“全同”超形变核转动带的量子群Uqp(u2)模型的理论分析

利用量子群U_qp(u₂)模型计算了^{191-192-193-194Hg}超形变(SD)带的γ跃迁能E_γ,运动学转动惯量J⁽¹⁾和动力学转动惯量J⁽²⁾,顺排角动量之差(i=ω(J⁽¹⁾(^{191-192-193-194}Hg)-J⁽¹⁾(¹⁹²Hg))),并与实验值进行比较得到了满意的结果,此外,还利用U_qp(u₂)模型的形变参量与核软度的关系式,计算出各SD带的核软度参数σ₁与唯象分析给出的组态结构进行了比较分析.     

125Ba高自旋态的测量

通过¹⁰⁹Ag(¹⁹F,3n)核反应布局了¹²⁵Ba核的激发态.使用带BGO康普顿抑制的高纯锗探测器阵列和常规在束γ实验技术,测量了它的高自旋态.建立在h_11/2中子支壳上的负宇称带和建立在g_7/2中子支壳上的正宇称带分别被延伸到了35/2^－和23/2⁺态.负宇称带显示出明显的正负Signature劈裂,而正宇称带则几乎没有这种劈裂.负宇称正负Signature带均出现反弯,其反弯处转动频率与¹²⁴Ba晕带反弯频率相近.正宇称带出开始出现反弯迹象.     

90Mo电磁跃迁几率的测量

利用束流能量为116MeV的⁵⁹Co(³⁵Cl,2p2n)⁹⁰Mo反应布居⁹⁰Mo的高自旋态.用10台反康普顿HPGe探测器组成的探测阵列进行γγ符合测量.通过多普勒展宽峰的形状分析测定⁹⁰Mo高自旋态的寿命.在正宇称衰变系观察到增强的M1跃迁,推断I=13以上是扁椭形变.负宇称高自旋态具有大的B(E2)值,并随自旋增大而起伏变化.正、负宇称态之间的跃迁显示增大的E1跃迁,似有八极关联的可能.但是,⁹⁰Mo并不处在理论预言的存在八极形变的核区内.     

三体势对含f玻色子的IBM1的O(6)极限能谱修正

在s–dIBM1的O(6)极限下,引入d玻色子之间相互作用的等效三体势,考虑f玻色子产生的八极态,导出了正负宇称态能谱解析表达式,并对过渡区偶偶核¹¹⁸Xe、¹²⁰Xe进行了能谱计算,得到了与实验能谱符合更好的结果,然后用Staggering指数定量分析了正负宇称态能谱中的Staggering现象.     

129Ce高自旋态的形状变化

通过¹¹⁶Sn(¹⁶O,3n)¹²⁹Ce反应,利用多普勒移动衰减法测量了¹²⁹Ce高自旋态的寿命.得到的跃迁四极矩表明¹²⁹Ce的集体性相对于核芯¹²⁸Ce减弱.这个因增加一个h_11/2中子而引起集体性的降低可以解释为由于形状驱动效应产生三轴形变所造成的.正、负宇称带的跃迁四极矩与角动量的关系呈现相似的变化趋势,推测一对h_11/2准质子可能对核芯性质起主要作用.     

偶偶Ge和Se同位素核的形变HF态及负宇称带研究

将具有负宇称的fp轨道空间扩大到包含具有正宇称的1g_9/2轨道,采用修正的表面δ相互作用,对⁶⁴Ge,⁶⁶Ge,⁶⁸Ge,⁷⁰Se,⁷²Se和⁷⁴Se等6个偶偶核做了形变HF计算.得到了基态和一些激发态的解.同时,还用近似角动量投影形变Hartree-Fock(PDHF)方法,对⁶⁴Ge和⁷⁴Se进行了能谱计算,得到其正、负宇称带的解,计算结果与实验谱基本一致.     

128—150Ce偶偶核的低能谱和电磁跃迁的相互作用玻色子模型

采用相互作用玻色子模型研究了^128—150Ce同位素核的低能正宇称态的能谱和电磁跃迁.应用简单的哈密顿量很好的描述它们的能谱和E2跃过.研究表明,这些偶偶Ce核是属于U(5)到SU(3)过渡核,而¹⁴⁶Ce以后的核基本是完全的转动核.     

变形核转动谱的Harris公式和吴-曾公式的比较

本文利用重离子库仑激发提供的锕系偶偶核基带高自旋态(直到I^π～30⁺)的丰富数据,检验了现行各转动谱公式.能谱、转动惯量和γ跃迁能量的分析表明,吴-曾公式优于其它两参数公式,包括广泛流行的Harris公式.在某些情况下,吴-曾公式还有助于判断数据的可靠程度.     

转动对电磁跃迁的影响

利用推广的粒子-转子模型研究了¹⁵⁹Tm负宇称Yrast态的能谱的Signature分离,B(M1)值以及动力学电四极矩Q^(1)和Q⁽²⁾,并同实验进行了比较,得到了较好的符合.着重分析了二级柯里奥利作用H_c对B(M1)值的Signature依赖性的影响,指出粒子-转子高级耦合项部分地等效于γ形变.     

北京谱仪上的J/ψ物理

利用BES上取得的9.0×10⁶ J/ψ数据,进行了系统的J/物理分析.证实了ξ(2230)的存在,并首次发现ξ(2230)的非奇异衰变模式.测量了f₀(980)、f₂(1270)的共振参数和极化.对J/ψ→K⁺K^－过程短分析的结果表明f_J(1710)是含有0⁺⁺和2⁺⁺两个态的宽结构.采用分波法测定了η(1440)、f₀(1500)的自旋宇称,得到它们的主要衰变模式.     

Guided-Wave Two-Dimensional Acousto-Optic Scanner Using Proton-Exchanged Lithium Niobate Waveguide

Two-dimensional scanning of a 0.6328 mum guided-light beam has been realized using noncolinear acousto-optic (AO) coplanar Bragg diffraction together with colinear AO guided-mode to substrate radiation-mode conversion in a Z-cut Xpropagation LiNbO3 proton-exchanged (PE) waveguide. The two surface acoustic (SAW) waves utilized are at the center frequencies of 500 and 200 MHz, propagating in the Y and X axes, respectively. Two-dimensional scanning of approximately 720 resolvable light beam spots, namely, 18 40 (horizontal vertical) scanning, has been demonstrated using a light beam of 1.0 mm aperture. The total number of resolvable beam spots can be greatly increased from 720 by simply utilizing SAW transducers of larger bandwidth and a light beam of greater aperture. It should also be possible to significantly increase the diffraction efficiency from 3 % by optimizing the parameters of the PE waveguide and the SAWs.     

Effect ofγ-radiation on the spectral luminescence characteristics of impure cadmium tungstate crystals

Results of a study of the effect of γ-radiation on the spectral luminescence properties of cadmium tungstate crystals doped with silver, bismuth, and molybdenum cations are presented. Spectral characteristics of the nondnnnoped crystals are briefly described. Absorption and photo and X-ray luminescence spectra of the crystals taken before and after exposure to γ-radiation (5.5·10⁴ Gy) are compared. It is found that the spectral characteristics of the crystals doped with silver, bismuth, and molybdenum cations do not change markedly after the exposure. The relation between the type of impurity-induced defects, individual characteristics of the impurity cations, and the character of the effect of γ-radiation on the spectral luminescence properties of impure crystals is analyzed (preliminarily). Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 1, pp. 55–60, January–February, 1997.     

Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Measurement of nonlinear coefficient of optical fiber based on small chirped soliton transmission

We measure the waveform and phase curves of short optical pulses before and after transmission over different lengths of fibers by use of the pulse analyzer with the frequency-resolved optical gating (FROG),and numerically simulate pulse evolution under the experimental conditions.The nonlinear coefficient of the fiber is given by comparing the experimental results with the numerical ones.Difference between the experiment and numerical simulation is analyzed.     

Resonance scattering of canonical elastic shells in absorbing fluid medium

Resonance scattering of elastic spherical shell and cylindrical shell while the surrounding fluid medium has absorption is studied. The normal mode solution derived using exact elastic theory and the separation of variables is still applicable. However, the scattering form function has to be modified for the absorbing medium, otherwise the unreasonable result would be obtained. The backscattering form function in the absorbing medium is redefined, and the form function of elastic spherical and cylindrical shell with vacuum or solid matter filled is calculated in various absorption conditions. The results show that the absorption of surrounding fluid leads to notable attenuation of the coincidence resonances in the mid-frequency, but it has a little influence on the low-frequency resonance scattering induced by the filler inside the shell.     

Single-beam self-referenced phase-sensitive surface plasmon resonance sensor with high detection resolution

A versatile and low-cost single-beam self-referenced phase-sensitive surface plasmon resonance(SPR)sensing system with ultra-high resolution performance is presented.The system exhibits a root-mean-square phase fluctuation of ±0.0028.over a period of 45 min.i.e.a resolution of±5.2×10-9 refractive index units.The enhanced performance has been achieved through the incorporation of three design elements:a true single-beam configuration enabling complete self-referencing so that only the phase change associated with SPR gets detected,a differential measurement scheme to eliminate spurious signals not related to the sensor response,and the elimination of retardation drifts by incorporating temperature stabilization in the liquid crystal phase modulato .Our design should bring the detection sensitivity of non-labeling SPR biosensing closer to that achievable by conventional fluorescence-based techniques.     

Influences of SiO2 protective layers and annealing on the laser-induced damage threshold of Ta2O5 films

Ta2O5 films are prepared on BK7 substrates with conventional electron beam evaporation deposition.The effects of SiO2 protective layers and annealing on the laser-induced damage threshold (LIDT) of the films are investigated.The results show that SiO2 protective layers exert little influence on the electric field intensity(EFI)distribution,microstructure and microdefect density but increase the absorption slightly.Annealing iS effective on decreasing the microdefect density and the absorption of the films.Both SiO2 protective layers and annealing are beneficial to the damage resistance of the films and the latter is more effective to improve the LIDT.Moreover,the maximal LIDT of Ta2O5 films is achieved by the combination of SiO2 protective layers and annealing.     

A stereo matching algorithm using multi-peak candidate matches and geometric constraints

Gray cross correlation matching technique is adopted to extract candidate matches with gray cross correla- tion coefficients less than some certain range of maximal correlation coefficient called multi-peak candidate matches. Multi-peak candidates are extracted corresponding to three closest feature points at first. The corresponding multi-peak candidate matches are used to construct the model polygon. Correspondence is determined based on the local geometric relations between the three feature points and the multi-peak candidates. The disparity test and the global consistency checkout are applied to eliminate the remaining ambiguous matches that are not removed by the local geometric relational test. Experimental results show that the proposed algorithm is feasible and accurate.