共查询到20条相似文献,搜索用时 78 毫秒
1.
加权残值法计算力学在我国十六年中的进展 国际近期进展概要及展望 总被引:1,自引:0,他引:1
本文综述了1978~1994年我国加权残值法作为固体力学,流体力学及工程应用的计算力学的主要进展,国际近期的进展概况,并提出展望及今后的研究工作。内容为:一、方法及分类;二:首届全国加权残值法(下称残值法)学术会议(1982年)及前后的主要进展;三、第二届全国残值法学术会议(1986年)及其后的主要进展;四、第三届全国残值法学术会议(1989年)及前后的主要进展;五、第四届全国残值法学术会议的主要进展(1994年~1995年);六、国际残值法进展概要;七、展望及今后的研究工作。 相似文献
2.
本文综述了1978-1994年我国加权残值法作为固体力学,流体力学及工程应用的计算力学的主要进展,国际近期的进展概况,并提出展望及今后的研究工作。内容为:一、方法及分类;二:首届全国加权残值法泞主会议及前后的主要进展;三、第二届全国残值法学术会议及其后的主要进展;四、第三届全国残值法学术会议及前后的主要进展;五、第四届全国残值不学术会议的主要进展;六、国际残值法进展概要;七、展望及今后的研究工作。 相似文献
3.
4.
第三届全国加权残值法学术会议将于1989年5月在四川峨眉西南交通大学召开。已收到论文一百多篇,经两次审稿会审阅,基本上已肯定110篇论文在大会上宣读交流,并收集进第三届全国加权残值法会议论文集,(预定在1989年四月由西南交大出版社正式出版)。上述110篇论文的内容丰富,涉及范围广泛,题材新颖,各有独创之处。它们对加权残值法的基础理论、误差和收敛性等问题的研究有了进一步深入;成功地将加权残值法用于固体及流体领域:如结构的非线性动力响应,板壳的 相似文献
5.
全国第三届加权残值法学术会议于1989年11月21日至25日在四川省峨眉县西南交通大学召开。这次会议由中国力学学会主办,西南交通大学岩土所及工程力学系协办。到会代表60人,第三届全国加权残值法论文集已正式出版,其中论文94篇,共607页,统一书号,公开出售。 相似文献
6.
7.
有效集法在数学规划加权残值法中的应用 总被引:2,自引:0,他引:2
本文研究有效集法在数学规划加权残值法求解微分方程问题中的应用。从理论上和实际应用方面 阐明,对于数学规划加权残值法和线性规划问题,有效集法比常用的单纯形法更简便、易程序化、计算速度更快,因此更适用于数学规划加权残值法求解微分方程问题。 相似文献
8.
9.
10.
卷积型加权残值法求解梁的动力学问题 总被引:5,自引:2,他引:3
利用卷积型加权残值法推导出Gurtin变分原理, 并应用卷积型加权残值法计算了简支梁的振动、冲击问题, 算例表明此方法是成功的. 相似文献
11.
Yan-Ming Cen 《Acta Mechanica Solida Sinica》1988,1(1):1-13
Based on the assumption that the yield criterionF(,)=0 is a differentiable surface in stress space and by starting from a specially defined real Euclidean space, the fundamental properties of the elasto-plastic matrix in the incremental theory of plasticity is discussed in detail. By using these results, a convex analysis is made to prove the existence and uniqueness of 1) the distribution of incremental elasto-plastic stress for work-hardening materrials; 2) the displacement distribution for work-hardening materials. Material isotropy is assumed in all discussions of relevant problems. 相似文献
12.
13.
采用垂直提拉法将单层双炔酸膜转移到云母基片上,同时将13层双炔酸膜转移到经过亲水处理的单晶硅片和石英片上,使双炔酸在紫外光照射下发生拓扑聚合制备双炔酸聚合LB膜,并对双炔酸和经紫外光照射后聚合双炔酸LB膜的结构及摩擦磨损特性进行研究.结果表明:双炔酸在可见区无吸收峰,但经紫外光照射后因双炔酸聚合后形成的共轭大π键在可见区出现了吸收峰;双炔酸LB膜均匀平整,厚度约为3.5 nm,聚合后其结构发生变化,厚度降至约1.5 nm;而聚合后双炔酸LB膜的减摩性能基本保持不变,聚合前后双炔酸LB膜的摩擦系数不随载荷而变化,符合阿芒顿定律,其抗磨特性得到明显提高;磨痕结果充分表明聚合双炔酸耐磨性能较好. 相似文献
14.
V. S. Nagornyi 《Journal of Applied Mechanics and Technical Physics》2000,41(2):225-230
The physical and mathematical principles of the method of electrogas-and electrohydrodynamic conversion of electrical signals
to pneumatic (hydraulic) signals and vice versa for control of gas and liquid jets and flows in electropneumohydraulic systems
are considered.
St. Petersburg State Technical University, St. Petersburg 195251. Translated from Prikladnaya Mekhanika i Tekhnicheskaya Fizika,
Vol. 41, No. 2, pp. 25–31, March–April, 2000. 相似文献
15.
科学的统一性与力学的范围地位和方向 总被引:3,自引:1,他引:2
综述科学的统一性和统一性所决定的科学发展的方向,并从科学统一性的观战简评力不的范围,它在科学上的地位,影响和今后发展的方向。. 相似文献
16.
The graphical method to determine with the aid of a Mollier i - x diagram (psychrometric chart) combined heat and mass transfer is simulated by a computer program. Heat rejection rates from a plate-fin tube type condenser are determined for various flow rates and inlet state conditions of air and for different degrees of wetting of the heat transfer surfaces. The presence of water and the cooling by latent heat makes it possible to exchange more heat than the unwetted exchanger would even for idealized conditions of infinite heat transfer coefficient of the air. The evaporative cooled condenser also can exchange heat with ambient air which has much higher temperature than the condensing fluid. Evaporative cooling increases heat transfer by a factor of more than three for saturated inlet air and greater than five for lower inlet humidities. Wetted heat exchangers require less extended surfaces and can operate effectively with bare tubes only. Wetting the condenser of a refrigeration or heat pump system makes it possible to exchange the condenser load at lower temperatures. This yields an increase of COP of the order of 30 to 60% and therefore a substantial decrease in compressor power and its energy consumption. 相似文献
17.
本文提出了一种新的弹性与弹塑性问题的对称耦合解法。根据分区广义变分原理,直接导出问题的求解方程式。通过典型算例,验证了该方法的有效性,本文建议的方法与超单元形式的耦合法相比,在理论上比较直接,在计算上更为经济。 相似文献
18.
IntroductionFatiguefractrueisaprimarymodeoffailureformetallicstructuresandmechanicalsystemssubjectedtovariousdynamicloads.Atthebeginningofservice,someinherentdefectssuchasmicrocracks,weldingdefects,notches,voidsetc.existinmanystructuresorelements.Thesed… 相似文献
19.
20.
Richard E. Whaley 《Experimental Mechanics》1962,2(11):329-334
This paper describes a method of presentation of fatigue data on three commonly used aircraft materials, 2024-T3 and 7075-T6 aluminum alloys and normalized SAE 4130 steel, such that variations in fatigue strength with stress-concentration factor can be shown. Comparisons of the fatigue strengths of 2024-T3 and 7075-T6 aluminum are made for the most useful range of stress-concentration factors. Static-strength results of notched and unnotched specimens of the three materials are presented to show how the strength varies with some parameters of the stress concentration. Comparison of the data with one theory for the strength of cracked specimens was made. 相似文献