     

Preparation of phenolic microspheres in water/“water” system

Phenolic microspheres were obtained by condensation of resorcinol and formaldehyde via a novel water/“water” suspension polymerization (WWSP) system, which was proposed and constructed for the first time. Resorcinol/formaldehyde aqueous solutions, ammonium sulfate aqueous solution, hydroxyethyl cellulose (HEC), and sodium hydroxyl were employed as water phase, “water” phase, stabilizer for protecting colloid, and catalyst, respectively. Stable and perfect phenolic microspheres were prepared in this special WWSP system. Particle sizes, size distribution, as well as morphology of microspheres were investigated by scanning electron microscope and computerized image analysis program. The results showed that particle size increased from 0.38 to 2.22 µm along with the increase of concentration of ammonium sulfate in “water” phase from 1.5% to 12.5% and the ratio of resorcinol to formaldehyde from 1:1.5 to 1:4. On the contrary, the particle size decreased from 1.80 to 0.30 µm with the increase of the amount of HEC from 0.1 to 1.0 g and amount of catalyst from 0.05 to 0.2 g. The polydispersity index value of the resulting microspheres is quite narrow, ranging from 1.01 to 1.30, which meant that the morphology of phenolic microspheres was unique. Copyright © 2011 John Wiley & Sons, Ltd.     

Block copolymers by transformation of “living” carbocationic into “living” radical polymerization. II. ABA-type block copolymers comprising rubbery polyisobutene middle segment

A general method for the transformation of “living” carbocationic into “living” radical polymerization, without any modification of chain ends, is reported for the preparation of ABA block copolymers. For example, α,ω-difunctional polyisobutene, capped with several units of styrene, Cl-St-PIB-St-Cl, prepared cationically (M_n = 7800, M_w/M_n = 1.31) was used as an efficient difunctional macroinitiator for homogeneous “living” atom transfer radical polymerization to prepare triblock copolymers with styrene, PSt-PIB-PSt (M_n = 28,800, M_w/M_n = 1.14), methyl acrylate, PMA-PIB-PMA (M_n = 31,810, M_w/M_n = 1.42), isobornyl acrylate, PIBA-PIB-PIBA (M_n = 33,500, M_w/M_n = 1.21), and methyl methacrylate, PMMA-PIB-PMMA (M_n = 33,500, M_w/M_n = 1.47). © 1997 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 35 : 3595–3601, 1997     

Efficient synthesis of monodisperse,highly crosslinked,and “living” functional polymer microspheres by the ambient temperature iniferter‐induced “living” radical precipitation polymerization

The facile and efficient one‐pot synthesis of monodisperse, highly crosslinked, and “living” functional copolymer microspheres by the ambient temperature iniferter‐induced “living” radical precipitation polymerization (ILRPP) is described for the first time. The simple introduction of iniferter‐induced “living” radical polymerization (ILRP) mechanism into precipitation polymerization system, together with the use of ethanol solvent, allows the direct generation of such uniform functional copolymer microspheres. The polymerization parameters (including monomer loading, iniferter concentration, molar ratio of crosslinker to monovinyl comonomer, and polymerization time and scale) showed much influence on the morphologies of the resulting copolymer microspheres, thus permitting the convenient tailoring of the particle sizes by easily tuning the reaction conditions. In particular, monodisperse poly(4‐vinylpyridine‐co‐ethylene glycol dimethacrylate) microspheres were prepared by the ambient temperature ILRPP even at a high monomer loading of 18 vol %. The general applicability of the ambient temperature ILRPP was confirmed by the preparation of uniform copolymer microspheres with incorporated glycidyl methacrylate. Moreover, the “livingness” of the resulting polymer microspheres was verified by their direct grafting of hydrophilic polymer brushes via surface‐initiated ILRP. Furthermore, a “grafting from” particle growth mechanism was proposed for ILRPP, which is considerably different from the “grafting to” particle growth mechanism in the traditional precipitation polymerization. © 2013 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2013     

Construction of Hetero‐Four‐Layered Tripalladium(II) Cyclophanes by Transannular π⋅⋅⋅π Interactions

A synthetic strategy for the generation of new molecular species utilizing a provision of nature is presented. Nano‐dimensional (23(2)×21(1)×16(1) ų) hetero‐four‐layered trimetallacyclophanes were constructed by proof‐of‐concept experiments that utilize a suitable combination of π???π interactions between the central aromatic rings, tailor‐made short/long spacer tridentate donors, and the combined helicity. The behavior of the unprecedented four‐layered metallacyclophane system offers a landmark in the development of new molecular systems.     

A Constrained Disorder Refinement: “Reinvestigation of “Single‐Crystal X‐ray Structure of 1,3‐Dimethylcyclobutadiene” by M. Shatruk and I. V. Alabugin”

Shatruk and Alabugin propose an alternative structural model for the observed electron density that we have attributed to the photochemical formation of 1,3‐dimethylcyclobutadiene in a protective solid crystalline matrix. The main criticism from Shatruk and Alabugin concerns the modeling of the disorder in the calixarene cavity and in particular the neglect of a residual electron density close to the O1 atom. We published (Chem. Eur. J. 2011 , 17, 10021) our opinion concerning this “ignored peak” in the Supporting Information of the paper. The current response to the Correspondence demonstrates that Shatruk and Alabugin have over‐modeled our data by assigning a small electron density peak, which is hardly more than the density corresponding to a hydrogen atom, to an under‐occupied oxygen site, using inappropriate refinement contraints.     

Synthesis of a Novel Oligoaniline: “Dumbbell‐Shaped” Oligoaniline

Summary: A new kind of aniline oligomer with a “dumbbell” shape was synthesized through a simple oxidative coupling reaction with a new rigid aromatic amine as starting material. The oligomer was characterized with mass spectrometry, IR and NMR spectroscopies. Its redox property was checked by cyclic voltammetry and chemical oxidation/reduction process was monitored by UV spectroscopy. We found it has a reversible electrochemical property like common oligoanilines. Combined with its well‐defined structure, it is expected to act as a model compound for a molecular electronic switch.

The “dumbbell‐shaped” oligoaniline compound synthesized here.     

CF3: An Electron‐Withdrawing Substituent for Aromatic Anion Acceptors? “Side‐On” versus “On‐Top” Binding of Halides

The ability of multiple CF₃‐substituted arenes to act as acceptors for anions is investigated. The results of quantum‐chemical calculations show that a high degree of trifluoromethyl substitution at the aromatic ring results in a positive quadrupole moment. However, depending on the polarizability of the anion and on the substitution at the arene, three different modes of interaction, namely Meisenheimer complex, side‐on hydrogen bonding, or anion–π interaction, can occur. Experimentally, the side‐on as well as a η²‐type π‐complex are observed in the crystal, whereas in solution only side‐on binding is found.