Study on Square Wave Pulsewidth-variable Solid State Laser

Based on the rate equation of laser oscillation, we study the possibility of square wave output of a solid state laser in temporal domain. By means of the smooth cavity dumping, the reduction of output loss compensates the photon decrease in cavity. In experiment, we use two sets of avalanche transistor chains to control the functional voltage applied on the Pockels cell for getting uniform and pulsewidth-variable square wave laser pulse.     

基于类噪声方波脉冲的掺铒光纤激光器

搭建了长腔"8"字型掺铒光纤激光器,并对产生的谐波锁模方波脉冲进行了实验研究.结果表明,该脉冲具有光滑的宽带光谱,示波器上显示为方波脉冲,但自相关迹证实其为类噪声脉冲,即为类噪声方波脉冲;通过调节偏振控制器和泵浦功率等激光器腔内参量,获得了高达5阶的谐波锁模类噪声方波脉冲;该类噪声方波脉冲并非可以无限增大脉冲能量,而是在一定条件下产生脉冲分裂,出现谐波锁模方波脉冲现象.     

用行波速率方程组确定半导体激光器的输出场

为了解决在平均场近似速率方程中自洽地由激光器腔内平均场来确定输出场的问题,以半导体激光器为例,采用集总形式的端面反射率,通过求解行波速率方程组,得出了半导体激光器腔内平均光子数密度与输出光子数密度的解析关系式.结果表明,半导体激光器输出场与腔内平均场之比是一个与泵浦电流有关的量,把它当成常数是有偏见的.     

Generation and Modulation of Phase Difference of Output Intensities in a Feedback Nd:YAG Laser with an Extracavity Waveplate Rotated

External anisotropic feedback effects on the phase difference behaviour of output intensities in a microchip Nd：YAG laser are presented. By rotating a quarter wave plate placed in the external cavity, the angle between laser initial polarization direction and o-axis of the wave plate is tuned from -45°to 45°, which results in variable extra-cavity birefringence along two orthogonal detection directions. With only one optical path and one wave plate, laser intensities of the two orthogonal directions, both modulated by the external cavity length, are output with a tunable phase difference, which can be continuously changed from zero to twice as large as that of the waveplate. Experimental results as well as a theoretical analysis based on Fabry-Perot cavity equivalent model and the refractive index ellipsoid, are presented. The potential applications of this phenomenon are also discussed.     

Research and application of a pocket CO2 laser in the near field

The axisymmetrical structural traveling wave cavity (ASSC) CO₂ laser is introduced based on the propagation theory of the standing wave cavity CO₂ laser. Then the propagation characteristics of the elliptically polarized Gaussian beam are studied in detail. The transforms of the coordinate were used to solve the near field distributions of the output laser beams. The numerical calculations show that the combination of the output beams in the near field can be fulfilled. The diminutive ASSC CO₂ laser can be applied into the laser gyro and the measure of the angular velocity.     

全内腔可调谐CO2激光器

研制了一台用光栅选支,压电驱动改变腔长的连续CO₂调频激光器。采用全内腔结构,四电极放电。在腔长为2m、放电长度为1.5m的条件下,获得稳定激光输出。输出激光谱线80条以上,最强单线输出功率50 W,单线调谐宽度70 MHz。     

有横向分布为TEM10模的信号注入的环形腔激光器的双稳性

本文假设注入环形腔激光器的信号的横向场分布为TEM_(10)模.利用平均场近似方法得到了单横模共振时的定态方程,并进行了线性稳定性分析.结果表明,对优质腔来说,与Lugiato等讨论的注入信号为平面波光束及高斯光束(TEM_(00)模)的情况不同,注入光场横向分布具有TEM_(10)模的横式时,环形激光器的输出呈现双稳性.     

Output characteristics of right angle cone mirror cavity laser

The anti-misalignment stability and output characteristics of the right angle cone cavity laser are experimentally studied. When the misalignment angle of the cone mirror turns to 46.8 minutes, the single-pulse output energy of the plano-cone cavity laser decreases 24% and the near-field beam patterns have little change; as for the beam directional stability, when the measuring place stands 3.12 m in front of the output mirror, the near-field beam patterns of the plano-cone laser are located at the primary places until the misalignment angle of the cone mirror turns to 18 minutes. These results show that the plano-cone cavity laser has better performances in comparison with the plano-concave cavity laser. The analytical results of the mode instrument are also obtained, which show that the near-field beam intensity distribution of the plano-cone mirror cavity laser is near to the plane wave.     

Frequency doubled femtosecond Ti:sapphire laser with an assisted enhancement cavity

We report an enhancement cavity for femtosecond Ti:sapphire laser at the repetition rate of 170 MHz. An enhancement factor of 24 is obtained when the injecting pulses have an average power of 1 W and a pulse duration of 80 fs. By placing a BBO crystal at the focus of the cavity, we obtain a 392-m W intracavity doubled-frequency laser, corresponding to a conversion efficiency of 43%. The output power has a long-term stability with a root mean square(RMS) of 0.036%.     

半外腔微片Nd∶YAG正交偏振激光器及其在精密测角中的应用

设计了一种半外腔微片Nd∶YAG正交偏振双频激光器。把2个1/4波片置于激光谐振腔内,一个静止,一个作360°旋转,旋转引起2个1/4波片快轴之间的角度变化被激光器转化成激光2个频率之差的变化,从而输出可调谐的双频激光。采用琼斯矩阵对光在腔内的本征模进行分析,给出了双频频差的理论解释。讨论了一种体积小、分辨率高和可整周测量的新型Nd∶YAG激光测角仪的潜在前景。     

Controlling light by light with three-level atoms inside an optical cavity

We present our experimental demonstration of controlling the cavity output intensity of one laser beam with the intensity of another laser beam in a composite system consisting of a collection of three-level ?-type rubidium atoms and an optical ring cavity. When the intensity of the controlling beam is modulated with a square waveform, the cavity output power switches on and off (with a distinction ratio better than 20:1) between two steady-state values. This all-optical switching effect is the result of combined absorption and enhanced Kerr nonlinearity near resonance in such three-level atomic systems because of atomic coherence and can find applications in optical communication and optical computation.     

High-power continuous wave green beam generation by use of simple linear cavity with side-pumped module

High-power continuous wave green radiation has been generated by means of type-II phase-matched frequency doubling in a KTP crystal located in a simple linear cavity incorporating a diode side-pumped Nd:YAG laser module. The cavity was designed to make the fundamental beam radius at the KTP crystal smaller than that at the gain medium, as is required for obtaining large mode volume in Nd:YAG crystal and realizing efficient CW intracavity frequency doubling. Output power of 51.2 W is obtained in the experiment with a diode-to-green optical conversion efficiency of 10.3%. The M²-parameters of the laser are measured at different output powers. For the output power of about 47 W, the power fluctuation is measured less than 1%. The experimental results show that the continuous wave green laser system using this simple linear cavity offers good laser performance and output stability.     

Laser Intensity Variation in Amplitude and Phase Induced by Elliptically Polarized Feedback

The laser output characteristics under elliptically polarized optical feedback effect are studied. Elliptically polarized light is generated by wave plate placed in the feedback cavity. By analyzing the amplitude and phase of the laser output in the orthogonal direction, some new phenomena are firstly discovered and explained theoretically.Elliptically polarized feedback light is amplified in the gain medium in the resonator, and the direction perpendicular to the original polarization direction is easiest to oscillate. The laser intensity variation in amplitude and phase are related to the amplified mode and the anisotropy of external cavity. The theoretical analysis and experimental results agree well. Because the output characteristic of the laser has a relationship with the anisotropy of the external cavity, the phenomenon also provides a method for measuring birefringence.     

Single-walled carbon nanotubes on side polished fiber as a universal saturable absorber for various laser output states

We demonstrated four different laser operational states in the same passive fiber ring laser cavity by controlling solely the polarization state in a saturable absorber. The demonstrated laser operational states were continuous wave, mode-locking, Q-switching, and Q-switched mode-locking. The saturable absorber was fabricated by spin-coating a single-walled carbon nanotubes (SWCNT)/polymer composite on a side polished fiber providing enhanced nonlinear interaction with the SWCNT. The wide tuning range of the saturable absorber allows the simple means to generate different forms of laser output from a single laser cavity.     

环形腔中激光振荡输出的横向斑图及向光学湍流的转变

在研究环形腔中激光振荡输出的分岔与混沌的基础上,采用耦合映象格子模型研究了其空间扩展系统的横向效应.数值模拟表明,随着参数的改变,空间扩展系统由均匀稳态、行波解向时空混沌演化.在一定的参数条件下,空间扩展系统从光场取入射平面波(均匀分布)开始,经对称破缺向光学湍流转变. 关键词： 横向斑图 时空混沌 湍流 数值模拟     

Single-frequency laser oscillator with watts-level output power at 1.5 microm by use of a twisted-mode technique

We report an all-fiber laser oscillator producing as much as 1.9 W of single-frequency direct output at 1.5 microm. Spatial gain hole burning in the active fiber has been eliminated by use of a twisted-mode cavity approach. The two short pieces of a polarization-maintaining fiber that were spliced to the ends of the active fiber served as ultracompact quarter-wave plates. To our knowledge, the use of such a wave plate to manipulate the polarization state of light inside a fiber laser cavity is reported here for the first time. The laser output is linearly polarized and delivered through a polarization-maintaining fiber pigtail. We believe that the output power of our laser is the highest among all single-frequency fiber laser oscillators reported to date.     

Multi-wavelength Q-switched erbium doped fiber laser with a short carbon nanotube based saturable absorber

We demonstrate an all-fiber passively multi-wavelength Q-switched Erbium doped fiber laser (EDFL) based on a short Carbon Nanotube based saturable absorber. With the saturable absorber connected in a longer standing wave based fiber laser cavity, stable single, dual, and multiple wavelength Q-switched low threshold EDFL are achieved. Experimental results show that the output pulse of the filtered single wavelength has the same repetition rate as that of the multi-wavelength output while its average output power is lower than that of the multi-wavelength output.     

cw dual-wavelength operation of a diode-end-pumped Nd:YVO4 laser

A dual-wavelength continuous wave (cw) diode-end-pumped Nd:YVO₄ laser that generates simultaneous laser action at the wavelengths 1064 nm and 1342 nm is demonstrated. The optimum oscillation condition for the simultaneous dual-wavelength operation in a diode-end-pumped solid-state laser has been derived. The relationship between the laser cavity and the output stability is also studied. Experimental results show that the stability of the output power at the two wavelengths could be enhanced by use of a three-mirror cavity. Received: 26 August 1999 / Revised version: 11 October 1999 / Published online: 23 February 2000     

Temporal investigation of acoustic wave pressure spectrum of high repetition rate TEA-CO2 lasers by using a three-dimensional mathematical model

The production of acoustic wave is one of the most important factors on the action of High Repetition Rate TEA-CO₂ lasers. In this paper a three-dimensional mathematical modeling has been considered for investigation of temporal and spatial variations of acoustic waves in the laser cavity and its effect on the output of HRR lasers. By calculation of equations obtained from this model and plotting the pressure spectrum in different states, the effect of electrodes dimensions, cavity dimensions, gas flow velocity and repetition rate of laser in different times have been acquired. At last, optimum conditions for performance of laser action and having a good output have been arrived.     

半导体激光泵浦亚稳态氩气激光器实现激光振荡

采用基于体布拉格光栅的窄线宽半导体激光器作为泵浦源,以电容耦合式射频激励Ar, He混合气体放电等离子体为增益介质,在双程纵向泵浦的结构下实现了连续波模式的912 nm的激光输出。